Long Wang
Research Subjects
Long Wang has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Hengwei Yu
Fudan Univ, State Key Lab ASIC & Syst, Shanghai 201203, Peoples R China
2 shared publications - Jiqing Xu
School of Microelectronics, Fudan University, Shanghai, China
2 shared publications - Patrick Yin Chiang
School of Microelectronics, Fudan University, Shanghai, China
2 shared publications Lei Zhao
State Key Laboratory of ASIC and System, Fudan University, Shanghai, China
1 shared publication- Shenglong Zhuo
State Key Laboratory of ASIC and System, Fudan University, Shanghai, China
1 shared publication - Tao Xia
School of Integrated Circuits, Peking University, Beijing, China
1 shared publication
Latest Publications
- 14 March 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 35 (9) , 477-480
All-in-One SPAD Ranging Sensor With Real-Time Xtalk Calibration and Integrated Biasing
This letter presents a novel fully integrated dToF system-on-chip ranging sensor based on a SPADs array. The sensor is made a configurable array of $16\times16$ SPADs, a 940nm VCSEL, a co-design VCSEL driver and embedded DSP core. To suitable different ranging scenarios with high reliability and low cost, the above mentioned are all packaged into one module for ranging. However, the package of coverglass can cause Xtalk, which have a negative impact on ranging. In order to reduce the influence of Xtalk on ranging. This letter proposes a real-time Xtalk calibration circuit system, which can automatically adjust the laser pulse width, when Xtalk and target bins are mixed together. And also to mitigate the effect of SPAD jitter on the Xtalk bins width, an adjustable bias voltage charge pump circuit is adopted to realize the accurate adjustment of pixel SPAD’s bias voltage. The system has been turned out with precision of better than 5mm within 6m in 80% reflectance of target, still with a precision better than 8mm at a distance within 4m in 18% reflectance of target.
- 14 March 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 35 (9) , 477-480
All-in-One SPAD Ranging Sensor With Real-Time Xtalk Calibration and Integrated Biasing
This letter presents a novel fully integrated dToF system-on-chip ranging sensor based on a SPADs array. The sensor is made a configurable array of $16\times16$ SPADs, a 940nm VCSEL, a co-design VCSEL driver and embedded DSP core. To suitable different ranging scenarios with high reliability and low cost, the above mentioned are all packaged into one module for ranging. However, the package of coverglass can cause Xtalk, which have a negative impact on ranging. In order to reduce the influence of Xtalk on ranging. This letter proposes a real-time Xtalk calibration circuit system, which can automatically adjust the laser pulse width, when Xtalk and target bins are mixed together. And also to mitigate the effect of SPAD jitter on the Xtalk bins width, an adjustable bias voltage charge pump circuit is adopted to realize the accurate adjustment of pixel SPAD’s bias voltage. The system has been turned out with precision of better than 5mm within 6m in 80% reflectance of target, still with a precision better than 8mm at a distance within 4m in 18% reflectance of target.
- Open Access
A dToF Ranging Sensor with Accurate Photon Detector Measurements for LiDAR Applications
Direct time-of-flight (dToF) ranging sensors based on single-photon avalanche diodes (SPADs) have been used as a prominent depth-sensing devices. Time-to-digital converters (TDCs) and histogram builders have become the standard for dToF sensors. However, one of the main current issues is the bin width of the histogram, which limits the accuracy of depth without TDC architecture modifications. SPAD-based light detection and ranging (LiDAR) systems require new methods to overcome their inherent drawbacks for accurate 3D ranging. In this work, we report an optimal matched filter to process the raw data of the histogram to obtain high-accuracy depth. This method is performed by feeding the raw data of the histogram into the different matched filters and using the Center-of-Mass (CoM) algorithm for depth extraction. Comparing the measurement results of different matched filters, the filter with the highest depth accuracy can be obtained. Finally, we implemented a dToF system-on-chip (SoC) ranging sensor. The sensor is made of a configurable array of 16 × 16 SPADs, a 940 nm vertical-cavity surface-emitting laser (VCSEL), an integrated VCSEL driver, and an embedded microcontroller unit (MCU) core to implement the best matched filter. To achieve suitably high reliability and low cost, the above-mentioned features are all packaged into one module for ranging. The system resulted in a precision of better than 5 mm within 6 m with 80% reflectance of the target, and had a precision better than 8 mm at a distance within 4 m with 18% reflectance of the target.
Open AccessA dToF Ranging Sensor with Accurate Photon Detector Measurements for LiDAR Applications
Direct time-of-flight (dToF) ranging sensors based on single-photon avalanche diodes (SPADs) have been used as a prominent depth-sensing devices. Time-to-digital converters (TDCs) and histogram builders have become the standard for dToF sensors. However, one of the main current issues is the bin width of the histogram, which limits the accuracy of depth without TDC architecture modifications. SPAD-based light detection and ranging (LiDAR) systems require new methods to overcome their inherent drawbacks for accurate 3D ranging. In this work, we report an optimal matched filter to process the raw data of the histogram to obtain high-accuracy depth. This method is performed by feeding the raw data of the histogram into the different matched filters and using the Center-of-Mass (CoM) algorithm for depth extraction. Comparing the measurement results of different matched filters, the filter with the highest depth accuracy can be obtained. Finally, we implemented a dToF system-on-chip (SoC) ranging sensor. The sensor is made of a configurable array of 16 × 16 SPADs, a 940 nm vertical-cavity surface-emitting laser (VCSEL), an integrated VCSEL driver, and an embedded microcontroller unit (MCU) core to implement the best matched filter. To achieve suitably high reliability and low cost, the above-mentioned features are all packaged into one module for ranging. The system resulted in a precision of better than 5 mm within 6 m with 80% reflectance of the target, and had a precision better than 8 mm at a distance within 4 m with 18% reflectance of the target.