Seung Ho Ryu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Seung Ho Ryu has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
- Seong Keun Kim
Korea Institute of Science and Technology
4 shared publications - In-Hwan Baek
Department of Chemistry and Chemical Engineering Education and Research Center For Smart Energy and Materials Inha University Incheon Republic of Korea
3 shared publications - Taek-Mo Chung
Thin Film Materials Research Center, Korea Research Institute of Chemical Technology, 141 Gajeong-ro, Yuseong-gu, Daejeon 34114, Republic of Korea
2 shared publications - Taikyu Kim
Stanford University
2 shared publications - Dong Hyun Park
Department of Chemistry and Chemical Engineering Education and Research Center For Smart Energy and Materials Inha University Incheon Republic of Korea
1 shared publication - Gwang Min Park
KU-KIST Graduate School of Converging Science and Technology, Korea University 1 , Seoul 02841, South Korea
1 shared publication
Latest Publications
- 12 October 2026
- Published by AIP Publishing in Applied Physics Letters
- Vol. 129 (15)
High-mobility enhancement-mode thin-film transistors with 1.5 nm-thick ALD-grown Sn-doped In2O3 channels
Aggressive channel thickness scaling to the sub-2 nm regime is essential for strengthening electrostatic gate control in monolithic three-dimensional electronics, but it causes severe carrier depletion and transport degradation in In2O3 thin-film transistors (TFTs). Here, we demonstrate enhancement-mode TFTs with 1.5 nm-thick Sn-doped In2O3 (ITO) channels prepared by inhibitor-assisted atomic layer deposition. At the same physical channel thickness, the ITO TFT exhibits a field-effect mobility of 25.7 ± 1.4 cm2V−1s−1, a subthreshold swing of 129 ± 31 mV/dec, and a threshold voltage of 0.2 ± 0.2 V, whereas the undoped In2O3 TFT undergoes severe transport degradation. The ITO TFT also shows markedly improved positive-bias-stress stability, with a threshold voltage shift of 0.37 V after 3600 s, whereas the thickness-matched In2O3 TFT reaches 2.07 V within 1000 s and fails before 3600 s. Analysis of the effective mobility and sheet carrier density indicates that Sn doping mitigates carrier depletion in the sub-2 nm channel. The resulting carrier replenishment improves on-state transport and strengthens electrostatic screening against positive-bias-induced trap charging, thereby improving the mobility–positive-bias-stress stability balance. These results establish controlled Sn doping as an effective strategy for realizing high-mobility ultrathin In2O3 TFTs with positive-bias-stress stability for monolithic three-dimensional electronics.
- 12 October 2026
- Published by AIP Publishing in Applied Physics Letters
- Vol. 129 (15)
High-mobility enhancement-mode thin-film transistors with 1.5 nm-thick ALD-grown Sn-doped In2O3 channels
Aggressive channel thickness scaling to the sub-2 nm regime is essential for strengthening electrostatic gate control in monolithic three-dimensional electronics, but it causes severe carrier depletion and transport degradation in In2O3 thin-film transistors (TFTs). Here, we demonstrate enhancement-mode TFTs with 1.5 nm-thick Sn-doped In2O3 (ITO) channels prepared by inhibitor-assisted atomic layer deposition. At the same physical channel thickness, the ITO TFT exhibits a field-effect mobility of 25.7 ± 1.4 cm2V−1s−1, a subthreshold swing of 129 ± 31 mV/dec, and a threshold voltage of 0.2 ± 0.2 V, whereas the undoped In2O3 TFT undergoes severe transport degradation. The ITO TFT also shows markedly improved positive-bias-stress stability, with a threshold voltage shift of 0.37 V after 3600 s, whereas the thickness-matched In2O3 TFT reaches 2.07 V within 1000 s and fails before 3600 s. Analysis of the effective mobility and sheet carrier density indicates that Sn doping mitigates carrier depletion in the sub-2 nm channel. The resulting carrier replenishment improves on-state transport and strengthens electrostatic screening against positive-bias-induced trap charging, thereby improving the mobility–positive-bias-stress stability balance. These results establish controlled Sn doping as an effective strategy for realizing high-mobility ultrathin In2O3 TFTs with positive-bias-stress stability for monolithic three-dimensional electronics.
- Open Access
- 29 July 2026
- Published by Wiley in Advanced Science
- Vol. 13 (59) , e76809
Selective Polarity Control of Metal Oxide Semiconductors for Complementary Logic Gates
Realizing tunable charge carrier polarity is essential for programmable complementary logic circuits. While two‐dimensional (2D) semiconductors have demonstrated polarity controllability through Schottky barrier modulation or contact engineering, their high interfacial sensitivity limits scalability and integration. Here, we present a robust polarity‐conversion strategy for tin oxide (SnO) semiconductors based on electrolyte‐gated transistors (EGTs). In situ electrochemical doping enables the conversion of p‐type SnO to n‐type SnO 2 via Sn 2+ to Sn 4+ oxidation. Both p‐ and n‐type EGTs exhibit outstanding electrical characteristics, including low‐voltage operation, high ON/OFF current ratios, sharp switching behavior, and reliable long‐term stability. Furthermore, we demonstrate the monolithic integration of complementary logic gates, including inverter, NAND, and NOR gates, through spatially selective electrochemical doping of a single SnO layer. Overall, this work provides a scalable and versatile pathway toward oxide‐based programmable complementary circuits.
- 29 July 2026
- Published by Wiley in Advanced Science
- Vol. 13 (59) , e76809
Open AccessSelective Polarity Control of Metal Oxide Semiconductors for Complementary Logic Gates
Realizing tunable charge carrier polarity is essential for programmable complementary logic circuits. While two‐dimensional (2D) semiconductors have demonstrated polarity controllability through Schottky barrier modulation or contact engineering, their high interfacial sensitivity limits scalability and integration. Here, we present a robust polarity‐conversion strategy for tin oxide (SnO) semiconductors based on electrolyte‐gated transistors (EGTs). In situ electrochemical doping enables the conversion of p‐type SnO to n‐type SnO 2 via Sn 2+ to Sn 4+ oxidation. Both p‐ and n‐type EGTs exhibit outstanding electrical characteristics, including low‐voltage operation, high ON/OFF current ratios, sharp switching behavior, and reliable long‐term stability. Furthermore, we demonstrate the monolithic integration of complementary logic gates, including inverter, NAND, and NOR gates, through spatially selective electrochemical doping of a single SnO layer. Overall, this work provides a scalable and versatile pathway toward oxide‐based programmable complementary circuits.
- 20 January 2025
- Published by AIP Publishing in Applied Physics Letters
- Vol. 126 (3)
Ultrahigh field-effect mobility of 147.5 cm2/Vs in ultrathin In2O3 transistors via passivating the surface of polycrystalline HfO2 gate dielectrics
This study presents considerable improvements in the electrical characteristics of atomic-layer-deposited 3-nm-thick In2O3 thin-film transistors (TFTs), which were achieved by introducing a 2-nm-thick amorphous Al2O3 interfacial layer to passivate the surface of a polycrystalline HfO2 gate dielectric. The resulting devices exhibited exceptional electrical characteristics, including an ultrahigh field-effect mobility (μFE) of approximately 147.5 ± 16.6 cm2/V s, subthreshold swing of 103.7 ± 9.1 mV/dec, and threshold voltage (VTH) of 0.5 ± 0.1 V. These enhancement-mode devices represent increases of more than threefold in μFE compared to devices without an amorphous passivation layer. This is despite all the fabrication processes being identical, except for the introduction of the Al2O3 interfacial layer. This improvement can be primarily attributed to the reduced electron scattering through suppressed remote Coulomb interactions. Furthermore, the In2O3 TFTs exhibited enhanced operational stability, showing minimal VTH shifts of 0.15 and −0.01 V under positive and negative bias-stress conditions, respectively. The findings of this study emphasize the critical role of the surface passivation of polycrystalline HfO2 dielectrics in improving the electrical performance of ultrathin In2O3 TFTs.
- 20 January 2025
- Published by AIP Publishing in Applied Physics Letters
- Vol. 126 (3)
Ultrahigh field-effect mobility of 147.5 cm2/Vs in ultrathin In2O3 transistors via passivating the surface of polycrystalline HfO2 gate dielectrics
This study presents considerable improvements in the electrical characteristics of atomic-layer-deposited 3-nm-thick In2O3 thin-film transistors (TFTs), which were achieved by introducing a 2-nm-thick amorphous Al2O3 interfacial layer to passivate the surface of a polycrystalline HfO2 gate dielectric. The resulting devices exhibited exceptional electrical characteristics, including an ultrahigh field-effect mobility (μFE) of approximately 147.5 ± 16.6 cm2/V s, subthreshold swing of 103.7 ± 9.1 mV/dec, and threshold voltage (VTH) of 0.5 ± 0.1 V. These enhancement-mode devices represent increases of more than threefold in μFE compared to devices without an amorphous passivation layer. This is despite all the fabrication processes being identical, except for the introduction of the Al2O3 interfacial layer. This improvement can be primarily attributed to the reduced electron scattering through suppressed remote Coulomb interactions. Furthermore, the In2O3 TFTs exhibited enhanced operational stability, showing minimal VTH shifts of 0.15 and −0.01 V under positive and negative bias-stress conditions, respectively. The findings of this study emphasize the critical role of the surface passivation of polycrystalline HfO2 dielectrics in improving the electrical performance of ultrathin In2O3 TFTs.
- Open Access
- 14 August 2023
- Published by AIP Publishing in Applied Physics Letters
- Vol. 123 (7)
Controlled orientation and microstructure of p-type SnO thin film transistors with high-k dielectric for improved performance
Despite its relatively high hole mobility, the electrical performance of p-type SnO thin-film transistors (TFTs) lags behind that of n-type oxide TFTs. In this study, we present an approach to enhance the performance of p-type SnO TFTs by utilizing an atomic-layer-deposited SnO/high-k structure, with crystalline HfO2 (c-HfO2) serving as a high-k dielectric. However, the grain boundaries on the c-HfO2 surface influenced the microstructure and orientation of the SnO layer, resulting in a random orientation and surface roughening. To address this issue, we modified the c-HfO2 surface with an amorphous ultrathin Al2O3 layer to eliminate the grain boundaries on the deposition surface. This enabled the alignment of the (00l) SnO planes parallel to the substrate surface and provided a smooth surface. Moreover, the introduction of ultrathin Al2O3 into SnO/high-k stacks substantially improved the electrical performance of p-type SnO TFTs. Our findings highlight the potential of integrating van der Waals semiconductors with high-k dielectrics, facilitating opportunities for advanced device applications.
- 14 August 2023
- Published by AIP Publishing in Applied Physics Letters
- Vol. 123 (7)
Open AccessControlled orientation and microstructure of p-type SnO thin film transistors with high-k dielectric for improved performance
Despite its relatively high hole mobility, the electrical performance of p-type SnO thin-film transistors (TFTs) lags behind that of n-type oxide TFTs. In this study, we present an approach to enhance the performance of p-type SnO TFTs by utilizing an atomic-layer-deposited SnO/high-k structure, with crystalline HfO2 (c-HfO2) serving as a high-k dielectric. However, the grain boundaries on the c-HfO2 surface influenced the microstructure and orientation of the SnO layer, resulting in a random orientation and surface roughening. To address this issue, we modified the c-HfO2 surface with an amorphous ultrathin Al2O3 layer to eliminate the grain boundaries on the deposition surface. This enabled the alignment of the (00l) SnO planes parallel to the substrate surface and provided a smooth surface. Moreover, the introduction of ultrathin Al2O3 into SnO/high-k stacks substantially improved the electrical performance of p-type SnO TFTs. Our findings highlight the potential of integrating van der Waals semiconductors with high-k dielectrics, facilitating opportunities for advanced device applications.