YMYanping Ma

Yanping Ma

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Yanping Ma has a total of 19 co-authors. Here are the top co-authors by number of shared publications:

  • Hong Jiang

    State Key Laboratory of Tropic Ocean Engineering Materials and Materials Evaluation & Special Glass Key Laboratory of Hainan Province, Hainan University, Haikou 570228, China

    7 shared publications
  • Wenzhi Wang

    State Key Laboratory of Marine Resources Utilization in South China Sea & Special Glass Key Lab of Hainan Province, Hainan University, Haikou 570228, China

    3 shared publications
  • Chunrong Xiong

    State Key Laboratory of Marine Resources Utilization in South China Sea, Hainan University, Haikou 570228, China

    2 shared publications
  • Jiaqi Duan

    State Key Laboratory of Marine Resources Utilization in South China Sea & Special Glass Key Laboratory of Hainan Province, Hainan University, Haikou 570228, China

    2 shared publications
  • Minghan Li

    Special Glass Key Lab of Hainan Province & State Key Laboratory of Marine Resource Utilization in South China Sea, Hainan University, Haikou 570228, China

    2 shared publications
  • Minghan Li

    State Key Laboratory of Marine Resources Utilization in South China Sea & Special Glass Key Laboratory of Hainan Province, Hainan University, Haikou 570228, China

    2 shared publications

Latest Publications

  • Open Access

    Effect of SiO2 Layer Thickness on SiO2/Si3N4 Multilayered Thin Films

    by Ziming Huang, Jiaqi Duan, Minghan Li, Yanping Ma, Hong Jiang

    Silicon nitride (Si3N4) materials are widely used in the electronics, optoelectronics, and semiconductor industries, with Si3N4 thin films exhibiting high densities, high dielectric constants, good insulation performance, and good thermal and chemical stability. However, direct deposition of Si3N4 thin films on glass can result in considerable tensile stress and cracking. In this study, magnetron sputtering was used to deposit a Si3N4 thin film on glass, and a silicon dioxide (SiO2) thin film was introduced to reduce the Si3N4 binding force and stress. The effect of the SiO2 layer thickness on the SiO2/Si3N4 multilayered thin film was explored. The results indicated that the introduction of the SiO2 layer could improve the weak adhesion characteristics of Si3N4 thin films. Moreover, sputtering the SiO2 layer to 150 nm resulted in the highest hardness and transmittance of the SiO2/Si3N4 multilayered thin films. The findings of this study lay a solid foundation for the application of Si3N4 thin films on glass.


  • Open Access

    Kinetic analysis of the crystallization of Y 2 O 3 and La 2 O 3 doped Li 2 O–Al 2 O 3 –SiO 2 glass

    by Tao Zheng, Minghan Li, Yanping Ma, Hong Jiang

    Li2O–Al2O3–SiO2 (LAS) glass ceramics have a low coefficient of thermal expansion, high mechanical strength, and excellent chemical stability. With advancements in glass ceramics, researchers have explored using LAS glass ceramics with transition metal doping and rare earth doping. Most previous studies have studied the impact of rare earth element doping on crystallization primarily in the context of conventional nucleating agents present in glass. In this study, we aimed to investigate the impact of Y2O3 and La2O3 on LAS glasses in the presence of undoped nucleating agents. The crystallization mechanism of La2O3 and Y2O3 doped LAS glass ceramics was studied using differential scanning calorimetry. The crystallization kinetics of the glasses were analyzed using model-free and modeling methods. Moreover, the activation energy of crystallization and the indices of crystallization and growth of glass ceramics were calculated, and the crystalline phase and microstructure of the samples were characterized. All three fractions of the LAS glass showed consistent crystallization under different calculation methods. The glass doped with La2O3 and Y2O3 exhibited two- or three-dimensional growth during crystallization, promoting crystallization in the LAS glass. The Y3La0 sample demonstrated the most favorable crystallization effect. In the presence of an undoped nucleating agent, rare earth elements can enhance glass crystallization; this new idea can be utilized for the development of new materials.


  • Open Access

    Microstructure, Dielectric Properties and Bond Characteristics of Lithium Aluminosilicate Glass-Ceramics with Various Li/Na Molar Ratio

    by Minghan Li, Lingqi Kong, Wenzhi Wang, Yanping Ma, Hong Jiang

    The advent of 5G technology presented new challenges regarding the high-frequency characteristics of electrical signals and their impact on the cover glass properties of electronic devices. This study aimed to analyze the effect of the Li/Na molar ratio on the dielectric and mechanical properties, as well as the structural characteristics, of lithium aluminosilicate glass-ceramics. Using the melting method, we prepared lithium aluminosilicate base glasses and subsequently crystallized them by adjusting the molar ratio. XRD and TEM analyses were employed to investigate the resultant structures and crystal formation in the five base glasses. It was observed that Li2Si2O5 and LiAlSi4O10 crystals precipitated, exhibiting varying degrees of crystallinity and crystal ratios. Through a comparison of dielectric properties before and after crystallization, it was found that the dielectric constants of the glass-ceramics were consistently reduced. This decrease can be attributed to the lower dielectric constants exhibited by both crystalline phases compared to the parent lithium aluminosilicate glasses. Furthermore, the presence of glass crystals effectively immobilized the alkali metal ions within the glass phase, impeding their movement under an electric field. Consequently, the dielectric loss value of the glass-ceramics decreased with the increasing amount of precipitated crystals. By carefully adjusting the composition and optimizing the crystallization process, we successfully produced lithium aluminosilicate glass-ceramics, demonstrating excellent mechanical and optical properties, coupled with low dielectric properties.


  • Open Access

    Preparation and Performance of Multilayer Si-B-C-N/Diamond-like Carbon Gradient Films

    by Jiaqi Duan, Minghan Li, Wenzhi Wang, Ziming Huang, Hong Jiang, Yanping Ma

    Si-B-C-N/diamond-like carbon (DLC) gradient films with different layers were prepared on a glass substrate by radio frequency magnetron sputtering, and the structure and surface morphology of the resulting films were analyzed by scanning electron microscopy, Raman spectrometry, and X-ray photoelectron spectroscopy. The mechanical and optical properties of the films were studied using a multifunctional material mechanical testing system, UV-Vis spectrophotometer, and micro-Vickers hardness tester. The gradient structure promotes the formation of sp3 bonds and improves the hardness and optical transmittance of the resulting films. Among the prepared films, the single-layer Si-B-C-N/DLC gradient film shows the highest optical transmittance (97%). Film–substrate adherence is strengthened by the introduction of the gradient structure. The best adhesion was obtained with a double-layer Si-B-C-N/DLC gradient film. Suitable anti-wear properties were exhibited in both dry (0.18) and wet (0.07) conditions. In this paper, evaluation of the microstructural, optical, and mechanical properties of the films could provide new insights into improvements in the bonding force of glass-based DLC films and enrich the experimental data of DLC multilayer film systems.


  • Open Access

    Light-Transmitting Lithium Aluminosilicate Glass-Ceramics with Excellent Mechanical Properties Based on Cluster Model Design

    by Minghan Li, Chuang Dong, Yanping Ma, Hong Jiang

    In this study, for the first time, a cluster-plus-glue-atom model was used to optimize the composition of lithium aluminosilicate glass-ceramics. Basic glass in glass-ceramics was considered to be a 16-unit combination of three-valence {M2O3} and one-valence {Li2O} units. By adjusting the ratio of {M2O3} and {Li2O}, the composition of basic glass could be optimized. After optimization, the average cation valence of the base glass was increased to 2.875. After heat treatment of the optimized base glass, it is found that the crystal size, proportion, and crystallinity changed obviously compared with that before optimization. The main crystalline phases of all the lithium aluminosilicate glass-ceramics prepared in this work were Li2Si2O5 and LiAlSi4O10. All optimized glass-ceramics had an obvious improvement in the crystallinity, with one of the largest having a crystallinity of over 90%. Furthermore, its bending strength was 159 MPa, the microhardness was 967 Hv, and the visible light transmission rate exceeded 90%. Compared with the widely used touch panel cover glass, the optical properties were close, and the mechanical properties were greatly improved. Due to its excellent performance, it could be used in microelectronics, aerospace, deep-sea exploration, and other fields.


  • Open Access

    Study on Crystallization Process of Li2O–Al2O3–SiO2 Glass-Ceramics Based on In Situ Analysis

    by Minghan Li, Chunrong Xiong, Yanping Ma, Hong Jiang

    In this paper, we used differential scanning calorimetry (DSC), high-temperature X-ray diffraction (HT-XRD), and confocal scanning laser microscopy (CSLM) to investigate the Li2O–Al2O3–SiO2 glass crystallization process. At 943 K, lithium disilicate (Li2Si2O5) phase crystals began to precipitate in the Li2O–Al2O3–SiO2 glass with a crystal size of 50–70 nm. At the temperature of 1009 K, petalite (LiAlSi4O10) crystals began to precipitate in the vitreous phase, forming composite spherical crystals of LiAlSi4O10 and Li2Si2O5 with size in the range of 90–130 nm. Furthermore, the Kissinger method and KAS method of the JMAK model were used to calculate the crystallization activation energy and the Avrami index “n”. It was found that the precipitation mechanism of the two kinds of crystals is whole crystallization; accordingly, the selection of crystallization heat treatment system was guided to determine the nucleation and crystallization temperature.


  • Open Access

    Network Structure and Properties of Lithium Aluminosilicate Glass

    by Shoujia Huang, Wenzhi Wang, Hong Jiang, Huifeng Zhao, Yanping Ma

    Based on lithium aluminosilicate glass, the composition of glass was optimized by replacing SiO2 with B2O3, and the influence of glass composition on structure and performance was studied. With the increase in B2O3 concentrations from 0 to 6.5 mol%, Al2O3 always existed in the form of four-coordinated [AlO4] in the network structure, and B2O3 mainly entered the network in the form of four-coordinated [BO4]. The content of Si-O-Si linkages (Q4(0Al)) was always dominant. The incorporation of boron oxide improved the overall degree of polymerization and connectivity of the lithium aluminosilicate glass network structure. An increase in the degree of network polymerization led to a decrease in the thermal expansion coefficient of the glass and an increase in Vickers hardness and density. The durability of the glass in hydrofluoric acid and NaOH and KOH solutions was enhanced overall.


  • Molecule-like structural units in silicate-glass-forming oxides

    by Fa-Qi Wan, Yan-Ping Ma, Dan-Dan Dong, Wan-Yu Ding, Hong Jiang, Chuang Dong, Jian-Xiong He

    本文引入团簇加连接原子模型来解析硅酸盐玻璃相关氧化物的结构, 并给出了这些氧化物的最小结构单元——类分子结构单元. 参与网络形成体的氧化物主要以三角形或者四面体的配位体形式存在, 构建玻璃的三维网络状骨架. 如基础的网络形成体SiO2, 其类分子结构单元团簇式是为[Si-O4]Si, 含有的价电子数为32, 形成四面体网络. 中间体以同时形成八面体和四面体为特征, 网络外体则以立方体和八面体为主. 经证实, 这些类分子结构单元无一例外, 均满足八电子规则(即每个结构单元所含的价电子总数为8的整数倍), 具有分子的属性. 玻璃中氧化物类分子结构单元概念的提出, 将为后续的玻璃成分设计工作打下基础.