XDXiaoming Ding

Xiaoming Ding

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Xiaoming Ding has a total of 5 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Sol-Gel Derived Tungsten Doped VO2 Thin Films on Si Substrate with Tunable Phase Transition Properties

    by Xiaoming Ding, Yanli Li, Yubo Zhang

    Vanadium dioxide (VO2) with semiconductor-metal phase transition characteristics has presented great application potential in various optoelectrical smart devices. However, the preparation of doped VO2 film with a lower phase transition threshold on Si substrate needs more investigation for the exploration of silicon-based VO2 devices. In this work, the VO2 films doped with different contents of W element were fabricated on high-purity Si substrate, assisted with a post-annealing process. The films exhibited good crystallinity and uniform thickness. The X-ray diffraction and X-ray photoelectron spectroscopy characterizations illustrated that W element can be doped into the lattice of VO2 and lead to small lattice distortion. In turn, the in situ FT-IR measurements indicated that the phase transition temperature of the VO2 films can be decreased continuously with W doping content. Simultaneously, the doping would lead to largely enhanced conductivity in the film, which results in reduced optical transmittance. This work provides significant insights into the design of doped VO2 films for silicon-based devices.


  • Open Access

    Research on Three-Roll Screw Rolling Process for Ti6Al4V Titanium Alloy Bar

    by Xiaoming Ding, Liyuan Sun, Xu Huang, Zhiwei Zhao

    The effects of both the microstructure and the original grain size on three-roll screw rolling process of Ti6Al4V titanium alloy bar were studied in the present work. The microstructure of Ti6Al4V titanium bar had a great influence on the mechanical properties of the rolling bar. When the original size was large, the grains were apparently refined but the microstructure was uneven. But for semi-finished titanium bar composed of fine equiaxed grains, the grains after rolling were fine and uniform. During the rolling process, the Ti6Al4V titanium alloy microstructure changed from equiaxed structure to the basket-weave one. After annealing at 800℃ for 1.5 hours and then cooling in air, the average tensile strength decreased from 984 MPa to 964 MPa; while after annealing at 950℃ for 1.5 hours and then cooling by water, and aging at 540℃ for 6 hours then cooling by air, the average tensile strength increased from 979 MPa to 1107 MPa.