SZShiyuan Zhu

Shiyuan Zhu

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Shiyuan Zhu has a total of 12 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Electrodeposition and Corrosion Resistance of Ni-Mo Alloy Coating: Effect of Electroplating Bath pH Values

    by Xi Shi, Shiyuan Zhu, Qiongyu Zhou, Bo Liang, Jun Li, Guangji Li, Longquan Chen, Peijun Xu

    Ni-Mo alloy coating has shown exciting potential as a candidate to replace chromium coating. In this paper, Ni-Mo alloy coatings were successfully electrodeposited from a citrate/ammonia bath, and the effect of the bath pH values over a wide range (4–10) on the characteristics and corrosion resistance of Ni-Mo alloy coating was studied in detail. Results show that all the deposited Ni-Mo alloy coatings consist of a crystalline solid-solution Ni(Mo) fcc structure. An increase in bath pH values could facilitate the deposition of Mo, thereby increasing the Mo content and decreasing the crystallite size of Ni-Mo alloy coatings. However, there are subtle gaps between the coarse grains on the surface of the Ni-Mo alloy coating deposited at pH 10. These subtle gaps tend to form between the coarse grains on the surface of the electrodeposited Ni-Mo alloy coating because of the relatively high Mo content, refined grains, and appropriate morphology. The Ni-Mo alloy coating deposited at pH 9 exhibits optimal corrosion resistance, attributed to its lowest corrosion current density icorr (7.31 × 10−6 A cm−2), the strongest polarization resistance (11.13 kΩ·cm−2), and impedance value, which are mainly contributed to by the coating resistance and charge-transfer resistance.


  • Open Access

    Li+ Conduction in a Polymer/Li1.5Al0.5Ge1.5(PO4)3 Solid Electrolyte and Li-Metal/Electrolyte Interface

    by Qinghui Li, Xiaofen Wang, Linlin Wang, Shyuan Zhu, Qingdong Zhong, Yuanyuan Li, Qiongyu Zhou

    The solid oxide electrolyte Li1.5Al0.5Ge1.5(PO4)3 (LAGP) with a NASICON structure has a high bulk ionic conductivity of 10−4 S cm−1 at room temperature and good stability in the air because of the strong P5+-O2− covalence bonding. However, the Ge4+ ions in LAGP are quickly reduced to Ge3+ on contact with the metallic lithium anode, and the LAGP ceramic has insufficient physical contact with the electrodes in all-solid-state batteries, which limits the large-scale application of the LAGP electrolyte in all-solid-state Li-metal batteries. Here, we prepared flexible PEO/LiTFSI/LAGP composite electrolytes, and the introduction of LAGP as a ceramic filler in polymer electrolytes increases the total ionic conductivity and the electrochemical stability of the composite electrolyte. Moreover, the flexible polymer shows good contact with the electrodes, resulting in a small interfacial resistance and stable cycling of all-solid-state Li-metal batteries. The influence of the external pressure and temperature on Li+ transfer across the Li/electrolyte interface is also investigated.