Valerio Lupi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Valerio Lupi has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Philipp Schlatter
Department of Engineering Mechanics, KTH Royal Institute of Technology, Stockholm, Sweden
3 shared publications - Adam Peplinski
KTH Royal Institute of Technology
2 shared publications - Daniele Massaro
Massachusetts Institute of Technology
2 shared publications Dan S. Henningson
FLOW Turbulence Laboratory, Department of Engineering Mechanics, KTH Royal Institute of Technology, SE-100 44 Stockholm, Sweden
1 shared publication- Enrico Rinaldi
Linné FLOW Centre KTH Mechanics Royal Institute of Technology SE-100 44 Stockholm Sweden
1 shared publication - J. Simon Kern
FLOW Turbulence Laboratory, Department of Engineering Mechanics, KTH Royal Institute of Technology, SE-100 44 Stockholm, Sweden
1 shared publication
Latest Publications
- Open Access
- 14 November 2025
- Published by American Physical Society (APS) in Physical Review Fluids
- Vol. 10 (11)
Swirl switching in spatially developing bent pipes
Swirl switching refers to the temporal rotation of the plane of symmetry of the cross-sectional vortices about the equatorial plane of the curved pipe and may induce significant vibrations in piping systems. The origin of this phenomenon is not yet understood, and its relationship with turbulent fluctuations in the upstream straight section is still debated in the literature. To assess the effect of upstream turbulence, direct numerical simulations are performed for spatially developing bent pipe flows under both laminar and turbulent inflow conditions. Additionally, the influence of the bending angle on swirl switching and time-averaged flow characteristics is investigated. Proper orthogonal decomposition (POD) is applied to three-dimensional velocity fields to extract spatially coherent structures responsible for swirl switching. The phenomenon is observed for both inlet velocity profiles and bending angles, although it does not correspond to the dominant mode in the case of laminar inflow conditions. A reduced-order reconstruction using the most energetically relevant antisymmetric POD modes indicates a link between swirl switching and the shear layer within the bend. We therefore infer that swirl switching could arise because of a symmetry-breaking shear layer instability, representing a stage in the bifurcation cascade that leads to turbulence.
- 14 November 2025
- Published by American Physical Society (APS) in Physical Review Fluids
- Vol. 10 (11)
Open AccessSwirl switching in spatially developing bent pipes
Swirl switching refers to the temporal rotation of the plane of symmetry of the cross-sectional vortices about the equatorial plane of the curved pipe and may induce significant vibrations in piping systems. The origin of this phenomenon is not yet understood, and its relationship with turbulent fluctuations in the upstream straight section is still debated in the literature. To assess the effect of upstream turbulence, direct numerical simulations are performed for spatially developing bent pipe flows under both laminar and turbulent inflow conditions. Additionally, the influence of the bending angle on swirl switching and time-averaged flow characteristics is investigated. Proper orthogonal decomposition (POD) is applied to three-dimensional velocity fields to extract spatially coherent structures responsible for swirl switching. The phenomenon is observed for both inlet velocity profiles and bending angles, although it does not correspond to the dominant mode in the case of laminar inflow conditions. A reduced-order reconstruction using the most energetically relevant antisymmetric POD modes indicates a link between swirl switching and the shear layer within the bend. We therefore infer that swirl switching could arise because of a symmetry-breaking shear layer instability, representing a stage in the bifurcation cascade that leads to turbulence.
- Open Access
- 24 May 2024
- Published by Cambridge University Press (CUP) in Journal of Fluid Mechanics
- Vol. 987, A40
Modal stability analysis of toroidal pipe flow approaching zero curvature
The present study investigates the modal stability of the steady incompressible flow inside a toroidal pipe for values of the curvature $\delta$ (ratio between pipe and torus radii) approaching zero, i.e. the limit of a straight pipe. The global neutral stability curve for $10^{-7} \leq \delta \leq ~10^{-2}$ is traced using a continuation algorithm. Two different families of unstable eigenmodes are identified. For curvatures below $1.5 \times 10^{-6}$ , the critical Reynolds number ${{Re}}_{cr}$ is proportional to $\delta ^{-1/2}$ . Hence, the critical Dean number is constant, ${{De}}_{cr} = 2\,{{Re}}_{cr}\,\sqrt {\delta } \approx 113$ . This behaviour confirms that the Hagen–Poiseuille flow is stable to infinitesimal perturbations for any Reynolds number and suggests that a continuous transition from the curved to the straight pipe takes place as far as it regards the stability properties. For low values of the curvature, an approximate self-similar solution for the steady base flow can be obtained at a fixed Dean number. Exploiting the proposed semi-analytic scaling in the stability analysis provides satisfactory results.- 24 May 2024
- Published by Cambridge University Press (CUP) in Journal of Fluid Mechanics
- Vol. 987, A40
Open AccessModal stability analysis of toroidal pipe flow approaching zero curvature
The present study investigates the modal stability of the steady incompressible flow inside a toroidal pipe for values of the curvature $\delta$ (ratio between pipe and torus radii) approaching zero, i.e. the limit of a straight pipe. The global neutral stability curve for $10^{-7} \leq \delta \leq ~10^{-2}$ is traced using a continuation algorithm. Two different families of unstable eigenmodes are identified. For curvatures below $1.5 \times 10^{-6}$ , the critical Reynolds number ${{Re}}_{cr}$ is proportional to $\delta ^{-1/2}$ . Hence, the critical Dean number is constant, ${{De}}_{cr} = 2\,{{Re}}_{cr}\,\sqrt {\delta } \approx 113$ . This behaviour confirms that the Hagen–Poiseuille flow is stable to infinitesimal perturbations for any Reynolds number and suggests that a continuous transition from the curved to the straight pipe takes place as far as it regards the stability properties. For low values of the curvature, an approximate self-similar solution for the steady base flow can be obtained at a fixed Dean number. Exploiting the proposed semi-analytic scaling in the stability analysis provides satisfactory results. - Open Access
- 9 April 2024
- Published by American Physical Society (APS) in Physical Review Fluids
- Vol. 9 (4) , 043906
Floquet stability analysis of pulsatile flow in toroidal pipes
The linear temporal stability of the fully developed pulsatile flow in a torus with high curvature is investigated using Floquet theory. The baseflow is computed via a Newton-Raphson iteration in frequency space to obtain basic states at supercritical Reynolds numbers in the steady case for two curvatures, and 0.3, exhibiting structurally different linear instabilities for the steady flow. The addition of a pulsatile component is found to be overall stabilizing over a wide range of pulsation amplitudes, in particular for high values of curvature. The pulsatile flows are found to be at most transiently stable with large intracyclic growth rate variations even at small pulsation amplitudes. While these growth rates are likely insufficient to trigger an abrupt transition at the parameters in this work, the trends indicate that this is indeed likely for higher pulsation amplitudes, similar to pulsatile flow in straight pipes. At the edge of the considered parameter range, subharmonic eigenvalue orbits in the local spectrum of the time-periodic operator, recently found in pulsating channel flow, have been confirmed also for pulsatile flow in toroidal pipes, underlining the generality of this phenomenon.- 9 April 2024
- Published by American Physical Society (APS) in Physical Review Fluids
- Vol. 9 (4) , 043906
Open AccessFloquet stability analysis of pulsatile flow in toroidal pipes
The linear temporal stability of the fully developed pulsatile flow in a torus with high curvature is investigated using Floquet theory. The baseflow is computed via a Newton-Raphson iteration in frequency space to obtain basic states at supercritical Reynolds numbers in the steady case for two curvatures, and 0.3, exhibiting structurally different linear instabilities for the steady flow. The addition of a pulsatile component is found to be overall stabilizing over a wide range of pulsation amplitudes, in particular for high values of curvature. The pulsatile flows are found to be at most transiently stable with large intracyclic growth rate variations even at small pulsation amplitudes. While these growth rates are likely insufficient to trigger an abrupt transition at the parameters in this work, the trends indicate that this is indeed likely for higher pulsation amplitudes, similar to pulsatile flow in straight pipes. At the edge of the considered parameter range, subharmonic eigenvalue orbits in the local spectrum of the time-periodic operator, recently found in pulsating channel flow, have been confirmed also for pulsatile flow in toroidal pipes, underlining the generality of this phenomenon. - Open Access
- 20 November 2023
- Published by American Physical Society (APS) in Physical Review Fluids
- Vol. 8 (11) , 113903
Global stability of -bend pipe flow with mesh adaptivityThe global stability of the flow in a spatially developing -bend pipe with curvature is investigated by performing direct numerical simulations to understand the underlying transitional mechanism. A unique application of the adaptive mesh refinement technique is used during the stability analysis for minimizing the interpolation and quadrature errors. Independent meshes are created for the direct and adjoint solutions, as well as for the base flow extracted via selective frequency damping. The spectrum of the linearized Navier-Stokes operator reveals a pair of complex conjugate eigenvalues, with frequency . Therefore, the transition is attributed to a Hopf bifurcation that takes place at . A structural sensitivity analysis is performed by extracting the wavemaker. We identify the primary source of instability located on the outer wall, downstream of the bend inlet. This region corresponds to the separation bubble on the outer wall. We thus conclude that the instability is caused by the strong shear resulting from the backflow, similar to the -bend pipe flow. We believe that understanding the stability mechanism and characterizing the base flow in bent pipes is crucial for studying various biological flows, like blood vessels. Hence, this paper aims to close the knowledge gap between a -bend and toroidal pipes by investigating the transition nature in a -bend pipe flow.- 20 November 2023
- Published by American Physical Society (APS) in Physical Review Fluids
- Vol. 8 (11) , 113903
Open AccessGlobal stability of -bend pipe flow with mesh adaptivityThe global stability of the flow in a spatially developing -bend pipe with curvature is investigated by performing direct numerical simulations to understand the underlying transitional mechanism. A unique application of the adaptive mesh refinement technique is used during the stability analysis for minimizing the interpolation and quadrature errors. Independent meshes are created for the direct and adjoint solutions, as well as for the base flow extracted via selective frequency damping. The spectrum of the linearized Navier-Stokes operator reveals a pair of complex conjugate eigenvalues, with frequency . Therefore, the transition is attributed to a Hopf bifurcation that takes place at . A structural sensitivity analysis is performed by extracting the wavemaker. We identify the primary source of instability located on the outer wall, downstream of the bend inlet. This region corresponds to the separation bubble on the outer wall. We thus conclude that the instability is caused by the strong shear resulting from the backflow, similar to the -bend pipe flow. We believe that understanding the stability mechanism and characterizing the base flow in bent pipes is crucial for studying various biological flows, like blood vessels. Hence, this paper aims to close the knowledge gap between a -bend and toroidal pipes by investigating the transition nature in a -bend pipe flow.