Antoine Bident
Research Subjects
Research Interests
Antoine Bident has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- Christine Labrugère-Sarroste
Univ. Bordeaux, CNRS, PLACAMAT, UAR 3626, F-33600 Pessac, France
1 shared publication - Florence Delange
Schneider Electric SAS, 38 EQI, Rue Henry Tarze, 38000 Grenoble, France
1 shared publication - Jean-François Silvain
University Bordeaux, CNRS, Bordeaux INP, ICMCB, UMR 5026, Pessac, France
1 shared publication - Nathalie Caillault1 shared publication
- Yongfeng Lu
Department of Electrical and Computer Engineering, University of Nebraska-Lincoln, Lincoln, NE 68588, USA
1 shared publication
Latest Publications
- Open Access
- 14 June 2023
- Published by MDPI AG in Preprints.org
Fabrication and Characterization of Copper and Copper Alloys Reinforced with Graphene
The constant increase in current density in electrical wires leads to increasingly significant heat losses due to Joule effect. Therefore, reducing the electrical resistivity of copper wires becomes necessary. To achieve this goal, the development of a composite material incorporating a more conductive reinforcement, the graphene, is a promising way. The design of a copper/graphene composite using a powder metallurgy-based method is presented. This synthesis method allows for interface control through the growth of CuO(Cu) nanoparticles tightly bonded to the reinforcement. It also involves the dispersion of graphene through ultrasonic treatment and its alignment within the matrix using a uniaxial pressing densification method. The increase in the hardness (+12 HV) demonstrates the effective dispersion and separation of graphene layers. The impact on the electrical properties of dendritic copper (ρe = 2.30 µΩ.cm) remains limited, with a decrease in electrical resistance of approximately 1.4%. However, for copper with higher electrical resistivity, flake copper (at 2.71 µΩ.cm) and brass at (7.66 µΩ.cm), reductions of 2.7% and 10% have been achieved, respectively. With the improvement of graphene quality, there is more room to improve the electrical properties. This work paves the way for the development of composites with improved electrical resistivity.
- 14 June 2023
- Published by MDPI AG in Preprints.org
Open AccessFabrication and Characterization of Copper and Copper Alloys Reinforced with Graphene
The constant increase in current density in electrical wires leads to increasingly significant heat losses due to Joule effect. Therefore, reducing the electrical resistivity of copper wires becomes necessary. To achieve this goal, the development of a composite material incorporating a more conductive reinforcement, the graphene, is a promising way. The design of a copper/graphene composite using a powder metallurgy-based method is presented. This synthesis method allows for interface control through the growth of CuO(Cu) nanoparticles tightly bonded to the reinforcement. It also involves the dispersion of graphene through ultrasonic treatment and its alignment within the matrix using a uniaxial pressing densification method. The increase in the hardness (+12 HV) demonstrates the effective dispersion and separation of graphene layers. The impact on the electrical properties of dendritic copper (ρe = 2.30 µΩ.cm) remains limited, with a decrease in electrical resistance of approximately 1.4%. However, for copper with higher electrical resistivity, flake copper (at 2.71 µΩ.cm) and brass at (7.66 µΩ.cm), reductions of 2.7% and 10% have been achieved, respectively. With the improvement of graphene quality, there is more room to improve the electrical properties. This work paves the way for the development of composites with improved electrical resistivity.