FZFuxiang Zhang

Fuxiang Zhang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Fuxiang Zhang has a total of 9 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Calibration of Snow Particle Contact Parameters for Simulation Analysis of Membrane Structure Snow Removal Robot

    by Jiangtao Dong, Fuxiang Zhang, Fengshan Huang, Xiaofei Man

    To enhance the accuracy of discrete element method (DEM) simulation for the snow removal process performed by autonomous robots on membrane structures, this study calibrated the key contact parameters of snow particles used in the simulation. Through literature research, the intrinsic parameters and contact parameter ranges for snow particles and membrane structures were determined. A discrete element model of snow particles was established, and the Hertz–Mindlin with Johnson–Kendall–Robert contact model was selected to simulate the formation process of the repose angle. Using the actual repose angle of snow particles as the target, four significant factors were identified through the P-B experiment, and other factors were set at the intermediate level. Through the steepest slope climbing experiment and response surface design, second-order response equations of the four significant factors were obtained. The optimal parameter combination was calculated as follows: the surface energy of snow particles was 0.23 J/m2; the restitution coefficient, static friction coefficient, and rolling friction coefficient of snow–snow were 0.141, 0.05, and 0.03; and the restitution coefficient, static friction coefficient, and rolling friction coefficient of snow–membrane were 0.2, 0.18, and 0.03. The simulated repose angle was 40.62°, and the relative error with the actual repose angle was 0.32%. These calibration results are reliable and can provide a reliable simulation basis and essential data support for the optimal design of a snow removal robot and the dynamic simulation of the operation process.


  • Open Access

    End Face Positioning Method for Bundled Bars by Using Point Cloud Partition Statistics

    by Fuxiang Zhang, Hesheng Sun, Yongjian Huang, Fengshan Huang

    Aiming at the difficulty and low efficiency of end face center position measurement in the end face labeling process of bundled bars, a method of end face positioning of bundled bars based on point cloud partitioning statistics is proposed. Firstly, the end face point cloud is pre-processed; then the end face point cloud is segmented using an improved clustering segmentation algorithm, and a method for locating the endface centre of complete single bar and a method for locating the endface centre of defective single bar based on the zoning statistics are proposed to achieve end face center localization; finally, the end face normal vector is used instead of the endface center pose for end face center pose reconstruction. 200 single bar end face point clouds with different pose were collected for the experiment, the time to locate a single bar endface was less than 0.5 s, the position error was less than 3 mm, and the posture error was within 2°. The results show that the proposed method is efficient and can accurately locate the bar endface centre.