Nathaniel G. Sauer
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Nathaniel G. Sauer has a total of 24 co-authors. Here are the top co-authors by number of shared publications:
- Adam Barowy
Fire Safety Research Institute, UL Research Institutes, Columbia, USA
3 shared publications Ali S. Rangwala
Department of Fire Protection Engineering, Worcester Polytechnic Institute, Worcester, USA
3 shared publications- Ali. S. Rangwala
Worcester Polytechnic Institute
2 shared publications - Matthew J. DiDomizio
Fire Safety Research Institute, UL Research Institutes, Columbia, USA
2 shared publications - Parham Dehghani
UL Research Institutes, Fire Safety Research Institute, 6200 Old Dobbin Lane, Suite 150, Columbia, MD 21045, United States
2 shared publications - Benjamin Gaudet
UL Solutions, Northbrook, IL (United States)
1 shared publication
Latest Publications
- Open Access
- 11 March 2026
- Published by Elsevier in Fire Safety Journal
- Vol. 162
Probabilistic design fire scenarios for performance-based design involving passenger vehicles
- 11 March 2026
- Published by Elsevier in Fire Safety Journal
- Vol. 162
Open AccessProbabilistic design fire scenarios for performance-based design involving passenger vehicles
- Open Access
- 16 January 2026
- Published by Elsevier in Data in Brief
- Vol. 65, 112471
Measurement data from full-scale fire experiments of battery electric vehicles and internal combustion engine vehicles
- 16 January 2026
- Published by Elsevier in Data in Brief
- Vol. 65, 112471
Open AccessMeasurement data from full-scale fire experiments of battery electric vehicles and internal combustion engine vehicles
- Open Access
- 13 September 2025
- Published by Elsevier in Fire Safety Journal
- Vol. 158
Heat exposure from electric vehicle fires: Experimental results and analysis
- 13 September 2025
- Published by Elsevier in Fire Safety Journal
- Vol. 158
Open AccessHeat exposure from electric vehicle fires: Experimental results and analysis
- Open Access
Experimental investigation of explosion hazard from lithium-ion battery thermal runaway effluent gas
- 28 September 2023
- Published by Springer Nature in Fire Technology
- Vol. 60 (1) , 71-99
Burning Behavior of Liquid Fuel on Wavy Water
- 28 September 2023
- Published by Springer Nature in Fire Technology
- Vol. 60 (1) , 71-99
Burning Behavior of Liquid Fuel on Wavy Water
- 11 August 2023
- Published by Elsevier in Fire Safety Journal
- Vol. 140
Burning capability of the flame refluxer under the influence of waves
- 11 August 2023
- Published by Elsevier in Fire Safety Journal
- Vol. 140
Burning capability of the flame refluxer under the influence of waves
- 1 January 2023
- Published by Bureau of Safety and Environmental Enforcement
Development of a Floating Flame Refluxer (FR) System
- 1 January 2023
- Published by Bureau of Safety and Environmental Enforcement
Development of a Floating Flame Refluxer (FR) System
- 21 July 2022
- Published by Elsevier in Marine Pollution Bulletin
- Vol. 182, 113932
A study of thin fuel slick combustion on wavy water
- 21 July 2022
- Published by Elsevier in Marine Pollution Bulletin
- Vol. 182, 113932
A study of thin fuel slick combustion on wavy water
- Open Access
- 1 May 2021
- Published by International Oil Spill Conference in International Oil Spill Conference Proceedings
- Vol. 2021 (1)
Controlling mechanisms of burning rate enhancement while using Flame Refluxer technology during in situ burning of crude oil spills
The focus of this study is to quantify the controlling mechanisms, which increases the burning rate of a pool fire using a Flame RefluxerTM. Part of the Flame RefluxerTM, is exposed to the fire and is heated up transferring heat to the fuel pool layer to which it extends. This enhances the conventional heat transfer that occurs only through the pool surface by transferring the heat from a fire to an in-depth layer of the liquid. Both sensible heat and heat of vaporization are supplied at increased rates by the submerged material. As an additional important effect, nucleate boiling onsets at the surface of the inserted material that generates bubbles of fuel vapor. These bubbles are transported to the surface of the pool, where they burst and release the v0061por to the gas-phase. While doing so, additional processes such as formation of micron-sized droplets or small jets of liquid fuel from the break point occur. This phenomenon causes additional fuel in liquid phase transported to the gas-phase, where they vaporize, ignite and burn in heterogeneous mode. Therefore, the processes involved in FR occur in three steps; enhancement of heat transfer to the liquid causing nucleate boiling, formation of bubbles and their transport, and dynamics of bubble breakage at the pool surface causing transfer of liquid fuel in the form of tiny droplets or jets towards the gas-phase. This study analyzes the influence of bubbles on the burning behavior of a pool fire using a simple experiment involving burning ethanol as a fuel. Ethanol is used due to its transparency and hence bubble behavior is easily observable on the heater surface. A 5cm x 5cm glass enclosure constantly replenished with ethanol serves as the burning pool. A solid aluminum block (8.8 cm tall x 3.6 cm wide x 1.2 cm thick) is placed in the flame to act as the Flame RefluxerTM. Bubble counts and burning rate measurements indicate the influence of the bubbles on the overall burning rate of the liquid pool.
- 1 May 2021
- Published by International Oil Spill Conference in International Oil Spill Conference Proceedings
- Vol. 2021 (1)
Open AccessControlling mechanisms of burning rate enhancement while using Flame Refluxer technology during in situ burning of crude oil spills
The focus of this study is to quantify the controlling mechanisms, which increases the burning rate of a pool fire using a Flame RefluxerTM. Part of the Flame RefluxerTM, is exposed to the fire and is heated up transferring heat to the fuel pool layer to which it extends. This enhances the conventional heat transfer that occurs only through the pool surface by transferring the heat from a fire to an in-depth layer of the liquid. Both sensible heat and heat of vaporization are supplied at increased rates by the submerged material. As an additional important effect, nucleate boiling onsets at the surface of the inserted material that generates bubbles of fuel vapor. These bubbles are transported to the surface of the pool, where they burst and release the v0061por to the gas-phase. While doing so, additional processes such as formation of micron-sized droplets or small jets of liquid fuel from the break point occur. This phenomenon causes additional fuel in liquid phase transported to the gas-phase, where they vaporize, ignite and burn in heterogeneous mode. Therefore, the processes involved in FR occur in three steps; enhancement of heat transfer to the liquid causing nucleate boiling, formation of bubbles and their transport, and dynamics of bubble breakage at the pool surface causing transfer of liquid fuel in the form of tiny droplets or jets towards the gas-phase. This study analyzes the influence of bubbles on the burning behavior of a pool fire using a simple experiment involving burning ethanol as a fuel. Ethanol is used due to its transparency and hence bubble behavior is easily observable on the heater surface. A 5cm x 5cm glass enclosure constantly replenished with ethanol serves as the burning pool. A solid aluminum block (8.8 cm tall x 3.6 cm wide x 1.2 cm thick) is placed in the flame to act as the Flame RefluxerTM. Bubble counts and burning rate measurements indicate the influence of the bubbles on the overall burning rate of the liquid pool.