Muhammad Waseem
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Muhammad Waseem has a total of 3 co-authors. Here are the top co-authors by number of shared publications:
- Muhammad Jawad
Department of Industrial Engineering, Faculty of Industrial Engineering, University of Engineering and Technology, Taxila, Pakistan
2 shared publications - Muhammad Waqas Hanif
Department of Industrial Engineering, University of Engineering and Technology Taxila, Punjab, Pakistan
2 shared publications - Salman Hussain
Department of Industrial Engineering, University of Engineering and Technology, Taxila, Pakistan
2 shared publications
Latest Publications
- Open Access
- 19 September 2023
- Published by MDPI AG in Engineering Proceedings
- Vol. 45 (1) , 53
Investigating the Ability of Process Parameters to Reduce Defects during the Drilling of Carbon-Fiber-Reinforced Plastic (CFRP) and Aluminum Stack
The effects of drilling process parameters, such as drill diameter and feed rate, on the delamination of holes has been examined while drilling Carbon-Fiber-Reinforced Plastics and aluminum (CFRP/Al2219-T6). The stack method was employed while drilling in order to reduce the defects in the drilling process and enhance the quality of the holes produced. A total of nine experiments were performed using the central composite design. An analysis of variance (ANOVA) revealed that feed rate and drill size have significant effects on the delamination of holes. The experimental results show that the minimum delamination value (1.018) was obtained at a feed rate of 26.5 mm/min and with a drill diameter of 6.5 mm.
- 19 September 2023
- Published by MDPI AG in Engineering Proceedings
- Vol. 45 (1) , 53
Open AccessInvestigating the Ability of Process Parameters to Reduce Defects during the Drilling of Carbon-Fiber-Reinforced Plastic (CFRP) and Aluminum Stack
The effects of drilling process parameters, such as drill diameter and feed rate, on the delamination of holes has been examined while drilling Carbon-Fiber-Reinforced Plastics and aluminum (CFRP/Al2219-T6). The stack method was employed while drilling in order to reduce the defects in the drilling process and enhance the quality of the holes produced. A total of nine experiments were performed using the central composite design. An analysis of variance (ANOVA) revealed that feed rate and drill size have significant effects on the delamination of holes. The experimental results show that the minimum delamination value (1.018) was obtained at a feed rate of 26.5 mm/min and with a drill diameter of 6.5 mm.