XWXiaoyong Wang

Xiaoyong Wang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Xiaoyong Wang has a total of 72 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Effects of vibration–vibration–translation reactions in vibrational state-specific modeling of high-enthalpy nitrogen flow over a sphere

    by Xiaoyong Wang, Qiming Zhang, Ming Che, Jiale Zhu, Jinghui Guo

    The large number of transitions involved in vibration–vibration–translation (VVT) transitions during molecule–molecule collisions in the state-to-state (StS) simulation significantly increases computational cost and limits the multidimensional application. Two methods, multiquantum restrictions and simplifying VVT transitions to vibration–translation (VTm) transitions, are proposed to reduce computational consumption. This study is a continuation of a previous work [Guo et al., “Investigation of high enthalpy thermochemical nonequilibrium flow over spheres,” Phys. Fluids 36, 016122 (2024)]. It aims to systematically analyze the effects of VVT and VTm transitions on the flowfield characteristics and heat flux distributions of high-enthalpy nitrogen flow over a sphere. The numerical results show that the StS VVT and VTm transitions predict nearly identical shock standoff distances and stagnation-point heat fluxes, which agree with experimental data. Incorporating VVT transitions yields minimal differences in the predictions of translational temperature, vibrational temperature, and N mass fraction compared to VTm processes. Near the wall, the VVT and VTm transitions yield almost identical state populations, with gradually pronounced non-Boltzmann distributions. Therefore, the VVT transitions can be effectively reduced to VTm transitions while maintaining essential accuracy for predicting aerodynamic heating.

  • Chemiluminescence and oxygen molecular radiation in hypersonic carbon dioxide expanding flow

    by Yixin Xu, Senhao Zhang, Chunsheng Nie, Xingquan Gu, Shizhong Zhang, Xiaoyong Wang, Xin Lin, Qiu Wang, Jinping Li, Fei Li

    This study investigates the radiative properties of hypersonic carbon dioxide (CO2) expanding flows. Spatially resolved spectral measurements for the expansion region of a two-dimensional model were conducted in the JF14 shock tunnel. Experiments were performed in a shock tube mode, where the shock wave with velocities ranging from 3.37 to 3.88 km/s directly propagates to the test section, forming a stable flow field around the model. Results showed that the radiation emission within the 250–710 nm range is primarily dominated by CO2 chemiluminescence and Schumann–Runge bands of molecular oxygen (O2). The intensity of the Schumann–Runge spectrum was found to be significantly higher than the O2 thermal radiation calculated under the two-temperature (2-T) model, indicating that the O2 excited state (O2(3B)) was overpopulated relative to the Boltzmann distribution in the expansion region. In regions with lower degrees of expansion, the CO2 chemiluminescence intensity was overestimated by about 3 to 6 times, which may be attributed to an overprediction of the atomic oxygen (O) and carbon monoxide (CO) number densities in the current thermochemical model. As the degree of expansion intensified, the CO2 chemiluminescence intensity gradually exceeded the predicted values, suggesting that the expansion process can accelerate the recombination of O and CO, leading to stronger CO2 chemiluminescence. This work enhances the understanding of radiative processes in hypersonic CO2 expanding flow and provides benchmarks for the development of thermochemical and radiative models.


  • Coarse-grained modeling of high-enthalpy air flows based on the updated vibrational state-to-state kinetics

    by Yifeng Huang, Qizhen Hong, Sangdi Gu, Xiaoyong Wang, Quanhua Sun

    The state-to-state (StS) model can accurately describe high-temperature thermochemical nonequilibrium flows. For the five-species air gas mixture, we develop a comprehensive database for the state-specific rate coefficients for temperatures 300–25 000 K in this paper. The database incorporates recent molecular dynamics simulations (based on the ab initio potential energy surfaces) in the literature, and theoretical methods, including the forced harmonic oscillator model and the Marrone–Treanor model, are employed to complement the rate coefficients that are unavailable from molecular dynamics calculations. The post-shock StS simulations using the present database agree with the experimental NO infrared radiation. Based on this updated StS kinetics database, we investigate the post-shock high-enthalpy air flows by employing both the StS and coarse-grained models (CGM). The CGM, which lumps molecular vibrational states into groups, shows results that align with the StS model, even utilizing only two groups for each molecule. However, the CGM-1G model, with only one group per molecule and belonging to the multi-temperature model (but uses StS kinetics), fails to reproduce the StS results. Analysis of vibrational energy source terms for different kinetic processes and fractions of vibrational groups reveals that the deficiency of the CGM-1G model stems from the overestimation of high-lying vibrational states, leading to higher dissociation rates and increased consumption of vibrational energy in dissociation. Furthermore, the presence of the Zeldovich-exchange processes indirectly facilitates energy transfer in N2 and O2, a phenomenon not observed in binary gas systems. These findings have important implications for developing the reduced-order model based on coarse-grained treatment.


  • Two-temperature thermochemical nonequilibrium model based on the coarse-grained treatment of molecular vibrational states

    by Jiaqi Lv, Qizhen Hong, Xiaoyong Wang, Yifeng Huang, Quanhua Sun

    Although the high-fidelity state-to-state (StS) model accurately describes high-temperature thermochemical nonequilibrium flows, its practical application is hindered by the prohibitively high computational cost. In this paper, we develop a reduced-order model that leverages the widely used two-temperature (2T) framework and a coarse-grained treatment of molecular vibrational states to achieve accuracy comparable to the StS model while ensuring computational efficiency. We observe that the multigroup coarse-grained model (CGM), lumping vibrational energy levels into several groups, yields results close to the StS model for the high-temperature postshock oxygen flows, even using only two groups. However, the one-group CGM (CGM-1G), equivalent to the 2T model but using the StS kinetics, fails to approximate the StS results. Analysis of microscopic group properties reveals that the failure of the CGM-1G stems from the inability to capture the non-Boltzmann effects of mid-to-high vibrational levels, overestimating apparent dissociation rates and vibrational energy loss in the dissociation-dominated region. We then propose an analytical distribution function of vibrational groups by incorporating Treanor-like terms and an additional linear term (addressing the dissociation depletion of highlying levels). Building upon this algebraic group distribution function and reconstructing vibrational levels within each group using the vibrational temperature, we develop a new 2T model called CG2T, which demonstrates accuracy much closer (than the CGM-1G) to the StS results for the postshock oxygen flows with varying degrees of thermochemical nonequilibrium. Moreover, a fullyconnected neural network is pretrained to substitute the module for the mass and vibrational energy source terms to enhance computational efficiency, achieving about 30-fold speedup in the CG2T model without sacrificing accuracy.


  • Direct Numerical Simulation of High-Enthalpy Turbulent Boundary-Layer Flow with Light Gas Injections

    by Rui Zhao, Zhengxuan Zuo, Xiaoyong Wang, Wu Yuan, Chihyung Wen

    Two light gases (He and [Formula: see text]) are, respectively, introduced upstream of a high-enthalpy turbulent flat-plate flow with a boundary-layer edge Mach number of [Formula: see text] and temperature of [Formula: see text]. The flow condition refers to the after-shock wave flow on a blunt-body hypersonic vehicle (Duan and Martín, AIAA Journal, Vol. 49, No. 1, 2011, pp. 172–184). Direct numerical simulation results show that the injection of these light gases has little effect on the mean velocity profiles but significantly reduces the near-wall density and skin friction. The separation and fragmentation of near-wall vortical structures are restrained, and the Reynolds shear stress decreases. The injection of inert He inhibits the dissociation reaction of [Formula: see text] and weakens the chemical nonequilibrium effect, resulting in enhanced mean and fluctuating temperatures. The injection of active [Formula: see text] promotes the reaction between [Formula: see text] and [Formula: see text], which increases the mean temperature but inhibits its fluctuation. After decomposing the mean skin friction into physics-informed contributions, both injections largely reduce the turbulent kinetic energy production term [Formula: see text] and the spatial growth term of the flow, [Formula: see text], through lowering the near-wall density and reducing vortices.


  • Investigation of high enthalpy thermochemical nonequilibrium flow over spheres

    by Jinghui Guo, Xiaoyong Wang, Sijia Li

    The hypersonic high enthalpy nitrogen flows over spheres are investigated by high-fidelity state-to-state (StS) modeling. The objective of the study is to understand the nonequilibrium behaviors in the shock layer, including the stagnation line features, surface heat transfer rate, and near-wall properties inside the thermal boundary layer. Two cases with the freestream total enthalpies of 16.5 and 15.5 MJ/kg are considered, and the numerical results are compared with the experimental data. The StS model yields an accurate prediction of the shock stand-off distance with the experiment rather than an underestimation by the traditional two-temperature model. Both the StS and two-temperature models provide general agreement of the stagnation point heat flux with the experiment. In comparison, the heat flux obtained by the StS model is lower than the two-temperature model. Note that our work finds distinctive behaviors of near-wall properties. The vibrational energy is not accommodated with the sphere surface and is in thermal nonequilibrium with the translational energy, with evidence showing that the vibrational temperature is much higher than the wall temperature and the translational temperature. The values of vibrational temperature in the immediate vicinity of the stagnation point are 9.3 and 10.0 times the wall temperature for the cases with total enthalpies of 16.5 and 15.5 MJ/kg, respectively. Moreover, the vibration temperature demonstrates a nonmonotonic variation trend with a local minimum, which can be explained by the nonequilibrium distributions of vibrational energy states due to vibrational-translational energy transfer and molecular recombination.


  • Open Access

    High-fidelity state-to-state modeling of hypersonic flow over a double cone

    by Xiaoyong Wang, Jinghui Guo, Qizhen Hong, Sijia Li

    The state-of-the-art high-fidelity state-to-state (StS) model is performed to investigate the hypersonic shock wave/laminar boundary layer interaction over a 25°–55° double cone. This work aims to clarify whether the shortcomings of thermochemical models are the underlying source for the discrepancies between the simulations and experiments. A high-enthalpy nitrogen flow with a Mach number of 11.54 and a unit Reynolds number of 4.394×105/m is considered. We first find that the StS and widely used two-temperature models yield two different shock reflection patterns (i.e., the regular reflection and Mach reflection, respectively). However, the surface pressure and heat flux distributions predicted by the two models are generally consistent, which are not influenced by the differences in the shock patterns, dissociation rates, and non-Boltzmann vibrational distributions in the flowfields. Moreover, the StS model fails to match the experiments in spite of fairly limited improvement. Our findings indicate that the shortcomings of thermochemical models are not the main reason for the discrepancies in the simulations and experiments for the high-enthalpy nitrogen double-cone flow.