Ana P. Arcanjo
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Ana P. Arcanjo has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Aline Machado de Castro
Biotechnology Division, Research and Development Center, PETROBRAS, Rio de Janeiro, Brazil
1 shared publication - Bernardo Dias Ribeiro
Federal University of Rio de Janeiro
1 shared publication - Celmy Maria Bezerra Menezes Barbosa
Department of Chemical Engineering, Federal University of Pernambuco, Recife, PE, Brazil CEP
1 shared publication - Denisson De Oliveira Libório
Universidade Federal de Sergipe
1 shared publication - Florival R. Carvalho
Fuel Laboratory, Institute for Petroleum and Energy Research (LITPEG), Department of Chemical Engineering, Center of Technology and Geosciences, Federal University of Pernambuco, Recife 50740-540, PE, Brazil
1 shared publication - Jose Geraldo Andrade Pacheco
Federal University of Pernambuco
1 shared publication
Latest Publications
- Open Access
Chemical Recycling of PET Using Catalysts from Layered Double Hydroxides: Effect of Synthesis Method and Mg-Fe Biocompatible Metals
The chemical recycling of poly(ethylene terephthalate) (PET) residues was performed via glycolysis with ethylene glycol (EG) over Mg-Fe and Mg-Al oxide catalysts derived from layered double hydroxides. Catalysts prepared using the high supersaturation method (h.s.c.) presented a higher surface area and larger particles, but this represented less PET conversion than those prepared by the low supersaturation method (l.s.c.). This difference was attributed to the smaller mass transfer limitations inside the (l.s.c.) catalysts. An artificial neural network model well fitted the PET conversion and bis(2-hydroxyethyl) terephthalate (BHET) yield. The influence of Fe in place of Al resulted in a higher PET conversion of the Mg-Fe-h.s.c. catalyst (~95.8%) than of Mg-Al-h.s.c. (~63%). Mg-Fe catalysts could be reused four to five times with final conversions of up to 97% with reaction conditions of EG: PET = 5:1 and catalyst: PET = 0.5%. These results confirm the Mg-Fe oxides as a biocompatible novel catalyst for the chemical recycling of PET residues to obtain non-toxic BHET for further polymerization, and use in food and beverage packaging.
Open AccessChemical Recycling of PET Using Catalysts from Layered Double Hydroxides: Effect of Synthesis Method and Mg-Fe Biocompatible Metals
The chemical recycling of poly(ethylene terephthalate) (PET) residues was performed via glycolysis with ethylene glycol (EG) over Mg-Fe and Mg-Al oxide catalysts derived from layered double hydroxides. Catalysts prepared using the high supersaturation method (h.s.c.) presented a higher surface area and larger particles, but this represented less PET conversion than those prepared by the low supersaturation method (l.s.c.). This difference was attributed to the smaller mass transfer limitations inside the (l.s.c.) catalysts. An artificial neural network model well fitted the PET conversion and bis(2-hydroxyethyl) terephthalate (BHET) yield. The influence of Fe in place of Al resulted in a higher PET conversion of the Mg-Fe-h.s.c. catalyst (~95.8%) than of Mg-Al-h.s.c. (~63%). Mg-Fe catalysts could be reused four to five times with final conversions of up to 97% with reaction conditions of EG: PET = 5:1 and catalyst: PET = 0.5%. These results confirm the Mg-Fe oxides as a biocompatible novel catalyst for the chemical recycling of PET residues to obtain non-toxic BHET for further polymerization, and use in food and beverage packaging.