Shanshan Lou
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Shanshan Lou has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
- Yuchun Chang
Dalian University of Technology
3 shared publications Guoqiang Zhong
School of Integrated Circuits, Dalian University of Technology, Dalian, China
2 shared publications- Yang Qu
School of Integrated Circuits, Dalian University of Technology, Dalian, China
2 shared publications - Yu Cheng
School of Integrated Circuits, Dalian University of Technology, Dalian 116000, China
2 shared publications - Botao Xiong
School of Integrated Circuits, Dalian University of Technology, Dalian, China
1 shared publication - Hongwei Liang
Dalian University of Technology
1 shared publication
Latest Publications
- 3 September 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 71 (10) , 6178-6184
Noise Improvement and High Dynamic Range in a CMOS Image Sensor With Shift Biasing Structure
In this article, a noise improvement and dynamic range (DR) enhanced CMOS image sensor (CIS), using a shift biasing structure, is proposed. The shift biasing pixel is constructed from a conventional 4T pixel and three additional transistors, including a bias transistor (BT) and two switch transistors. The BT works as a switch to connect the source and drain to accumulate electrons in the source follower (SF) in shift biasing mode and provides an extra capacitance to enlarge the capacity of floating diffusion (FD) in low gain (LG) mode. Electron distribution and noise performance of SF are simulated to prove the function of shift biasing pixels. A prototype sensor, with a 512 $\times$ 128-pixel array, is fabricated with a 180 nm CIS process. Measurement shows a temporal noise of 2 e $^{{-}}$ is achieved, which is a 2 e $^{{-}}$ noise improvement compared with the reference 4T readout mode of shift biasing pixel. Additionally, an over 92 dB DR is realized by combining shift biasing mode and LG mode without any specific process or complex control circuits.
- 3 September 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 71 (10) , 6178-6184
Noise Improvement and High Dynamic Range in a CMOS Image Sensor With Shift Biasing Structure
In this article, a noise improvement and dynamic range (DR) enhanced CMOS image sensor (CIS), using a shift biasing structure, is proposed. The shift biasing pixel is constructed from a conventional 4T pixel and three additional transistors, including a bias transistor (BT) and two switch transistors. The BT works as a switch to connect the source and drain to accumulate electrons in the source follower (SF) in shift biasing mode and provides an extra capacitance to enlarge the capacity of floating diffusion (FD) in low gain (LG) mode. Electron distribution and noise performance of SF are simulated to prove the function of shift biasing pixels. A prototype sensor, with a 512 $\times$ 128-pixel array, is fabricated with a 180 nm CIS process. Measurement shows a temporal noise of 2 e $^{{-}}$ is achieved, which is a 2 e $^{{-}}$ noise improvement compared with the reference 4T readout mode of shift biasing pixel. Additionally, an over 92 dB DR is realized by combining shift biasing mode and LG mode without any specific process or complex control circuits.
- 10 August 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 70 (9) , 4719-4724
An Over 140 dB Dynamic Range CMOS Image Sensor Combined DCG and Logarithmic Response
A dynamic range enhancement pixel architecture based on a standard CMOS image sensor (CIS) process with a pinned photodiode (PPD) is proposed, combining dual conversion gain (DCG) and logarithmic response. Due to a unique charge compensation mechanism of the proposed pixel, in a single exposure, three images are captured with the same integration time, related to different incident light levels. As a result, an over 140 dB dynamic range image is able to be obtained by merging these images. Photo response measurements show the image sensor exhibits over 92 dB linear dynamic range and more than 51 dB logarithmic dynamic range, without signal-to-noise ratio (SNR) performance degradation under low light conditions.
- 10 August 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 70 (9) , 4719-4724
An Over 140 dB Dynamic Range CMOS Image Sensor Combined DCG and Logarithmic Response
A dynamic range enhancement pixel architecture based on a standard CMOS image sensor (CIS) process with a pinned photodiode (PPD) is proposed, combining dual conversion gain (DCG) and logarithmic response. Due to a unique charge compensation mechanism of the proposed pixel, in a single exposure, three images are captured with the same integration time, related to different incident light levels. As a result, an over 140 dB dynamic range image is able to be obtained by merging these images. Photo response measurements show the image sensor exhibits over 92 dB linear dynamic range and more than 51 dB logarithmic dynamic range, without signal-to-noise ratio (SNR) performance degradation under low light conditions.
- Open Access
- 1 September 2022
- Published by MDPI AG in Electronics
- Vol. 11 (17) , 2753
An Investigation into the Comprehensive Impact of Self-Heating and Hot Carrier Injection
As the device feature size shrinks, the dissipation of power increases and further raises the carrier and lattice temperature, which finally affects device performance. In this paper, we analyze the comprehensive influence of the self-heating effect and hot carrier injection (HCI) using TCAD simulations. Based on the hydrodynamic and thermodynamic models, it is demonstrated that the thermal surface resistance had a positive impact on the carrier and lattice temperature and that the drain saturation current is reduced dramatically due to the self-heating effect. Moreover, the impact of HCI on device performance is discussed. Finally, it is concluded that the self-heating effect exacerbates the influence of HCI on device characteristics.
- 1 September 2022
- Published by MDPI AG in Electronics
- Vol. 11 (17) , 2753
Open AccessAn Investigation into the Comprehensive Impact of Self-Heating and Hot Carrier Injection
As the device feature size shrinks, the dissipation of power increases and further raises the carrier and lattice temperature, which finally affects device performance. In this paper, we analyze the comprehensive influence of the self-heating effect and hot carrier injection (HCI) using TCAD simulations. Based on the hydrodynamic and thermodynamic models, it is demonstrated that the thermal surface resistance had a positive impact on the carrier and lattice temperature and that the drain saturation current is reduced dramatically due to the self-heating effect. Moreover, the impact of HCI on device performance is discussed. Finally, it is concluded that the self-heating effect exacerbates the influence of HCI on device characteristics.