SASyed Shamroz Arshad

Syed Shamroz Arshad

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Syed Shamroz Arshad has a total of 11 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Low Power Electronically Tunable Compound Sziklai Pair-Based Low Noise Amplifier for High Frequency Applications

    by Syed Shamroz Arshad, Geetika Srivastava, SachchidaNand Shukla, Mamun Bin Ibne Reaz, Edi Kurniawan, Mihir Narayan Mohanty

    Low Noise Figure (NF) and gain flatness over a wide frequency band are critical Low Noise Amplifier (LNA) performance parameters in high frequency applications. This paper presents a low-power, Cascode Feedback (CASF) compound Sziklai pair Low-Noise Amplifier (LNA) operating across 3.4–39.82[ ]GHz frequency, making it suitable for Ultra-Wideband (UWB) and lower Millimeter-Wave (mmWave) applications in RF front-end systems. By leveraging a CASF structure with NMOS Sziklai pair and complementary Sziklai pair, the proposed LNA achieves low input and output impedances, leading to improved broadband performance. A [ ] Impedance Tuning Circuit (ITC) is employed to tune the gain and other parameters, further enhancing gain and overall performance. Active bias is used to provide appropriate DC bias to the transistors, which strengthens current feedback and mitigates narrowband limitations. By using a CASF structure with lower transconductance transistors, power consumption is significantly reduced. Simulations performed in the CMOS 180[ ]nm process show peak voltage gain of 19.51[ ]dB with a bandwidth of 36.42[ ]GHz and peak current gain of 39.87[ ]dB. These results represent substantial improvements compared to the conventional PMOS Sziklai LNA approach, with nearly double the voltage gain and four times the current gain. Furthermore, the LNA exhibits NF of 0.343[ ]dB at 10[ ]GHz, Input Third-Order Intercept Point (IIP3) of 1.5[ ]dBm, and a chip area of [ ]m 2 . The power consumption is [ ]W from a 1.5[ ]V DC supply, representing an 84.11% reduction compared to the PMOS Sziklai LNA. The proposed LNA also addresses the shortcomings of high-power consumption, low phase margin, and high harmonic distortions of PMOS Sziklai LNAs and low gain, narrow bandwidth, and high NF of the Darlington RF CASF amplifier.

  • Operational Transconductance Amplifier-Based Low-Pass Filters in Biomedical Signal Processing: A Review of Design Considerations and Performance

    by Sachchida Nand Singh, Geetika Srivastava, Syed Shamroz Arshad, Nakib Hayat Chowdhury, Fahmida Haque, Maria Liz Crespo, Mamun Bin Ibne Reaz

    The world of biomedical electronics is changing rapidly with the addition of newer circuit components and newer fabrication technologies day by day. The portability of biomedical devices is challenging due to size and battery life concerns and smaller geometries the poor noise performance and lack of linearity in performance are another big challenge. Operational transconductance amplifiers (OTAs) have recently gained much popularity in biomedical applications due to their requirement of low power and low voltage for operation yet offering low noise and good linearity at output. OTAs have also found wide application in data converters, sensors and signal processors including analog processing blocks as well. This study examines the behavior of previously reported CMOS OTAs in various literature works, based on their operational characteristics. Different OTA configurations are compared on the basis of their linearity, design technology, supply voltage, power consumption, cut-off frequency and bandwidth specifically for biomedical signal processing. This paper is a useful resource for researchers who wish to design OTA-based different circuits for biomedical applications and need a summary of performance characteristics of different types of OTAs reported so far.


  • Open Access

    Novel complementary Sziklai pair based high gain low noise small-signal amplifiers

    by SachchidaNand Shukla, Syed Shamroz Arshad, Geetika Srivastava

    A new paired configuration of opposite polarity BJTs, the “complementary Sziklai pair” is introduced in the series of multi-BJT-based devices like Darlington and Sziklai pair, and its viability is tested in small-signal common emitter (CE) and common collector (CC) amplifier configurations. The Darlington and Sziklai both face the problem of poor frequency response at a higher frequency which is addressed by the proposed configuration. The proposed pair with CE amplifier holds class-A amplification property with a high voltage gain of 200.05, a high current gain of 11.62, wider bandwidth of 1.64 MHz, and a low THD of 1.29E-6%, hence supports the potential of wide applicability in analog communication. Similarly, the proposed pair with CC configuration produces approximately a unit current gain of 0.99 with wider bandwidth of 1.90 MHz and low THD of 1.76E-6%, therefore it can be used as a current buffer in a generalized current follower circuit. Conclusively, the device structure of this new BJT pair may be considered the third consecutive member of the series of Darlington pair and Sziklai pair. The layout of the proposed CE and CC amplifier occupy small areas of 158.30 μm2 (10.23×15.47 μm) and 141.16 μm2 (10.20×13.84 μm) respectively in 180 nm process technology.


  • Open Access

    Design and Analysis of Wideband PNP Sziklai Common Collector Amplifier with High Current Gain

    by Sachchidanand Shukla, Syed Shamroz Arshad, Pratima Soni, Aditya Kumar Sharma, Geetika Srivastava

    Objective: Objective of the manuscript is to introduce a novel idea of designing a small-signal common collector (emitter follower) amplifier with user-defined PSpice model of PNP Sziklai pair. Method: A circuit simulation program is developed on the PSpice simulation platform to design and study the proposed amplifier circuit. Small-signal AC equivalent circuit analysis authenticates the proposed amplifier design and selection of biasing components. The proposed amplifier is also implemented on Cadence Virtuoso Simulation software at 180nm technology to validate the design by performing its layout and post-layout simulation. Findings: The proposed circuit gives high current gain and smaller gain fluctuations (β) due to environmental parameter variations. The effect of variation in stage current gain of Sziklai pair components is observed under different operating conditions. Equivalent circuit analysis, noise performance, and the effect of temperature on the performance of the proposed circuit are widely discussed. Other possible circuit structures with a similar concept of design are also discussed as special cases. Highly stable amplifier current gain as well as device current gain, high amplifier voltage gain, device voltage gains below unity, and low harmonic distortion are prime features of proposed circuit. The problem of finding a matched pair of BJTs for the Sziklai pair is also addressed in the proposed design. The linear distortion-less operation of this circuit, combined with its very high current gain, makes it a suitable candidate for instrumentation amplifiers with wide operating frequency range. The proposed amplifier takes up (10.105 x 10.055) μm2 of area at 180nm technology. The results of pre-layout and post-layout AC responses show that there is a close resemblance between the parameters before and after the layout, which promotes the usability and design of the proposed amplifier. Novelty: The idea explored in the manuscript is entirely new and first time announced by authors. Keywords: PNP Sziklai Pair, Common Collector Amplifier, Current Gain, Small Signal Amplifier, Cadence Virtuoso