JTJiqiang Tang

Jiqiang Tang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Jiqiang Tang has a total of 24 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Decoupling Control of Asymmetric Multicoupled AMB System Under Gyroscopic Effect Using Constrained Robust MPC With Adaptive Gain

    by Min Zhang, Jinxiang Zhou, Xue Han, Jiqiang Tang, Quanyao Yang, Shiqiang Zheng

    The multicoupling problem caused by the gyroscopic effect, asymmetric parameter coupling, and output coupling seriously affects the stability of magnetically suspended rotor (MSR) system of magnetically suspended turbo molecular pump (MSTMP). An adaptive constrained robust model predictive control (ACR-MPC) method with an adaptive feedback gain update is proposed to solve the multicoupling problem of an asymmetric large-inertia system. First, a state-space model is established considering gyroscopic effect, asymmetric parameter coupling, and output coupling, with rotor unbalance treated as a bounded disturbance. Second, based on the nominal-model MPC, a feedback-gain adaptive update law is designed to compensate for disturbances via linear state feedback. Third, a switching strategy is designed to accelerate Lyapunov function decay for faster convergence, while safety constraint tightening and actuator saturation implementation enhance the protection gap safety margin, and Lyapunov-based terminal constraints ensure closed-loop stability. Finally, simulation results show that the centralized decoupling control strategy can effectively solve the coupling among multiple channels of the asymmetric MSR system. Experiments on the MSTMP verify the feasibility and effectiveness of the ACR-MPC. Nutation spectrum is lower than –70.00 dBV, synchronous frequency vibration spectrum is lower than –30.00 dBV.

  • Real-Time Disturbance Magnetic Field Observation Method Based on Multiple Sensors to Enhance the Directionality of Active Disturbance Suppression in MCG Systems

    by Shengjie Qiu, Jiqiang Tang, Pengtao Tian, Fengwen Zhao

    Active magnetic compensation is commonly combined with passive magnetic shielding structures in magnetocardiography measurements to suppress environmental magnetic disturbances and improve the signal-to-noise ratio. Accurate measurement of the disturbance field in the target region is essential for control decisions. Active compensation systems that rely on a single reference sensor often suffer from inaccurate disturbance estimation and degradation of the target signal signal-to-noise ratio. In this work, a computationally efficient magnetic field observation method based on two-dimensional spherical harmonics is proposed. By exploiting the spatial correlation differences of signals, a Kalman filter is designed to suppress random noise and target signal components in the reference sensor while interpolating the disturbance field in the target region. Validation experiments were conducted on a prototype magnetocardiography system equipped with a barrel-shaped magnetic shielding structure. The results demonstrate that the proposed observation method can effectively guide the active compensation system to suppress disturbances in the target region, with the suppression rate improved from 43.05% using a single sensor to 84.14%. This disturbance observation approach provides valuable insights for the development of multi-channel active compensation systems and magnetocardiography devices operating without passive magnetic shielding.

  • Design of Uniform Magnetic Field Coils With Array Characteristics Under Asymmetric Coupling Effect in Magnetocardiography Devices

    by Wenzheng Wang, Jiqiang Tang, Fengwen Zhao, Lu Zhang, Yimeng Zhai, Haifeng Zhang

    Uniform magnetic field coils (UMFCs) are vital for generating a magnetic field environment that meets the magneto-cardiography (MCG) measurement requirements. However, designing UMFCs under the influence of asymmetric coupling within a single-ended magnetic shielding cylinder (SEMSC) is challenging. To address this issue, this article proposes a design method for a coil with array characteristics (CAC), in which the current of each coil unit (CU) is adaptively adjusted based on the coupling differences, thereby enabling the CAC to generate a highly uniform magnetic field within the SEMSC. First, an ana-lytical model of the array within the SEMSC is established. Subsequently, a two-stage particle swarm optimization (TS-PSO) algorithm is proposed to optimize the currents and turns of each CU, and the CAC path is planned based on a depth-first search (DFS) strategy. Simulation and experimental results demonstrate that the CAC achieves superior magnetic field uniformity within the SEMSC compared to other coils. Furthermore, magnetic field compensation experiments validate the effectiveness of CAC in improving MCG measurement quality, indicating that the aver-age power spectral density of magnetic field noise in the 1–40 Hz frequency range is reduced from 52.34 fT/Hz1/2 to 26.16 fT/Hz1/2. These results highlight the significant importance of this method in creating the magnetic environment for MCG measurements.

  • Open Access

    Vibration Suppression of Multi-Stage-Blade AMB-Rotor Using Parallel Adaptive and Cascaded Multi-Frequency Notch Filters

    by Min Zhang, Jiqiang Tang, Jinxiang Zhou, Xue Han, Kun Wang

    The application of active magnetic bearings (AMBs) in high-speed rotating machinery faces the challenge of micro-vibration. This research addresses the vibration control of a high-speed magnetically suspended turbo molecular pump (MSTMP) with rotor mass imbalance vibration and multi-stage-blade modal vibration. A novel integrated AMB controller consisting of parallel co-frequency adaptive notch filter (ANF) and cascaded multi-frequency improved double-T notch filters (DTNFs) is proposed. To suppress rotor mass imbalance vibration, a bandwidth factor rectification method of the ANF based on displacement stiffness perturbation is designed. To suppress multi-stage-blade modal vibration, a multi-objective constrained optimization method of cascaded improved DTNFs based on linear normalization is designed. Simulation and experimental results validate that the proposed structure improvement of the addition of an AMB controller and multi-parameter optimization of the algorithm can effectively improve not only the phase stability margin and the notch vibration performance of the magnetically suspended rotor (MSR) system but also the efficiency and practicability of the algorithm. At rotational speeds of 12,000 rpm, 15,000 rpm, 18,000 rpm, and 21,000 rpm, the suppression of co-frequency synchronous vibration is approximately maintained between −30.94 dB and −30.56 dB. At the rated speed of 24,000 rpm, compared with other algorithms, the value of the rotor displacement converges from 0.08 mm to 0.03 mm, a reduction of 62.50%. The convergence time decreases from 3.67 s to 2.85 s, a reduction of 22.34%.


  • Research on Magnetic Field Compensation Method Based on Fuzzy PI Control for Low Remanence in Magnetic Shielding Room

    by Jiqiang Tang, Yunfei Fang, Xikai Liu, Shengyi Shangguan

    An active magnetic compensation method based on passive shielding is used for low remanence and interfering field suppression in a lower cost magnetic shielding room (MSR). In this paper, a compensation coil control strategy with conventional PI and fuzzy PI segmentation control is proposed, and an active magnetic compensation system with a linearized model is built using an external high uniformity Helmholtz coil. The result shows that the compensation system has a greatly improvement in the suppression of the interfering magnetic field in the environment while ensuring good step response performance of the controller.


  • Open Access

    Neural Network Sliding Model Control of Radial Translation for Magnetically Suspended Rotor (MSR) in Control Moment Gyro

    by Jiqiang Tang, Min Zhang, Xu Cui, Jinji Sun, Xinxiu Zhou

    For a magnetically suspended control moment gyro (MSCMG), the high-speed rotor is actively suspended by magnetic bearings of 5-DOF, but the nonlinearity of the magnetic suspension force is one of the main reasons for the poor accuracy of radial translation control of the magnetically suspended rotor (MSR). To solve this problem, here, the characteristics of the magnetic suspension force are analyzed, and the nonlinear dynamic model of MSR is established. A sliding mode control (SMC) based on a neural network is presented, and the radial basis function (RBF) neural network is adopted to approximate the nonlinear displacement stiffness and the current displacement stiffness to weaken the chattering in SMC to improve the control accuracy of the MSR. The stability of the neural network SMC for the MSR is analyzed based on Lyapunov functions, and the rules of updating network weights are presented based on adaptive algorithms. Compared with these existing classic control methods, the simulation and experimental tests performed on a single-gimbal MSCMG with an angular momentum of 200 N.m.s indicated that this neural network SMC for MSR’s radial translation can not only make its suspension more stable but can also make its position precision higher.


  • Superconducting Magnetic Bearings and Active Magnetic Bearings in Attitude Control and Energy Storage Flywheel for Spacecraft

    by Jiqiang Tang, Jiancheng Fang, Wen Wen

    For an attitude control and energy storage flywheel (ACESF), not only does the speed of the rotor must be high but also the position of the rotor must be controlled accurately. To research the relationship between superconducting magnetic bearings (SMBs) and active magnetic bearings (AMBs) in this presented superconducting ACESF, the rotor model is established, the force of SMBs and AMBs is simplified by linearization, and the radial translation and tilting movement of the rotor suspended by only SMBs, SMBs with equivalent permanent-magnet bearings, and SMBs and AMBs with proportional-derivative-type control are researched, respectively. For the disklike rigid rotor with large inertia and high speed, simulation and experimental results proved that the gyroscopic effect of the rotor is prominent, the rotor model including gyroscopic couples can describe its behaviors, and the linearization of force for SMBs and AMBs are reasonable. The AMB can suppress the nutation and precession of the rotor effectively by a cross-feedback control method or other modern control methods; the SMB, together with the AMB, can make the rotor in ACESF be stable and the amplitude of the vibration of rotor be small.