Anton Harrer
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Anton Harrer has a total of 25 co-authors. Here are the top co-authors by number of shared publications:
- Andreas Görling
Lehrstuhl für Theoretische Chemie, Universität Erlangen-Nürnberg 1 , Egerlandstr. 3, D-91058 Erlangen
2 shared publications - Christian Papp
Angewandte Physikalische Chemie Freie Universität Berlin Arnimallee 22 14195 Berlin Germany
2 shared publications - Eva Marie Freiberger
Physikalische Chemie II Friedrich-Alexander-Universität Erlangen-Nürnberg Egerlandstr. 3 91058 Erlangen Germany
2 shared publications - Felix Hemauer
Lehrstuhl für Physikalische Chemie II Friedrich-Alexander-Universität Erlangen-Nürnberg Egerlandstr. 3 91058 Erlangen Germany
2 shared publications - Hans-Peter Steinrück
Lehrstuhl für Physikalische Chemie 2 Friedrich‐Alexander‐Universität Erlangen‐Nürnberg Erlangen Germany
2 shared publications - Julien Steffen
Lehrstuhl für Theoretische Chemie Friedrich‐Alexander‐Universität Erlangen‐Nürnberg Egerlandstr. 3 91058 Erlangen Germany
2 shared publications
Latest Publications
- Open Access
- 27 January 2025
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 129 (5) , 2441-2452
Naphthalene Decomposition on Fe(110)─Adsorption, Dehydrogenation, Surface Carbon Formation and the Influence of Coadsorbed Oxygen
Tar is an undesirable byproduct of biomass gasification, which can be removed through catalytic reforming to syngas components. Iron is a promising, abundant alternative to highly active but toxic nickel catalysts. The results observed so far in catalytic studies with iron have been mixed. In this paper, the decomposition of naphthalene, a representative model compound of tar, was studied on the catalytic Fe(110) surface using temperature-programmed desorption (TPD), sum frequency generation spectroscopy (SFG), and X-ray photoelectron spectroscopy (XPS). Napthalene adsorption, dehydrogenation and the formation of surface carbon were investigated, as well as the influence of oxygen. In comparison with previous studies on Ni(111), a similar dehydrogenation activity was found for Fe(110) with two main H2 TPD peaks at 450 and 550 K. The reaction of naphthalene on Fe(110) resulted in the predominant formation of carbidic and atomically adsorbed carbon on the surface, which did not dissolve into the bulk even at high temperatures. A moderately carbon-covered surface was shown to still be active toward naphthalene decomposition. Similarly to Ni(111), large amounts of oxygen inhibited the reaction but, at low oxygen doses, very high hydrogen yields were observed, suggesting that Fe(110) could be a valid alternative for tar decomposition.
- 27 January 2025
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 129 (5) , 2441-2452
Open AccessNaphthalene Decomposition on Fe(110)─Adsorption, Dehydrogenation, Surface Carbon Formation and the Influence of Coadsorbed Oxygen
Tar is an undesirable byproduct of biomass gasification, which can be removed through catalytic reforming to syngas components. Iron is a promising, abundant alternative to highly active but toxic nickel catalysts. The results observed so far in catalytic studies with iron have been mixed. In this paper, the decomposition of naphthalene, a representative model compound of tar, was studied on the catalytic Fe(110) surface using temperature-programmed desorption (TPD), sum frequency generation spectroscopy (SFG), and X-ray photoelectron spectroscopy (XPS). Napthalene adsorption, dehydrogenation and the formation of surface carbon were investigated, as well as the influence of oxygen. In comparison with previous studies on Ni(111), a similar dehydrogenation activity was found for Fe(110) with two main H2 TPD peaks at 450 and 550 K. The reaction of naphthalene on Fe(110) resulted in the predominant formation of carbidic and atomically adsorbed carbon on the surface, which did not dissolve into the bulk even at high temperatures. A moderately carbon-covered surface was shown to still be active toward naphthalene decomposition. Similarly to Ni(111), large amounts of oxygen inhibited the reaction but, at low oxygen doses, very high hydrogen yields were observed, suggesting that Fe(110) could be a valid alternative for tar decomposition.
- 16 November 2023
- Published by Wiley in Chemphyschem
- Vol. 24 (22)
Cover Feature: Bromine Adsorption and Thermal Stability on Rh(111): A Combined XPS, LEED and DFT Study (ChemPhysChem 22/2023)
- 16 November 2023
- Published by Wiley in Chemphyschem
- Vol. 24 (22)
Cover Feature: Bromine Adsorption and Thermal Stability on Rh(111): A Combined XPS, LEED and DFT Study (ChemPhysChem 22/2023)
- Open Access
- 19 September 2023
- Published by Wiley in Chemphyschem
- Vol. 24 (22) , e202300510
Bromine Adsorption and Thermal Stability on Rh(111): A Combined XPS, LEED and DFT Study
This study addresses a fundamental question in surface science: the adsorption of halogens on metal surfaces. Using synchrotron radiation‐based high‐resolution X‐ray photoelectron spectroscopy (XPS), temperature‐programmed XPS, low‐energy electron diffraction (LEED) and density functional theory (DFT) calculations, we investigated the adsorption and thermal stability of bromine on Rh(111) in detail. The adsorption of elemental bromine on Rh(111) at 170 K was followed in situ by XPS in the Br 3d region, revealing two individual, coverage‐dependent species, which we assign to fcc hollow‐ and bridge‐bound atomic bromine. In addition, we find a significant shift in binding energy upon increasing coverage due to adsorbate‐adsorbate interactions. Subsequent heating shows a high thermal stability of bromine on Rh(111) up to above 1000 K, indicating strong covalent bonding. To complement the XPS data, LEED was used to study the long‐range order of bromine on Rh(111): we observe a (√3×√3)R30° structure for low coverages (≤0.33 ML) and a star‐shaped compression structure for higher coverages (0.33–0.43 ML). Combining LEED and DFT calculations, we were able to visualize bromine adsorption on Rh(111) in real space for varying coverages.
- 19 September 2023
- Published by Wiley in Chemphyschem
- Vol. 24 (22) , e202300510
Open AccessBromine Adsorption and Thermal Stability on Rh(111): A Combined XPS, LEED and DFT Study
This study addresses a fundamental question in surface science: the adsorption of halogens on metal surfaces. Using synchrotron radiation‐based high‐resolution X‐ray photoelectron spectroscopy (XPS), temperature‐programmed XPS, low‐energy electron diffraction (LEED) and density functional theory (DFT) calculations, we investigated the adsorption and thermal stability of bromine on Rh(111) in detail. The adsorption of elemental bromine on Rh(111) at 170 K was followed in situ by XPS in the Br 3d region, revealing two individual, coverage‐dependent species, which we assign to fcc hollow‐ and bridge‐bound atomic bromine. In addition, we find a significant shift in binding energy upon increasing coverage due to adsorbate‐adsorbate interactions. Subsequent heating shows a high thermal stability of bromine on Rh(111) up to above 1000 K, indicating strong covalent bonding. To complement the XPS data, LEED was used to study the long‐range order of bromine on Rh(111): we observe a (√3×√3)R30° structure for low coverages (≤0.33 ML) and a star‐shaped compression structure for higher coverages (0.33–0.43 ML). Combining LEED and DFT calculations, we were able to visualize bromine adsorption on Rh(111) in real space for varying coverages.