Joonyup Bae
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Joonyup Bae has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
- Jihyun Kim
Department of Chemical and Biological Engineering, Seoul National University, Seoul 08826, Republic of Korea
4 shared publications - Aman Haque
Penn State University
3 shared publications - Fan Ren
Department of Chemical Engineering, University of Florida 3 , Gainesville, Florida 32611
3 shared publications - Hsiao-Hsuan Wan
Department of Chemical Engineering, University of Florida 1 , Gainesville, Florida 32611
2 shared publications - Stephen. J. Pearton
Material Science and Engineering, University of Florida 3 , Gainesville, Florida 32611
2 shared publications - Aaron Rabin
Department of Materials Science and Engineering, University of Florida 5 , Gainesville, Florida 32611
1 shared publication
Latest Publications
- Open Access
- 9 March 2026
- Published by The Electrochemical Society in ECS Journal of Solid State Science and Technology
- Vol. 15 (3)
Impact of 10 MeV Proton Irradiation on the Electrical Characteristics of Diamond Schottky and Heterojunction Diodes
The radiation tolerance of single-crystal diamond devices was investigated under 10 MeV proton irradiation. Schottky barrier diodes (SBDs) and ITO/diamond heterojunction diodes were fabricated on boron-doped diamond substrates with a 10 µm lightly doped drift layer and exposed to proton fluences from 1.0 × 10¹³ to 1.6 × 10¹⁴ cm⁻². Irradiation induced increased on-resistance, reduced saturation current, and enhanced reverse leakage, with heterojunction devices showing greater degradation due to the vulnerability of the ITO layer and interface. Capacitance–voltage measurements revealed carrier removal rates of 171, 65, and 43 cm⁻¹ for fluences of 1.0 × 10¹³, 6.0 × 10¹³, and 1.6 × 10¹⁴ cm⁻², respectively, confirming diamond’s superior radiation hardness compared to Si, GaN, and Ga₂O₃. This resilience is attributed to diamond’s high atomic displacement energy, which limits lattice damage. These results demonstrate the potential of single-crystal diamond devices for radiation-hard power electronics and high-radiation environments.
- 9 March 2026
- Published by The Electrochemical Society in ECS Journal of Solid State Science and Technology
- Vol. 15 (3)
Open AccessImpact of 10 MeV Proton Irradiation on the Electrical Characteristics of Diamond Schottky and Heterojunction Diodes
The radiation tolerance of single-crystal diamond devices was investigated under 10 MeV proton irradiation. Schottky barrier diodes (SBDs) and ITO/diamond heterojunction diodes were fabricated on boron-doped diamond substrates with a 10 µm lightly doped drift layer and exposed to proton fluences from 1.0 × 10¹³ to 1.6 × 10¹⁴ cm⁻². Irradiation induced increased on-resistance, reduced saturation current, and enhanced reverse leakage, with heterojunction devices showing greater degradation due to the vulnerability of the ITO layer and interface. Capacitance–voltage measurements revealed carrier removal rates of 171, 65, and 43 cm⁻¹ for fluences of 1.0 × 10¹³, 6.0 × 10¹³, and 1.6 × 10¹⁴ cm⁻², respectively, confirming diamond’s superior radiation hardness compared to Si, GaN, and Ga₂O₃. This resilience is attributed to diamond’s high atomic displacement energy, which limits lattice damage. These results demonstrate the potential of single-crystal diamond devices for radiation-hard power electronics and high-radiation environments.
- 12 May 2025
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 43 (4)
Defining the relative proton irradiation hardness of β-Ga2O3
The correlation between the carrier removal rate (CRR) in n-type Ga2O3 and the nonionizing energy loss (NIEL) by MeV protons during irradiation of rectifier structures is reported. A dependence of CRR = 7 × 10−14 (n0 × NIEL) + 18.7 is found, where n0 is the drift layer doping. The critical proton fluence at which the drift layer doping would be fully compensated by acceptor traps created by the NIEL in Ga2O3 is ΦCR (Ga2O3) = 6 × 10−4 (n0/NIEL) + 5 × 1013 cm−2. A comparison with SiC irradiated under similar conditions shows the Ga2O3 to have a higher critical fluence.
- 12 May 2025
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 43 (4)
Defining the relative proton irradiation hardness of β-Ga2O3
The correlation between the carrier removal rate (CRR) in n-type Ga2O3 and the nonionizing energy loss (NIEL) by MeV protons during irradiation of rectifier structures is reported. A dependence of CRR = 7 × 10−14 (n0 × NIEL) + 18.7 is found, where n0 is the drift layer doping. The critical proton fluence at which the drift layer doping would be fully compensated by acceptor traps created by the NIEL in Ga2O3 is ΦCR (Ga2O3) = 6 × 10−4 (n0/NIEL) + 5 × 1013 cm−2. A comparison with SiC irradiated under similar conditions shows the Ga2O3 to have a higher critical fluence.
- 2 January 2025
- Published by AIP Publishing in Applied Physics Letters
- Vol. 126 (1)
Defect-engineered electrical and optoelectronic properties of WS2 irradiated with 10 MeV protons
Transition metal dichalcogenides (TMDs), particularly tungsten disulfide (WS2), have gained considerable attention due to their versatile electrical and optoelectronic properties, making them promising candidates for next-generation nano(opto)electronic devices. This study investigates the impact of 10 MeV proton irradiation on the electrical and optoelectronic properties of WS2, focusing on the controlled introduction of defects, primarily sulfur vacancies, which are crucial for tailoring material properties and enhancing their capabilities. By varying proton fluences from 1 × 1013 to 5 × 1014 cm−2 at an energy of 10 MeV, the defect density was precisely modulated. The effects of this defect-engineering strategy were characterized using micro-Raman spectroscopy, low-temperature photoluminescence, and density functional theory calculations. Both electronic (field-effect transistor) and optoelectronic (photodetector) devices fabricated with defect-engineered WS2 exhibited a 24-fold decrease in contact resistance and a fivefold improvement in photogain. These results demonstrate the potential of proton irradiation as a powerful tool for defect engineering in TMDs. The findings underscore the promise of this approach for optimizing TMD-based devices for advanced electronic and optoelectronic applications, paving the way for tailored material properties in next-generation technologies.
- 2 January 2025
- Published by AIP Publishing in Applied Physics Letters
- Vol. 126 (1)
Defect-engineered electrical and optoelectronic properties of WS2 irradiated with 10 MeV protons
Transition metal dichalcogenides (TMDs), particularly tungsten disulfide (WS2), have gained considerable attention due to their versatile electrical and optoelectronic properties, making them promising candidates for next-generation nano(opto)electronic devices. This study investigates the impact of 10 MeV proton irradiation on the electrical and optoelectronic properties of WS2, focusing on the controlled introduction of defects, primarily sulfur vacancies, which are crucial for tailoring material properties and enhancing their capabilities. By varying proton fluences from 1 × 1013 to 5 × 1014 cm−2 at an energy of 10 MeV, the defect density was precisely modulated. The effects of this defect-engineering strategy were characterized using micro-Raman spectroscopy, low-temperature photoluminescence, and density functional theory calculations. Both electronic (field-effect transistor) and optoelectronic (photodetector) devices fabricated with defect-engineered WS2 exhibited a 24-fold decrease in contact resistance and a fivefold improvement in photogain. These results demonstrate the potential of proton irradiation as a powerful tool for defect engineering in TMDs. The findings underscore the promise of this approach for optimizing TMD-based devices for advanced electronic and optoelectronic applications, paving the way for tailored material properties in next-generation technologies.
- 22 July 2024
- Published by Elsevier in Optical Materials
- Vol. 155
Improvement of electrical and optoelectronic properties of ZnO thin films by plasma nitridation treatment
- 22 July 2024
- Published by Elsevier in Optical Materials
- Vol. 155
Improvement of electrical and optoelectronic properties of ZnO thin films by plasma nitridation treatment
- 8 December 2023
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 134 (22)
Reducing proton radiation vulnerability in AlGaN/GaN high electron mobility transistors with residual strain relief
Strain plays an important role in the performance and reliability of AlGaN/GaN high electron mobility transistors (HEMTs). However, the impact of strain on the performance of proton irradiated GaN HEMTs is yet unknown. In this study, we investigated the effects of strain relaxation on the properties of proton irradiated AlGaN/GaN HEMTs. Controlled strain relief is achieved locally using the substrate micro-trench technique. The strain relieved devices experienced a relatively smaller increase of strain after 5 MeV proton irradiation at a fluence of 5 × 1014 cm−2 compared to the non-strain relieved devices, i.e., the pristine devices. After proton irradiation, both pristine and strain relieved devices demonstrate a reduction of drain saturation current (Ids,sat), maximum transconductance (Gm), carrier density (ns), and mobility (μn). Depending on the bias conditions the pristine devices exhibit up to 32% reduction of Ids,sat, 38% reduction of Gm, 15% reduction of ns, and 48% reduction of μn values. In contrast, the strain relieved devices show only up to 13% reduction of Ids,sat, 11% reduction of Gm, 9% reduction of ns, and 30% reduction of μn values. In addition, the locally strain relieved devices show smaller positive shift of threshold voltage compared to the pristine devices after proton irradiation. The less detrimental impact of proton irradiation on the transport properties of strain relieved devices could be attributed to reduced point defect density producing lower trap center densities, and evolution of lower operation related stresses due to lower initial residual strain.
- 8 December 2023
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 134 (22)
Reducing proton radiation vulnerability in AlGaN/GaN high electron mobility transistors with residual strain relief
Strain plays an important role in the performance and reliability of AlGaN/GaN high electron mobility transistors (HEMTs). However, the impact of strain on the performance of proton irradiated GaN HEMTs is yet unknown. In this study, we investigated the effects of strain relaxation on the properties of proton irradiated AlGaN/GaN HEMTs. Controlled strain relief is achieved locally using the substrate micro-trench technique. The strain relieved devices experienced a relatively smaller increase of strain after 5 MeV proton irradiation at a fluence of 5 × 1014 cm−2 compared to the non-strain relieved devices, i.e., the pristine devices. After proton irradiation, both pristine and strain relieved devices demonstrate a reduction of drain saturation current (Ids,sat), maximum transconductance (Gm), carrier density (ns), and mobility (μn). Depending on the bias conditions the pristine devices exhibit up to 32% reduction of Ids,sat, 38% reduction of Gm, 15% reduction of ns, and 48% reduction of μn values. In contrast, the strain relieved devices show only up to 13% reduction of Ids,sat, 11% reduction of Gm, 9% reduction of ns, and 30% reduction of μn values. In addition, the locally strain relieved devices show smaller positive shift of threshold voltage compared to the pristine devices after proton irradiation. The less detrimental impact of proton irradiation on the transport properties of strain relieved devices could be attributed to reduced point defect density producing lower trap center densities, and evolution of lower operation related stresses due to lower initial residual strain.