Baochun Tao

To enhance the erosion efficiency in traditional abrasive water jet processing, an abrasive water jet processing method based on self-excited fluid oscillation is proposed. Traditional abrasive water jet methods suffer from reduced jet kinetic energy due to the presence of a stagnation layer, which hinders efficient material removal. By integrating a self-oscillation chamber into the conventional abrasive water jet nozzle, the continuous jet is transformed into a pulsed jet, thereby increasing the jet velocity and enhancing the kinetic energy of the process. This modification aims to improve material removal efficiency. Using Ansys Fluent, we simulated the material removal efficiency on workpiece surfaces with varying lengths of self-oscillation chambers. The simulation results reveal that the optimal length of the self-oscillation chamber for maximum erosion is 4 mm. SiC materials were used to evaluate the impact of self-oscillation chamber length (L), jet pressure (P), abrasive flow rate (M), and abrasive grain size (D) on erosion. Experimental results show that the self-oscillation chamber increases erosion depth by 33 μm. The maximum erosion depths recorded were 167 μm when L = 4 mm, 223 μm when P = 16 MPa, 193 μm when M = 80 g/min, and 268 μm when D = 2000 μm. Overall, the self-excited oscillation effect enhances the erosion efficiency of the waterjet by 14%. This study further elucidates the factors influencing erosion behaviors in oscillating abrasive water jet processing.

A self-excited oscillating pulsed abrasive water jet polishing method is proposed to solve the problems of low removal efficiency in traditional abrasive water jet polishing and the influence of an external flow field on the material surface removal rate. The self-excited oscillating chamber of the nozzle was used to generate pulsed water jets to reduce the impact of the jet stagnation zone on material surface removal and increase the jet speed to improve processing efficiency. ANSYS Fluent was employed to simulate the processing flow field characteristics for different lengths of oscillation cavities. The simulation results indicate that the velocity of the jet shaft reached a maximum of 178.26 m/s when the length of the oscillation cavity was 4 mm. The erosion rate of the material is linear with the processing angle. A nozzle with a length of 4 mm of the self-excited oscillating cavity was fabricated for SiC surface polishing experiments. The results were compared with those of ordinary abrasive water jet polishing. The experimental results showed that the self-excited oscillation pulse fluid enhanced the erosion ability of the abrasive water jet on the SiC surface and significantly improved the material-removal depth of the abrasive water jet polishing SiC. The maximum surface erosion depth can be increased by 26 μm.