Антон Олексійович Шматов
Антон Олексійович Шматов has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- Halyna Omelianenko
Національний технічний університет «Харківський політехнічний інститут», Україна
2 shared publications - Veronika Cherkashyna
National Technical University "Kharkiv Polytechnic Institute", Kharkiv, Ukraine
2 shared publications - Igor Volodymyrovych Barbashov1 shared publication
Вероніка Вікторівна Черкашина
Національний технічний університет «Харківський політехнічний інститут
1 shared publicationГалина Вікторівна Омеляненко
Національний технічний університет «Харківський політехнічний інститут
1 shared publication
Latest Publications
- Open Access
- 29 December 2024
- Published by National Technical University Kharkiv Polytechnic Institute in Bulletin of the National Technical University "KhPI". Series: Energy: Reliability and Energy Efficiency
- No. 2 (9),p. 84-88
Justification of the scheme of melting ice on the wires of overhead power lines
The article discusses an urgent problem related to the formation of ice and frost deposits on the wires of overhead power lines, which causes significant technical difficulties in ensuring the reliability of power supply, especially in winter. The accumulation of ice and frost on the wires leads to an increase in the weight of the wires, which can cause them to sag, damage insulators, destroy poles, and, as a result, serious accidents on power lines. The causes of accidents in power grids due to ice and frost deposits are analyzed and it is found that their elimination will reduce the probability of damage to overhead power lines from the action of ice loads. However, existing methods of dealing with this problem have a number of disadvantages, such as high cost, low efficiency in certain conditions, and negative environmental impact. The article presents a scheme for melting ice on the wires of overhead power lines by the method of a three-phase short circuit when powered by a power source with a solidly grounded and isolated neutral. This scheme makes it possible to locally increase the temperature of wires to a level sufficient to melt ice and frost, which reduces the risk of emergencies and ensures the uninterrupted operation of the electrical grid. The article provides theoretical justifications for the scheme for melting ice with three-phase short-circuit currents, which confirm its effectiveness. The analysis has shown that the proposed scheme is economically feasible, as it reduces the cost of maintenance and repair of overhead power lines. In addition, it is environmentally friendly, as it does not involve the use of chemicals. Thus, the proposed scheme for melting ice on the wires of overhead power lines is a promising solution for improving the reliability and safety of power supply in winter weather conditions. Its application can significantly increase the efficiency of power grid operation, reduce the number of accidents, and improve the stability of power supply to consumers.
- 29 December 2024
- Published by National Technical University Kharkiv Polytechnic Institute in Bulletin of the National Technical University "KhPI". Series: Energy: Reliability and Energy Efficiency
- No. 2 (9),p. 84-88
Open AccessJustification of the scheme of melting ice on the wires of overhead power lines
The article discusses an urgent problem related to the formation of ice and frost deposits on the wires of overhead power lines, which causes significant technical difficulties in ensuring the reliability of power supply, especially in winter. The accumulation of ice and frost on the wires leads to an increase in the weight of the wires, which can cause them to sag, damage insulators, destroy poles, and, as a result, serious accidents on power lines. The causes of accidents in power grids due to ice and frost deposits are analyzed and it is found that their elimination will reduce the probability of damage to overhead power lines from the action of ice loads. However, existing methods of dealing with this problem have a number of disadvantages, such as high cost, low efficiency in certain conditions, and negative environmental impact. The article presents a scheme for melting ice on the wires of overhead power lines by the method of a three-phase short circuit when powered by a power source with a solidly grounded and isolated neutral. This scheme makes it possible to locally increase the temperature of wires to a level sufficient to melt ice and frost, which reduces the risk of emergencies and ensures the uninterrupted operation of the electrical grid. The article provides theoretical justifications for the scheme for melting ice with three-phase short-circuit currents, which confirm its effectiveness. The analysis has shown that the proposed scheme is economically feasible, as it reduces the cost of maintenance and repair of overhead power lines. In addition, it is environmentally friendly, as it does not involve the use of chemicals. Thus, the proposed scheme for melting ice on the wires of overhead power lines is a promising solution for improving the reliability and safety of power supply in winter weather conditions. Its application can significantly increase the efficiency of power grid operation, reduce the number of accidents, and improve the stability of power supply to consumers.
- Open Access
- 5 July 2024
- Published by National Technical University Kharkiv Polytechnic Institute in Bulletin of the National Technical University "KhPI". Series: Energy: Reliability and Energy Efficiency
- No. 1 (8),p. 8-12
Research on improving the efficiency of electricity transmission
A study of ways to modernize the current-carrying part of overhead lines to improve the efficiency of electricity transmission through the use of innovative types of wires was conducted. The technical and economic characteristics of AC, ACCR, and AERO-Z wires were analyzed. The results of the analysis revealed that further improvement of the design of AC wires should be based on new progressive developments that would meet such technical requirements as reliability, survivability and durability; corrosion resistance; high adhesion ability; resistance to vibration during operation under the influence of adverse climatic factors; resistance to environmental temperature effects. As an innovative solution to this issue, high-temperature (ACCR) and specially designed (AERO-Z) wires have been developed in foreign countries. A comparative analysis of the types of wires used in Ukrainian power grids with innovative types of wires used in power grids of foreign countries was performed. The results of the comparison of AC, ACCR, and AERO-Z wires show that the factor that limits the scope of application of ACCR wire, even for spans with extremely high requirements for power transmission characteristics, is its extremely high cost. This is because the technical characteristics of this wire are better than those of AC wire and it has a relatively low cost compared to ACCR wire, and its special design is adapted to adverse climatic conditions that affect the characteristics of electricity transmission.
- 5 July 2024
- Published by National Technical University Kharkiv Polytechnic Institute in Bulletin of the National Technical University "KhPI". Series: Energy: Reliability and Energy Efficiency
- No. 1 (8),p. 8-12
Open AccessResearch on improving the efficiency of electricity transmission
A study of ways to modernize the current-carrying part of overhead lines to improve the efficiency of electricity transmission through the use of innovative types of wires was conducted. The technical and economic characteristics of AC, ACCR, and AERO-Z wires were analyzed. The results of the analysis revealed that further improvement of the design of AC wires should be based on new progressive developments that would meet such technical requirements as reliability, survivability and durability; corrosion resistance; high adhesion ability; resistance to vibration during operation under the influence of adverse climatic factors; resistance to environmental temperature effects. As an innovative solution to this issue, high-temperature (ACCR) and specially designed (AERO-Z) wires have been developed in foreign countries. A comparative analysis of the types of wires used in Ukrainian power grids with innovative types of wires used in power grids of foreign countries was performed. The results of the comparison of AC, ACCR, and AERO-Z wires show that the factor that limits the scope of application of ACCR wire, even for spans with extremely high requirements for power transmission characteristics, is its extremely high cost. This is because the technical characteristics of this wire are better than those of AC wire and it has a relatively low cost compared to ACCR wire, and its special design is adapted to adverse climatic conditions that affect the characteristics of electricity transmission.
- Open Access
- 9 July 2023
- Published by National Technical University Kharkiv Polytechnic Institute in Bulletin of the National Technical University "KhPI". Series: Energy: Reliability and Energy Efficiency
- No. 1 (6),p. 45-50
Study of foreign experience in dealing with ice and frost deposits on the wires of overhead power lines
The means and technologies for predicting and preventing frost and ice deposits on the wires of overhead power lines in the power grids of foreign countries are presented. The focus is on such systems as Meteo, dynamic thermal rating, online monitoring of China Southern Power Grid, Variable resistance cable de-icing system and mobile ice melting units. The advantages and disadvantages of these systems are analyzed and it is found that such approaches require energy consumption and are relevant only for the relevant region of the power grid, depending on weather conditions and the distance of electricity transmission. The mechanical, electromechanical, electrothermal, and physicochemical methods of predicting frost and ice deposits on the wires of overhead power lines are considered. It was found that the consideration of dynamic processes is essential and effective in the study of power grids in extreme weather conditions, and the data on frost and ice deposits on overhead line wires are characterized by high dimensionality, nonlinearity, multimodality, and heterogeneity, which makes it impossible to create an accurate forecasting model using traditional methods of evaluation and decision-making. The method of time series analysis and the method of Ensemble Empirical Mode Decomposition are proposed to solve this problem. The basis of these methods is to maximize the use of inherent regularities represented by frequency and time characteristics for effective data analysis and to create the basis for subsequent models and improve their forecasting accuracy. On the basis of the research, the author proposes ways to adapt and integrate the experience of foreign countries into the power grids of Ukraine. The necessity of creating integrated information systems for monitoring meteorological parameters and operating modes of power grids using specialized forecasting models and IT systems is substantiated, which will automate the process of assessing the current state of overhead power lines based on meteorological data in order to timely prevent emergencies in power grids provoked by frost and ice deposits.
- 9 July 2023
- Published by National Technical University Kharkiv Polytechnic Institute in Bulletin of the National Technical University "KhPI". Series: Energy: Reliability and Energy Efficiency
- No. 1 (6),p. 45-50
Open AccessStudy of foreign experience in dealing with ice and frost deposits on the wires of overhead power lines
The means and technologies for predicting and preventing frost and ice deposits on the wires of overhead power lines in the power grids of foreign countries are presented. The focus is on such systems as Meteo, dynamic thermal rating, online monitoring of China Southern Power Grid, Variable resistance cable de-icing system and mobile ice melting units. The advantages and disadvantages of these systems are analyzed and it is found that such approaches require energy consumption and are relevant only for the relevant region of the power grid, depending on weather conditions and the distance of electricity transmission. The mechanical, electromechanical, electrothermal, and physicochemical methods of predicting frost and ice deposits on the wires of overhead power lines are considered. It was found that the consideration of dynamic processes is essential and effective in the study of power grids in extreme weather conditions, and the data on frost and ice deposits on overhead line wires are characterized by high dimensionality, nonlinearity, multimodality, and heterogeneity, which makes it impossible to create an accurate forecasting model using traditional methods of evaluation and decision-making. The method of time series analysis and the method of Ensemble Empirical Mode Decomposition are proposed to solve this problem. The basis of these methods is to maximize the use of inherent regularities represented by frequency and time characteristics for effective data analysis and to create the basis for subsequent models and improve their forecasting accuracy. On the basis of the research, the author proposes ways to adapt and integrate the experience of foreign countries into the power grids of Ukraine. The necessity of creating integrated information systems for monitoring meteorological parameters and operating modes of power grids using specialized forecasting models and IT systems is substantiated, which will automate the process of assessing the current state of overhead power lines based on meteorological data in order to timely prevent emergencies in power grids provoked by frost and ice deposits.