Ivana Podstranská
Research Subjects
Ivana Podstranská has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Aleksandr Gokhman
Comtes FHT a.s., Průmyslová 995, 334 41 Dobřany, Czech Republic
1 shared publication - Jakub Kotous
Comtes FHT a.s., Průmyslová 995, 334 41 Dobřany, Czech Republic
1 shared publication - Milan Svoboda
Institute of Physics of Materials
1 shared publication - Pavel Salvetr
Comtes FHT a.s., Průmyslová 995, 334 41 Dobřany, Czech Republic
1 shared publication - Zbyšek Nový
COMTES FHT a. s., Prumyslova 995, 334 41 Dobrany, Czech Republic
1 shared publication - Črtomir Donik
Institute of Metals and Technology
1 shared publication
Latest Publications
- Open Access
Effect of Cu Alloying on Mechanical Properties of Medium-C Steel after Long-Time Tempering at 500 °C
This research studies the influence of the copper alloying of medium-carbon steel on mechanical properties after quenching and tempering at 500 °C. The microstructure was characterised using SEM, EBSD, TEM, and XRD analysis. The mechanical properties were comprehensively investigated using hardness measurements, tensile and Charpy impact tests and solid solution, grain boundary, dislocation, and precipitation strengthening contributions were estimated. Higher yield strength for Cu-alloyed steel was confirmed at about 35–73 MPa. The precipitation strengthening contribution from Cu precipitates in the range of 11–49 MPa was calculated. The interaction between Cu precipitates and dislocations retards the decrease in dislocation density. Similar values of effective grain size of martensite crystals were measured for Cu-alloyed and Cu-free steel as well. Copper alloyed steel exhibited significantly deteriorated impact toughness, total plastic elongation, and reduction of area. The size of Cu precipitates ranged from 8.3 nm after tempering at 500 °C for 6 h to 13.9 nm after tempering for 48 h.
Open AccessEffect of Cu Alloying on Mechanical Properties of Medium-C Steel after Long-Time Tempering at 500 °C
This research studies the influence of the copper alloying of medium-carbon steel on mechanical properties after quenching and tempering at 500 °C. The microstructure was characterised using SEM, EBSD, TEM, and XRD analysis. The mechanical properties were comprehensively investigated using hardness measurements, tensile and Charpy impact tests and solid solution, grain boundary, dislocation, and precipitation strengthening contributions were estimated. Higher yield strength for Cu-alloyed steel was confirmed at about 35–73 MPa. The precipitation strengthening contribution from Cu precipitates in the range of 11–49 MPa was calculated. The interaction between Cu precipitates and dislocations retards the decrease in dislocation density. Similar values of effective grain size of martensite crystals were measured for Cu-alloyed and Cu-free steel as well. Copper alloyed steel exhibited significantly deteriorated impact toughness, total plastic elongation, and reduction of area. The size of Cu precipitates ranged from 8.3 nm after tempering at 500 °C for 6 h to 13.9 nm after tempering for 48 h.