Minghan Li
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Minghan Li has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Hong Jiang
State Key Laboratory of Tropic Ocean Engineering Materials and Materials Evaluation & Special Glass Key Laboratory of Hainan Province, Hainan University, Haikou 570228, China
2 shared publications - Yanping Ma
State Key Laboratory of Marine Resources Utilization in South China Sea, Hainan University, Haikou 570228, China
2 shared publications - Jiaqi Duan
State Key Laboratory of Marine Resources Utilization in South China Sea & Special Glass Key Laboratory of Hainan Province, Hainan University, Haikou 570228, China
1 shared publication - Lingqi Kong
School of Physics and Optoelectronic Engineering, Hainan University, Haikou 570228, China
1 shared publication - Wenzhi Wang
State Key Laboratory of Marine Resources Utilization in South China Sea & Special Glass Key Lab of Hainan Province, Hainan University, Haikou 570228, China
1 shared publication - Ziming Huang
State Key Laboratory of Marine Resources Utilization in South China Sea & Special Glass Key Laboratory of Hainan Province, Hainan University, Haikou 570228, China
1 shared publication
Latest Publications
- Open Access
Effect of SiO2 Layer Thickness on SiO2/Si3N4 Multilayered Thin Films
Silicon nitride (Si3N4) materials are widely used in the electronics, optoelectronics, and semiconductor industries, with Si3N4 thin films exhibiting high densities, high dielectric constants, good insulation performance, and good thermal and chemical stability. However, direct deposition of Si3N4 thin films on glass can result in considerable tensile stress and cracking. In this study, magnetron sputtering was used to deposit a Si3N4 thin film on glass, and a silicon dioxide (SiO2) thin film was introduced to reduce the Si3N4 binding force and stress. The effect of the SiO2 layer thickness on the SiO2/Si3N4 multilayered thin film was explored. The results indicated that the introduction of the SiO2 layer could improve the weak adhesion characteristics of Si3N4 thin films. Moreover, sputtering the SiO2 layer to 150 nm resulted in the highest hardness and transmittance of the SiO2/Si3N4 multilayered thin films. The findings of this study lay a solid foundation for the application of Si3N4 thin films on glass.
Open AccessEffect of SiO2 Layer Thickness on SiO2/Si3N4 Multilayered Thin Films
Silicon nitride (Si3N4) materials are widely used in the electronics, optoelectronics, and semiconductor industries, with Si3N4 thin films exhibiting high densities, high dielectric constants, good insulation performance, and good thermal and chemical stability. However, direct deposition of Si3N4 thin films on glass can result in considerable tensile stress and cracking. In this study, magnetron sputtering was used to deposit a Si3N4 thin film on glass, and a silicon dioxide (SiO2) thin film was introduced to reduce the Si3N4 binding force and stress. The effect of the SiO2 layer thickness on the SiO2/Si3N4 multilayered thin film was explored. The results indicated that the introduction of the SiO2 layer could improve the weak adhesion characteristics of Si3N4 thin films. Moreover, sputtering the SiO2 layer to 150 nm resulted in the highest hardness and transmittance of the SiO2/Si3N4 multilayered thin films. The findings of this study lay a solid foundation for the application of Si3N4 thin films on glass.
- Open Access
Microstructure, Dielectric Properties and Bond Characteristics of Lithium Aluminosilicate Glass-Ceramics with Various Li/Na Molar Ratio
The advent of 5G technology presented new challenges regarding the high-frequency characteristics of electrical signals and their impact on the cover glass properties of electronic devices. This study aimed to analyze the effect of the Li/Na molar ratio on the dielectric and mechanical properties, as well as the structural characteristics, of lithium aluminosilicate glass-ceramics. Using the melting method, we prepared lithium aluminosilicate base glasses and subsequently crystallized them by adjusting the molar ratio. XRD and TEM analyses were employed to investigate the resultant structures and crystal formation in the five base glasses. It was observed that Li2Si2O5 and LiAlSi4O10 crystals precipitated, exhibiting varying degrees of crystallinity and crystal ratios. Through a comparison of dielectric properties before and after crystallization, it was found that the dielectric constants of the glass-ceramics were consistently reduced. This decrease can be attributed to the lower dielectric constants exhibited by both crystalline phases compared to the parent lithium aluminosilicate glasses. Furthermore, the presence of glass crystals effectively immobilized the alkali metal ions within the glass phase, impeding their movement under an electric field. Consequently, the dielectric loss value of the glass-ceramics decreased with the increasing amount of precipitated crystals. By carefully adjusting the composition and optimizing the crystallization process, we successfully produced lithium aluminosilicate glass-ceramics, demonstrating excellent mechanical and optical properties, coupled with low dielectric properties.
Open AccessMicrostructure, Dielectric Properties and Bond Characteristics of Lithium Aluminosilicate Glass-Ceramics with Various Li/Na Molar Ratio
The advent of 5G technology presented new challenges regarding the high-frequency characteristics of electrical signals and their impact on the cover glass properties of electronic devices. This study aimed to analyze the effect of the Li/Na molar ratio on the dielectric and mechanical properties, as well as the structural characteristics, of lithium aluminosilicate glass-ceramics. Using the melting method, we prepared lithium aluminosilicate base glasses and subsequently crystallized them by adjusting the molar ratio. XRD and TEM analyses were employed to investigate the resultant structures and crystal formation in the five base glasses. It was observed that Li2Si2O5 and LiAlSi4O10 crystals precipitated, exhibiting varying degrees of crystallinity and crystal ratios. Through a comparison of dielectric properties before and after crystallization, it was found that the dielectric constants of the glass-ceramics were consistently reduced. This decrease can be attributed to the lower dielectric constants exhibited by both crystalline phases compared to the parent lithium aluminosilicate glasses. Furthermore, the presence of glass crystals effectively immobilized the alkali metal ions within the glass phase, impeding their movement under an electric field. Consequently, the dielectric loss value of the glass-ceramics decreased with the increasing amount of precipitated crystals. By carefully adjusting the composition and optimizing the crystallization process, we successfully produced lithium aluminosilicate glass-ceramics, demonstrating excellent mechanical and optical properties, coupled with low dielectric properties.