HHHong Hou

Hong Hou

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Hong Hou has a total of 63 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • A dual-scale kernel reconstruction smoothed particle hydrodynamics method for broadband acoustic dispersion suppression

    by Ning Lu, Yunke Huang, Hong Hou

    Meshfree methods are suited to acoustic simulations involving moving interfaces and complex boundaries, such as noise from moving machinery and fluid-structure interactions. Smoothed particle hydrodynamics (SPH) provides a Lagrangian framework for such problems. However, conventional SPH accumulates numerical dispersion during long-range broadband propagation. Its kernel-gradient operator acts as a dispersive filter, producing frequency-dependent phase distortion, high-frequency attenuation, and spurious trailing oscillations. Direct assignment of broadband signals to particles may produce discontinuous pressure distributions within the source region, thereby distorting the injected waveform before propagation. This paper proposes an analytically dual-scale kernel (DSK) reconstruction operator that cancels the leading dispersion error at the operator level. Combined with the corrected smoothed particle method (CSPM), it corrects spectral dispersion and local consistency errors. A retarded-time source loading strategy with impedance matching is introduced to prevent injection-stage distortion. The framework is validated through one-dimensional long-distance propagation, two-dimensional plane wave propagation, and cylindrical-wave radiation. Results show that DSK-CSPM reduces the one-dimensional L2 pressure error by approximately a factor of 150 relative to standard SPH, brings phase velocities close to the sound speed, and incurs a computational overhead of 2.9% in the two-dimensional plane wave test. The method provides an accurate and efficient strategy for high-fidelity particle-based broadband acoustic simulation.

  • Influence of dynamic mechanical parameters of viscoelastic materials on the sound absorption performance of cavity-type coatings under static pressure

    by Ruihao Zhang, Zhe Liu, Qiaomu Zhang, Hong Hou

    Under hydrostatic pressure, both the geometry and dynamic mechanical parameters of underwater acoustic coatings change, affecting sound absorption performance. This paper proposes a composite coating structure with bullet-shaped cavities. The finite element method is used to investigate the effects of coating deformation and mechanical parameter changes under different pressures. The wave velocity method based on direct wave extraction measures the frequency-dependent dynamic mechanical parameters of viscoelastic materials from 500 Hz to 4 kHz under pressure. These measured parameters are introduced into simulations, and the predicted sound absorption coefficient is compared with that obtained using fixed (frequency-independent) parameters. Pressurized sound absorption tests up to 4 MPa are conducted in a water-filled tube. The experimental results show that under normal pressure, the structure achieves an average absorption coefficient of 0.93 in the 1000–4000 Hz band. At 4 MPa, the average coefficient remains 0.58. Simulations using frequency-dependent dynamic mechanical parameters reduce the average absolute deviation from experiments to half of that using fixed parameters (maximum average absolute deviation 0.07). These findings demonstrate the necessity of incorporating frequency-dependent dynamic mechanical parameters into finite element simulations for accurate prediction of hydrostatically loaded underwater acoustic coatings.

  • Viscosity resistance correction method of medium in dynamic mechanical parameter testing

    by Zhe Liu, Rui-Hao Zhang, Jie Zhang, Qiao-Mu Zhang, Yu-Xin Xu, Bing Wang, Hong-Wei Li, Hong Hou

  • NAPG: Neighborhood-Assisted Multiprototype Group Model for Cross-Domain Semantic Segmentation of Remote Sensing Images

    by Rongbo Fan, Jialin Xie, Junmin Liu, Jun Zhang, Yan Zhang, Hong Hou, Jianhua Yang

    Unsupervised domain adaptation (UDA) is crucial for semantic segmentation of remote sensing images (RS-SS), particularly when data distributions differ between source and target domains. Existing prototype-based UDA methods struggle with complex land cover class distributions and spatial information capture. To address these limitations, the Neighborhood-Assisted Multi-Prototype Group (NAPG) model is proposed. This model enhances cross-domain adaptability and spatial context richness by dynamically determining the number of prototype features and integrating neighborhood similarity gradients. Specifically, NAPG employs the Cross-Domain Representation of Multi-Prototype Group (CDR-MPG) module to generate multi-prototype group, capturing land cover complexity more effectively. Additionally, the Gradient Neighborhood Consistency Estimation (GNCE) module improves spatial representation by reducing intra-class variance and alleviating feature inconsistency. Experiments demonstrate that the proposed NAPG model outperforms state-of-the-art UDA methods across multiple datasets, achieving an mean intersection over union (mIoU) improvement of 3%. The source code is publicly available at https://github.com/Fanrongbo/NAPG-UDA-RS-SS.


  • Low-Frequency Sound Source Localization Algorithm for Small-Aperture AVSA Under Nonuniform Noise Scenarios

    by Jun Zhang, Bin Liang, Jianhua Yang, Hong Hou

    For low-frequency source localization with small aperture acoustic array, we propose a high-resolution localization algorithm based on complex Wishart prior. The algorithm, named Wishart-CSM-SBL, employs vectorized cross-spectral matrix (CSM) preprocessing and performs parameter updating within the sparse Bayesian learning (SBL) framework. Existing SBL algorithms struggle to capture the complex correlations between non-adjacent columns of the dictionary set in small aperture, low-frequency scenarios, often resulting in failed signal recovery. To solve this problem, the Wishart-CSM-SBL algorithm introduces the complex Wishart distribution and develops novel priors for sparse signal and noise. Specifically, the sparse signal is characterized by a two-layer prior model comprising complex Gaussian and complex Wishart distributions. By capturing the intricate correlations among the columns of the dictionary set, this modeling approach significantly improves the accuracy and robustness of sparse recovery. The complex Wishart distribution is employed to represent the noise with unknown structure, addressing the performance degradation in existing algorithms that assume noise with uniform variance. This is achieved by accounting for noise in-homogeneity and correlation. In addition, a two-dimensional off-grid solution is extended to eliminate localization errors caused by coarse grid division. Finally, simulations verify that the algorithm outperforms existing algorithms for small aperture arrays and low-frequency sources scenarios.


  • Open Access

    Down-film as a new non-frame porous material for sound absorption

    by Tingying Zhang, Jiyang Zhang, Hong Hou, Ying Xu, Kean Chen

    Down-polyethylene film material has been introduced for the first time as an excellent non-frame sound absorber, showing a distinctively outstanding performance. It contains down fiber adjacent to each other without firm connection in between, forming a structure of elastic fiber network. The unique structure has broadband response to sound wave, showing non-synchronous vibration in low and middle frequency and synchronous vibration in middle and high frequency. The broadband resonance in middle and high frequency allows the structure to achieve complete sound absorption in resonance frequency band. Moreover, down-polyethylene film material possesses forced vibration, corresponding sound absorption coefficient has been obtained based on vibration theory. The down-film sound absorption material has the characteristics of light weight, soft, environment-friendly, and has excellent broadband sound absorption performance.


  • Open Access

    Multiscale Change Detection Domain Adaptation Model Based on Illumination–Reflection Decoupling

    by Rongbo Fan, Jialin Xie, Jianhua Yang, Zenglin Hong, Yuqi Xu, Hong Hou

    In the change detection (CD) task, the substantial variation in feature distributions across different CD datasets significantly limits the reusability of supervised CD models. To alleviate this problem, we propose an illumination–reflection decoupled change detection multi-scale unsupervised domain adaptation model, referred to as IRD-CD-UDA. IRD-CD-UDA maintains its performance on the original dataset (source domain) and improves its performance on unlabeled datasets (target domain) through a novel CD-UDA structure and methodology. IRD-CD-UDA synergizes mid-level global feature marginal distribution domain alignment, classifier layer feature conditional distribution domain alignment, and an easy-to-hard sample selection strategy to increase the generalization performance of CD models on cross-domain datasets. Extensive experiments conducted on the LEVIR, SYSU, and GZ optical remote sensing image datasets demonstrate that the IRD-CD-UDA model effectively mitigates feature distribution discrepancies between source and target CD data, thereby achieving optimal recognition performance on unlabeled target domain datasets.


  • Open Access

    Study on Sound Absorption Properties of Polyvinyl Chloride (PVC) Film Multicavity Structure Materials

    by Tingying Zhang, Jiyang Zhang, Pengxuan Zheng, Hong Hou, Ying Xu

    Since the development of industry, sound absorption and noise reduction have gradually become an urgent problem to be solved. Lightweight polymer film materials are very effective in response to sound waves, and sound waves can easily cause vibration of the film, which can convert sound energy into vibration and film friction to achieve sound absorption. The application conditions of the film material are very harsh, that is, a support body is required to fix the film and the film needs to be tensioned. The film is very thin and easy to damage. The idea of this research is to transform the film into a bubble structure and use a large number of film bubbles to form a cavity structure material. As a unit of the sound absorption structure, bubbles can avoid damage to the film. In this paper, commercial polyvinyl chloride film bubble materials are used to prepare two kinds of film multicavity structure materials, and the sound absorption performance of this film multicavity structure material is studied. The research results show that this film multicavity structure material has very excellent broadband sound absorption performance, which changes the narrow band sound absorption properties of the usual film single cavity. The average sound absorption coefficient can reach 0.84 in frequency range from 500 Hz to 6400 Hz. This structural material has a single peak sound absorption curve at the middle and low frequency bands, which is the characteristic of resonance sound absorption. And at the middle and high frequency bands, it exhibits the characteristics of broadband sound absorption. The film multicavity structure material has both cavity sound absorption and broadband sound absorption characteristics.


  • Open Access

    Study on the acoustic performance of bending metasurface with ultra-thin broadband quasi-perfect sound absorption

    by Baozhu Cheng, QiuYu Zeng, Yang Liu, Jiansong Weng, Bin Li, Hong Hou

    In order to achieve low-frequency broadband noise control under subwavelength thickness, this paper established a theoretical model for calculating the sound absorption coefficient of curled acoustic metasurface (CAM) composed of embedded hole, equal width curled channel, and gradient width curled channel, which is based on the thermal viscosity equivalent model and impedance equivalent model. Considering the over resistance effect caused by multi-unit composite structure, a multi-parameter control strategy was used to design bending acoustic metasurface (BAM) units for perfect sound absorption at four discrete frequencies of 546 Hz, 563 Hz, 585 Hz, and 601 Hz, which is based on the complex frequency plane method. and the thicknesses of these unites are only λ / 52 (1.2 cm). The broadband and efficient sound absorption effect of the four parallel composite BAM units was theoretically studied. The simulation and experiment verified that the composite BAM not only achieved perfect sound absorption at 573 Hz with a subwavelength thickness of 12 mm, but also had an efficient sound absorption(α > 0.8) frequency band of 512Hz-621Hz, with a bandwidth up to 109 Hz. The research in this paper provides a certain theoretical basis for the design of low-frequency broadband compact acoustic structures, and has certain reference value for low-frequency broadband noise control.