Eleni Garmpi
Research Subjects
Research Interests
Eleni Garmpi has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- Athena Tsetsekou
School of Mining Engineering and Metallurgy, National Technical University of Athens, Zografou Campus, 15780 Athens, Greece
1 shared publication - Constantina‐Dia Andreouli
Materials Industrial Research and Technology Center S.A. Schimatari Greece
1 shared publication - Diana Baciu
National Center for Scientific Research “Demokritos”, GR-15341 Ag. Paraskevi Attikis, Greece
1 shared publication - Eleni Roussi
School of Mining and Metallurgical Engineering, National Technical University of Athens, 15780 Athens, Greece
1 shared publication - Konstantinos Dimitriadis
Division of Dental Technology, Department of Biomedical Sciences, University of West Attica, 122 43 Athens, Greece
1 shared publication
Latest Publications
- 6 November 2023
- Published by Wiley in International Journal of Applied Ceramic Technology
- Vol. 21 (2) , 702-714
Evaluation of robocasting process in the layering of dental feldspathic porcelain in metal‐ceramic restorations
The objective of the present in vitro study was to evaluate the robocasting process for the fabrication of metal‐ceramic dental restorations, according to ISO 9693. In this work, the rheological properties of dental porcelain pastes doped with organic additives and the parameters of robocasting process were determined, and the microstructural and physical‐mechanical characterization of the sintered material were performed. Subsequently, the suitability of the robocasting process for the production of metal‐ceramic dental restorations was evaluated. Results revealed that the dental feldspathic porcelain specimens, prepared by robocasting process, exhibited a homogeneous and dense microstructure with little or no microporosity, and the measured mechanical properties point towards good performance in oral cavity. The metal‐ceramic bonds produced by the robocasting process have markedly higher strength values than the minimum value of 25 MPa, required by ISO 9693, with a cohesive failure mode.
- 6 November 2023
- Published by Wiley in International Journal of Applied Ceramic Technology
- Vol. 21 (2) , 702-714
Evaluation of robocasting process in the layering of dental feldspathic porcelain in metal‐ceramic restorations
The objective of the present in vitro study was to evaluate the robocasting process for the fabrication of metal‐ceramic dental restorations, according to ISO 9693. In this work, the rheological properties of dental porcelain pastes doped with organic additives and the parameters of robocasting process were determined, and the microstructural and physical‐mechanical characterization of the sintered material were performed. Subsequently, the suitability of the robocasting process for the production of metal‐ceramic dental restorations was evaluated. Results revealed that the dental feldspathic porcelain specimens, prepared by robocasting process, exhibited a homogeneous and dense microstructure with little or no microporosity, and the measured mechanical properties point towards good performance in oral cavity. The metal‐ceramic bonds produced by the robocasting process have markedly higher strength values than the minimum value of 25 MPa, required by ISO 9693, with a cohesive failure mode.