Mohd Perwez Ali
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Mohd Perwez Ali has a total of 2 co-authors. Here are the top co-authors by number of shared publications:
- Nadeem Hasan
Aligarh Muslim University
4 shared publications - Sanjeev Sanghi
Indian Institute of Technology Delhi
4 shared publications
Latest Publications
- Open Access
- 4 November 2026
- Published by Cambridge University Press (CUP) in Journal of Fluid Mechanics
- Vol. 1046, A49
Role of baroclinic vorticity production on three-dimensional wake transition of a heated cylinder using a non-Boussinesq model
This study examines the role of buoyancy-induced baroclinic vorticity production in the three-dimensional (3-D) wake transition behind an infinitely long heated square cylinder subjected to aiding and cross-flow buoyancy, using direct numerical simulation (DNS). A non-Oberbeck–Boussinesq (NOB) model is employed, requiring the solution of the full compressible Navier–Stokes equations to capture baroclinic effects under large-scale heating regimes. Simulations are carried out at a Reynolds number of italic Re equals 300 $\textit{Re} = 300$ and a low Mach number ( upper M equals 0.1 $M = 0.1$ ) to minimise compressibility effects, with air (Prandtl number italic probability equals 0.71 $\textit{Pr} = 0.71$ ) as the working fluid. Previous studies have demonstrated that baroclinic torque significantly enhances the strength of 3-D wake structures, thereby promoting an earlier onset of three-dimensionality compared with the unheated case. However, these effects have been predominantly investigated in cross-buoyancy configurations, and the underlying mechanisms remain insufficiently understood. In the present study, the contributions of streamwise and spanwise baroclinic torque are systematically analysed to elucidate the mechanisms governing flow instability and organisation in thermally influenced wakes. The findings reveal a complex interplay between baroclinic torque and buoyancy, indicating that increasing heating levels weaken the 3-D wake under aiding-buoyancy conditions while strengthening it in cross-buoyancy configurations. Furthermore, the production of spanwise baroclinic torque, whether aligned with or opposed to local vortices, increases flow complexity and influences vortex shedding intensity and vortex dislocations. It also governs the contrasting wake behaviour, resulting in a symmetric wake under aiding buoyancy and an asymmetric wake under cross-buoyancy.- 4 November 2026
- Published by Cambridge University Press (CUP) in Journal of Fluid Mechanics
- Vol. 1046, A49
Open AccessRole of baroclinic vorticity production on three-dimensional wake transition of a heated cylinder using a non-Boussinesq model
This study examines the role of buoyancy-induced baroclinic vorticity production in the three-dimensional (3-D) wake transition behind an infinitely long heated square cylinder subjected to aiding and cross-flow buoyancy, using direct numerical simulation (DNS). A non-Oberbeck–Boussinesq (NOB) model is employed, requiring the solution of the full compressible Navier–Stokes equations to capture baroclinic effects under large-scale heating regimes. Simulations are carried out at a Reynolds number of italic Re equals 300 $\textit{Re} = 300$ and a low Mach number ( upper M equals 0.1 $M = 0.1$ ) to minimise compressibility effects, with air (Prandtl number italic probability equals 0.71 $\textit{Pr} = 0.71$ ) as the working fluid. Previous studies have demonstrated that baroclinic torque significantly enhances the strength of 3-D wake structures, thereby promoting an earlier onset of three-dimensionality compared with the unheated case. However, these effects have been predominantly investigated in cross-buoyancy configurations, and the underlying mechanisms remain insufficiently understood. In the present study, the contributions of streamwise and spanwise baroclinic torque are systematically analysed to elucidate the mechanisms governing flow instability and organisation in thermally influenced wakes. The findings reveal a complex interplay between baroclinic torque and buoyancy, indicating that increasing heating levels weaken the 3-D wake under aiding-buoyancy conditions while strengthening it in cross-buoyancy configurations. Furthermore, the production of spanwise baroclinic torque, whether aligned with or opposed to local vortices, increases flow complexity and influences vortex shedding intensity and vortex dislocations. It also governs the contrasting wake behaviour, resulting in a symmetric wake under aiding buoyancy and an asymmetric wake under cross-buoyancy. - Open Access
- 24 September 2024
- Published by Cambridge University Press (CUP) in Journal of Fluid Mechanics
- Vol. 996, A3
Influence of thermal buoyancy on the wake dynamics of a heated square cylinder
Direct numerical simulation of the three-dimensional (3-D) wake transition of a heated square cylinder subjected to horizontal cross-flow is performed in the presence of buoyancy. In order to capture the effects of large-scale heating, a non-Oberbeck–Boussinesq model is utilized, which includes the governing equations for compressible gas flow. All computations are performed at low free stream Mach number $M=0.1$ using air (free stream Prandtl number, $Pr=0.71$ ) as the working fluid. The 3-D instability modes A and B, which correspond to free stream Reynolds numbers of 180 and 250, are observed with longer and shorter spanwise wavelengths, respectively, and the onset of three-dimensionality is triggered at a Reynolds number of 173. In the presence of buoyancy, baroclinic vorticity production in the near-wake plays an important role for streamwise vorticity generation. The chaotic wake of the Mode-A instability bifurcates into periodic and quasiperiodic wakes at various heating levels, expressed by the overheat ratio, $\varepsilon =(T_w-T_\infty )/T_\infty$ , where $T_w$ and $T_\infty$ are the temperature of the cylinder surface and the ambient air, respectively. At low heating ( $\varepsilon =0.2$ ), the 3-D Mode-A instability is suppressed leading to a two-dimensional wake flow. Further increase in heating, again brings back the three-dimensionality in the wake through Mode-E instability. The variation of thermophysical properties and the effective Reynolds number with increase in heating level around the cylinder is examined. It is shown that the effect of thermophysical properties competes with the baroclinic streamwise vorticity generation at higher levels of heating ( $\varepsilon \geqslant 0.4$ ) to control the 3-D modes and wake dynamics.- 24 September 2024
- Published by Cambridge University Press (CUP) in Journal of Fluid Mechanics
- Vol. 996, A3
Open AccessInfluence of thermal buoyancy on the wake dynamics of a heated square cylinder
Direct numerical simulation of the three-dimensional (3-D) wake transition of a heated square cylinder subjected to horizontal cross-flow is performed in the presence of buoyancy. In order to capture the effects of large-scale heating, a non-Oberbeck–Boussinesq model is utilized, which includes the governing equations for compressible gas flow. All computations are performed at low free stream Mach number $M=0.1$ using air (free stream Prandtl number, $Pr=0.71$ ) as the working fluid. The 3-D instability modes A and B, which correspond to free stream Reynolds numbers of 180 and 250, are observed with longer and shorter spanwise wavelengths, respectively, and the onset of three-dimensionality is triggered at a Reynolds number of 173. In the presence of buoyancy, baroclinic vorticity production in the near-wake plays an important role for streamwise vorticity generation. The chaotic wake of the Mode-A instability bifurcates into periodic and quasiperiodic wakes at various heating levels, expressed by the overheat ratio, $\varepsilon =(T_w-T_\infty )/T_\infty$ , where $T_w$ and $T_\infty$ are the temperature of the cylinder surface and the ambient air, respectively. At low heating ( $\varepsilon =0.2$ ), the 3-D Mode-A instability is suppressed leading to a two-dimensional wake flow. Further increase in heating, again brings back the three-dimensionality in the wake through Mode-E instability. The variation of thermophysical properties and the effective Reynolds number with increase in heating level around the cylinder is examined. It is shown that the effect of thermophysical properties competes with the baroclinic streamwise vorticity generation at higher levels of heating ( $\varepsilon \geqslant 0.4$ ) to control the 3-D modes and wake dynamics. - 24 February 2024
- Published by Springer Nature
- p. 131-140
Effect of Buoyancy on Three-Dimensional Flow Around a Heated Square Cylinder in Mixed Convection
- 24 February 2024
- Published by Springer Nature
- p. 131-140
Effect of Buoyancy on Three-Dimensional Flow Around a Heated Square Cylinder in Mixed Convection
- Open Access
- 1 October 2023
- Published by AIP Publishing in Physics of Fluids
- Vol. 35 (10)
Three-dimensional wake transition of a heated square cylinder in the presence of cross-buoyancy
The three-dimensional flow transition is examined in the wake of a heated square cylinder subjected to horizontal cross-flow perpendicular to gravity utilizing a direct numerical simulation approach. The surface of the square cylinder is heated uniformly to an elevated temperature Tw, and the amount of excess temperature is represented as the over-heat ratio ε=(Tw−T∞)/T∞, where T∞ represents the surrounding temperature. The effects of large-scale heating on the transport properties and thermal straining of the fluid particles are captured using an in-house non-Oberbeck–Boussinesq compressible model. The compressible flow governing equations (in a body-fitted coordinate system) are solved using a variant of flux-based particle velocity upwind-modified+ (PVU-M+) technique [Ahmad et al., “On the formation and sustenance of the compressible vortex rings in starting axisymmetric jets: A phenomenological approach,” Phys. Fluids 32, 126114 (2020)]. In this investigation, all computations are conducted at a low Mach number (Ma = 0.1) and air (Prandtl number, Pr = 0.71) is used as the working fluid. As the heating level rises, the shape and wavelength of the vortical structure undergo significant alterations. At Re = 250, the mode-B transition with a shorter spanwise wavelength and the mode-D transition with a longer wavelength are observed, respectively, for heating levels ε=0.0−0.2 and ε=0.8−1.0. Furthermore, for heating levels in the range 0.4≤ε≤0.6, an intermediate wavelength of the mode-E transition is detected. The temporal variation of fluid properties such as the force coefficient (CL, CD) and the Nusselt number (Nu) are shown at various heating levels. In addition, surface vorticity is examined in order to comprehend the flow dynamics near the surface of a heated square cylinder.
- 1 October 2023
- Published by AIP Publishing in Physics of Fluids
- Vol. 35 (10)
Open AccessThree-dimensional wake transition of a heated square cylinder in the presence of cross-buoyancy
The three-dimensional flow transition is examined in the wake of a heated square cylinder subjected to horizontal cross-flow perpendicular to gravity utilizing a direct numerical simulation approach. The surface of the square cylinder is heated uniformly to an elevated temperature Tw, and the amount of excess temperature is represented as the over-heat ratio ε=(Tw−T∞)/T∞, where T∞ represents the surrounding temperature. The effects of large-scale heating on the transport properties and thermal straining of the fluid particles are captured using an in-house non-Oberbeck–Boussinesq compressible model. The compressible flow governing equations (in a body-fitted coordinate system) are solved using a variant of flux-based particle velocity upwind-modified+ (PVU-M+) technique [Ahmad et al., “On the formation and sustenance of the compressible vortex rings in starting axisymmetric jets: A phenomenological approach,” Phys. Fluids 32, 126114 (2020)]. In this investigation, all computations are conducted at a low Mach number (Ma = 0.1) and air (Prandtl number, Pr = 0.71) is used as the working fluid. As the heating level rises, the shape and wavelength of the vortical structure undergo significant alterations. At Re = 250, the mode-B transition with a shorter spanwise wavelength and the mode-D transition with a longer wavelength are observed, respectively, for heating levels ε=0.0−0.2 and ε=0.8−1.0. Furthermore, for heating levels in the range 0.4≤ε≤0.6, an intermediate wavelength of the mode-E transition is detected. The temporal variation of fluid properties such as the force coefficient (CL, CD) and the Nusselt number (Nu) are shown at various heating levels. In addition, surface vorticity is examined in order to comprehend the flow dynamics near the surface of a heated square cylinder.