BEBurak Evren

Burak Evren

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Burak Evren has a total of 9 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Enhanced interface structure of electroformed copper/diamond composites for thermal management applications

    by Burak Evren, Gökçe Evren, Cem Kıncal, Nuri Solak, Mustafa Ürgen

    As the power density of electronic devices increases, the requirement for heat sinks with enhanced thermal properties becomes imperative for advanced heat dissipation. Copper/diamond composites are next-generation heat dissipators with high thermal conductivities, yet fabrication of these composites requires high energy and complex instruments. In this study, copper/diamond composites are fabricated by electroforming. The sediment co-deposition process is modified to obtain uniform diamond particle distribution with tailorable volume fraction. Diamond particles were initially settled on the cathode surface outside the electrolyte, and then the setup was immersed in an acidic copper sulfate electroforming bath. Varying amounts (0–100 mg l−1) of thiourea are introduced to the electrolyte to enhance the matrix–particle interface. The gaps between diamond particles are filled with electrodeposited copper using optimized deposition conditions. The composite structure detaches from the cathode by itself after the production with desired shape and dimensions. The effect of operating conditions on cathodic polarization, composite microstructure, and thermal properties are investigated. Thermal conductivity of 49 vol.% diamond containing sample fabricated with optimized parameters exceeds 667 W m−1 K−1. The increase in thermal conductivity and enhanced interface structure is attributed to the excellent void-filling ability of the optimized electrolyte.


  • Open Access

    Morphological, microstructural and photocatalytic characterization of undoped and Ni, Co doped Fe2O3 particles synthesized by sonochemical method

    by Eli̇f Emi̇l Kaya, Burak Evren, Zeynep Erdöl, Duygu Eki̇nCi̇, Mehmet İpEkoğlu, Si̇bEl Özenler

    In this study, an abundant and eco-friendly photocatalytic material, Fe2O3 particles were synthesized by sonochemical method. Morphological and microstructural investigations of synthesized undoped and Ni, Co-doped Fe2O3 particles were performed. The effect of particle morphology and microstructure on its photocatalytic performance was further investigated. Comparative studies for evaluating particle crystallite sizes were conducted by Williamson-Hall (W-H) method and modified Debye-Scherrer (MDS). Crystallite sizes and lattice strains of Fe2O3 induced by process parameters were calculated by W-H method based on uniform deformation model (UDM). The crystallite sizes of the synthesized powders were calculated in the range of 200 nm and 76 nm by Williamson-Hall analysis. In addition to structural investigation, dislocation density of the synthesized particles was calculated by Williamson-Smallman relation. Afterwards, photocatalytic performance of Fe2O3 particles was investigated in detail. The photodegradation of methylene blue solutions in the presence of light in 20 min with samples 3,4, and 5 in 20 min were 0.937, 0.896, and 0.855, respectively. Moreover, the photodegradation of methylene blue solution with sample 5 for 15, 30, and 45 min were 0.9, 0.828, and 0.757, respectively. A photocatalytic activity of 24.25% has been observed under optimum conditions for the time interval of 45 min.