Marcelo F. Castoldi
Marcelo F. Castoldi has a total of 3 co-authors. Here are the top co-authors by number of shared publications:
- Manoel Luis Aguiar
School of Engineering of So Carlos, University of So Paulo, So Carlos, Brazil
2 shared publications - Azauri A. Oliveira
University of Sao Paulo, Sao Carlos, SP, Brazil
1 shared publication - Jose R. B. A. Monteiro
University of Sao Paulo, Sao Carlos, SP, Brazil
1 shared publication
Latest Publications
- 1 July 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 3 (21635137) , 2248-2253
Simulation of DTC Strategy in VHDL Code for Induction Motor Control
This paper presents a simulation of direct torque control (DTC) strategy, used to control induction motors. This simulation was realized with Matlab and Modelsim programs. The Matlab/Simulink was used to simulate the motor dynamics and the inverter of the control system. The DTC strategy was executed in Modelsim using VHDL floating point
- 1 July 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 3 (21635137) , 2248-2253
Simulation of DTC Strategy in VHDL Code for Induction Motor Control
This paper presents a simulation of direct torque control (DTC) strategy, used to control induction motors. This simulation was realized with Matlab and Modelsim programs. The Matlab/Simulink was used to simulate the motor dynamics and the inverter of the control system. The DTC strategy was executed in Modelsim using VHDL floating point
- 1 January 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 955-960
A Rapid Prototype Design to Investigate the FPGA-Based DTC Strategy Applied to the Speed Control of Induction Motors
This work presents a virtual prototype for study and simulation of DTC technique applied to the speedy control of induction motor. The implementation is supposed to be realized in a FPGA device. The simulation was conducted using the Matlab/Simulink and the ModelSim programs. While the inverter/motor dynamics is executed in the Matlab, the ModelSim perform the speed control and the DTC procedure witch is written in VHDL-code. The both programs work in co-simulation mode provided by the Link-for-ModelSim toolbox in the Simulink. This virtual prototype was tested with the implementation of the DTC strategy using float point representation.
- 1 January 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 955-960
A Rapid Prototype Design to Investigate the FPGA-Based DTC Strategy Applied to the Speed Control of Induction Motors
This work presents a virtual prototype for study and simulation of DTC technique applied to the speedy control of induction motor. The implementation is supposed to be realized in a FPGA device. The simulation was conducted using the Matlab/Simulink and the ModelSim programs. While the inverter/motor dynamics is executed in the Matlab, the ModelSim perform the speed control and the DTC procedure witch is written in VHDL-code. The both programs work in co-simulation mode provided by the Link-for-ModelSim toolbox in the Simulink. This virtual prototype was tested with the implementation of the DTC strategy using float point representation.