BDBjoern Driemeyer

Bjoern Driemeyer

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Bjoern Driemeyer has a total of 8 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    An Eye-Opening Arbiter PUF With Auto-Error Detection and PVT-Robust Masking Achieving a BER of 2e -8

    by Bjoern Driemeyer, Holger Mandry, David-Peter Wiens, John G. Kauffman, Joachim Becker, Maurits Ortmanns

    A hybrid ring oscillator (RO)/ arbiter physical unclonable function (PUF) is implemented in a 28-nm CMOS, where two competing ROs accumulate a sufficiently large phase difference exceeding a predefined deadzone (DZ). The resulting eye-opening arbiter (EOA) architecture enables a prediction of PUF bit stability over temperature change (from −40 °C to $125~^{\circ }$ C), supply voltage variation (±10%), and four-year accelerated aging based on a single point measurement at the initial PUFs usage. This once-a-lifetime initialization at nominal conditions generates a blanking mask without disclosing secret PUF information, off-chip or even outside the PUF cells. The EOA architecture additionally features an inherent multi-purpose auto-error detection (AE-Detection), which allows to assess the reliability of every generated PUF bit at every PUF bit readout. Using AE-detection and masking, a bit error rate (BER) of $2 \times 10^{-8}$ over 16 measured devices and a total of $200 \times 10^{6}$ measured bits over environmental changes and aging could be measured. The PUF operates with 0.259 pJ/bit, generates PUF bits with 4.515-Gbit/s bit-rate and only requires $34.84~\mu \text {m}^{2}$ per bit, including all masking and stabilization circuitry, to ensure the low BER PUF performance.

  • A Mixed-Signal I-D-TIA With Direct Digitization [Technical Note]

    by David-Peter Wiens, Ahmed Abdelaal, Bjoern Driemeyer, Joachim Becker, John G. Kauffman, Maurits Ortmanns

    Emerging sensing techniques impose strict requirements on the analog frontend regarding noise, bandwidth (BW), scalability, etc. For example, in nanopore-based DNA sequencing, two buffer solutions are separated by a membrane with a nanometer-sized pore. As molecules pass through the pore, they change the ionic current, producing a very small signal (MHz) is required in the sensing circuit [1]. Another example is scanning ion conductance microscopy, where a pipettewith an opening of a fewhundred nanometers is scanned over a small object (e.g., a cell or bacterium). The ionic current (hundres of pA) through the pipette varies with the object’s distance, thus a topographical image can be generated. To achieve high scan rates, a large BW(>100kHz) is required in the analog sensing front-end [2].

  • A Digitizing Integrator–Differentiator TIA With 1-MHz Bandwidth and 93-pA rms Sensitivity in 28-nm CMOS

    by David-Peter Wiens, Ahmed Abdelaal, Bjoern Driemeyer, Joachim Becker, John G. Kauffman, Maurits Ortmanns

    This article presents a low-noise, wideband, and direct-digitizing current sensing analog frontend based on a mixed-signal integrator–differentiator transimpedance amplifier (MS-TIA). Previous state of the art (SoA) implementations of low-noise and wideband current sensing analog frontends relied on analog amplifiers with large passive components. Furthermore, an analog-to-digital converter (ADC) is often not included in SoA designs. In the presented MS-TIA, an ADC is included in the signal chain, and most of the signal processing tasks are performed in the digital domain, thus benefiting from the use of an advanced process node. The presented MS-TIA was fabricated in 28-nm CMOS with an active area of 0.13 mm2. It achieves 93-pArms sensitivity in a 1-MHz bandwidth (BW), with a minimum input-referred current spot noise of 30 fA/ $\sqrt{}$ Hz. It consumes 8.5 mW from a single 0.9-V supply. The ac transimpedance was measured over a temperature range from $- 40~^{\circ } $ C to $120~^{\circ } $ C and shows only minor variation, with a temperature coefficient of only −100 ppm/K over the entire temperature range.


  • Open Access

    The Eye-Opening Arbiter-PUF FPGA Implementation with Auto Error Detection

    by Holger Mandry, Julian Spiess, Bjoern Driemeyer, Joachim Becker, Maurits Ortmanns

    We present the first implementation of an FPGA-based PUF that leverages the usually contradictory requirements of stability and response time. Many state-of-the-art implementations of PUFs are either slow with a low error rate, like the ring oscillator-PUF, or fast with a higher error rate, like the arbiter-PUF. The presented implementation of an eye-opening PUF uses the phase-integrating effect of a ring oscillator to realize the shortest possible response for the required stability of the readout. This principle also allows for new automatic detection of unstable bits based on counting the number of oscillations required until an arbitration is conducted. This first implementation of an eye-opening PUF reduces the bit error rate to a number under our measurement limits, while the readout time is simultaneously kept as low as ≤1.54 μs, with an average of 0.85 μs. In addition, environmental temperature changes are evaluated, and methods for limiting these effects are discussed.


  • A Mixed-Signal Integrator-Differentiator-TIA

    by David-Peter Wiens, Markus Sporer, Björn Driemeyer, Maurits Ortmanns

    Various implementations of transimpedance amplifiers (TIAs) are used for current sensing applications and they allow for low noise and wide bandwidth (BW). The process of digitization is usually not implicitly discussed. Though, BW limitation, sampling and quantization obviously add additional circuit complexity and have a strong influence on the minimum achievable spot-noise in low noise TIAs. We introduce a mixed-signal topology for the integrator-differentiator TIA (I-D-TIA), which introduces the analog-to-digital converter (ADC) before differentiation, thereby avoiding the implementation of the usually wideband and power-dominating analog differentiator. The proposed topologies are compared by circuit-level simulations.