Ryan Wu
Research Subjects
Ryan Wu has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
- Dongyin Ren
NXP Semiconductors, San Jose, CA, USA
5 shared publications - Jun Li
NXP Semiconductors, San Jose, CA, USA
5 shared publications - I. T. Lu
New York University, New York, NY, USA
2 shared publications - Jun H. Choi
Department of Electrical Engineering, University at Buffalo, Buffalo, NY, USA
2 shared publications - Nathan Chordas-Ewell
Department of Electrical Engineering, University at Buffalo, Buffalo, NY, USA
2 shared publications - Andreas Hofmann
Golden Devices GmbH, Erlangen, Germany
1 shared publication
Latest Publications
- Open Access
- 1 January 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Open Journal of Signal Processing
- Vol. 7, 704-716
Allpass-Based Chirp Design With Perfect Pulse Compression Property
- 1 January 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Open Journal of Signal Processing
- Vol. 7, 704-716
Open AccessAllpass-Based Chirp Design With Perfect Pulse Compression Property
- 16 September 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 73 (12) , 10135-10147
A W-Band Frequency-Scanning Leaky Wave Antenna Based on a Composite Right/Left-Handed Waveguide for Rapid Beam Scanning
This paper presents a W-band (75-110 GHz) frequency-scanning leaky-wave antenna with backward-to-forward rapid beam-scanning capability. The design takes advantage of the low-loss and high-dispersion features of an air-filled composite right/left-handed metallic waveguide. Equivalent circuit modeling and a detailed design procedure are presented to facilitate the analysis and design. The design method is validated by a prototype antenna using 3D printing technology. Measurement results are consistent with simulated ones and show a wide field-of-view (FoV) from -15° to +35° when the radiated frequency is swept from 75.4GHz to 79.4GHz, equivalent to a high scanning rate of 9.68°/%BW. In simulation, when operated from 76.5GHz to 81.5GHz, the FoV can cover from -30° to +50°, which translates to a scanning rate of 12.64°/%BW. To the best of the authors’ knowledge, the presented antenna achieves the highest scanning rate in the W-band. The presented design may be a good candidate for millimeter-wave imaging applications that require low loss and rapid beam-scanning, including automotive radars.
- 16 September 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 73 (12) , 10135-10147
A W-Band Frequency-Scanning Leaky Wave Antenna Based on a Composite Right/Left-Handed Waveguide for Rapid Beam Scanning
This paper presents a W-band (75-110 GHz) frequency-scanning leaky-wave antenna with backward-to-forward rapid beam-scanning capability. The design takes advantage of the low-loss and high-dispersion features of an air-filled composite right/left-handed metallic waveguide. Equivalent circuit modeling and a detailed design procedure are presented to facilitate the analysis and design. The design method is validated by a prototype antenna using 3D printing technology. Measurement results are consistent with simulated ones and show a wide field-of-view (FoV) from -15° to +35° when the radiated frequency is swept from 75.4GHz to 79.4GHz, equivalent to a high scanning rate of 9.68°/%BW. In simulation, when operated from 76.5GHz to 81.5GHz, the FoV can cover from -30° to +50°, which translates to a scanning rate of 12.64°/%BW. To the best of the authors’ knowledge, the presented antenna achieves the highest scanning rate in the W-band. The presented design may be a good candidate for millimeter-wave imaging applications that require low loss and rapid beam-scanning, including automotive radars.
- 11 August 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Radar Systems
- Vol. 3, 1103-1118
Broad Neural Networks for Sparse Signal Retrieval and Array Interpolation in Automotive Radar
Sparse antenna arrays are widely used in automotive radar systems to achieve high angular resolution with reduced hardware complexity and mutual coupling. However, the high sidelobes inherent in sparse configurations can degrade angle estimation accuracy, motivating the need for effective interpolation methods. Although deep neural networks (DNNs) have shown strong performance in sparse signal recovery, their deployment is hindered by high computational cost, complex activation functions, and limited interpretability due to deep-layer architectures. To address these challenges, we propose a novel framework based on broad neural networks (BNNs) for efficient and accurate sparse signal retrieval. Unlike conventional DNNs, BNNs utilize parallel network structures with simplified, custom-designed activation functions, eliminating hidden layers to reduce computational overhead and improve transparency. We further enhance this design with an iterative BNN approach that incorporates a scalar mask and a phase-enhanced layer, enabling high-accuracy data recovery with fewer iterations. The experimental results on simulated and real-world radar datasets demonstrate that the proposed BNN framework significantly outperforms baseline methods in angle spectrum estimation and data interpolation while maintaining low computational complexity. These findings highlight the potential of BNNs as a practical, interpretable, and scalable alternative for advanced automotive radar applications.
- 11 August 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Radar Systems
- Vol. 3, 1103-1118
Broad Neural Networks for Sparse Signal Retrieval and Array Interpolation in Automotive Radar
Sparse antenna arrays are widely used in automotive radar systems to achieve high angular resolution with reduced hardware complexity and mutual coupling. However, the high sidelobes inherent in sparse configurations can degrade angle estimation accuracy, motivating the need for effective interpolation methods. Although deep neural networks (DNNs) have shown strong performance in sparse signal recovery, their deployment is hindered by high computational cost, complex activation functions, and limited interpretability due to deep-layer architectures. To address these challenges, we propose a novel framework based on broad neural networks (BNNs) for efficient and accurate sparse signal retrieval. Unlike conventional DNNs, BNNs utilize parallel network structures with simplified, custom-designed activation functions, eliminating hidden layers to reduce computational overhead and improve transparency. We further enhance this design with an iterative BNN approach that incorporates a scalar mask and a phase-enhanced layer, enabling high-accuracy data recovery with fewer iterations. The experimental results on simulated and real-world radar datasets demonstrate that the proposed BNN framework significantly outperforms baseline methods in angle spectrum estimation and data interpolation while maintaining low computational complexity. These findings highlight the potential of BNNs as a practical, interpretable, and scalable alternative for advanced automotive radar applications.
- 11 April 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Aerospace and Electronic Systems
- Vol. 60 (2) , 2490
Erratum to “Bayesian Linear Regression With Cauchy Prior and Its Application in Sparse MIMO Radar”
Presents corrections to the paper, Bayesian Linear Regression With Cauchy Prior and Its Application in Sparse MIMO Radar.
- 11 April 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Aerospace and Electronic Systems
- Vol. 60 (2) , 2490
Erratum to “Bayesian Linear Regression With Cauchy Prior and Its Application in Sparse MIMO Radar”
Presents corrections to the paper, Bayesian Linear Regression With Cauchy Prior and Its Application in Sparse MIMO Radar.
- 3 October 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Aerospace and Electronic Systems
- Vol. 59 (6) , 9576-9597
Bayesian Linear Regression With Cauchy Prior and Its Application in Sparse MIMO Radar
In this paper, a sparse signal recovery algorithm using Bayesian linear regression with Cauchy prior (BLRC) is proposed. Utilizing an approximate expectation maximization (AEM) scheme, a systematic hyper-parameter updating strategy is developed to make BLRC practical in highly dynamic scenarios. Remarkably, with a more compact latent space, BLRC not only possesses essential features of the well-known sparse Bayesian learning (SBL) and iterative reweighted $l_{2}$ (IR- $l_{2}$ ) algorithms but also outperforms them. Using sparse array (SPA) and coprime array (CPA), numerical analyses are first performed to show the superior performance of BLRC under various noise levels, array sizes, and sparsity levels. Applications of BLRC to sparse multiple-input and multiple-output (MIMO) radar array signal processing are then carried out to show that the proposed BLRC can efficiently produce high-resolution images of the targets.
- 3 October 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Aerospace and Electronic Systems
- Vol. 59 (6) , 9576-9597
Bayesian Linear Regression With Cauchy Prior and Its Application in Sparse MIMO Radar
In this paper, a sparse signal recovery algorithm using Bayesian linear regression with Cauchy prior (BLRC) is proposed. Utilizing an approximate expectation maximization (AEM) scheme, a systematic hyper-parameter updating strategy is developed to make BLRC practical in highly dynamic scenarios. Remarkably, with a more compact latent space, BLRC not only possesses essential features of the well-known sparse Bayesian learning (SBL) and iterative reweighted $l_{2}$ (IR- $l_{2}$ ) algorithms but also outperforms them. Using sparse array (SPA) and coprime array (CPA), numerical analyses are first performed to show the superior performance of BLRC under various noise levels, array sizes, and sparsity levels. Applications of BLRC to sparse multiple-input and multiple-output (MIMO) radar array signal processing are then carried out to show that the proposed BLRC can efficiently produce high-resolution images of the targets.
- Open Access
Bayesian Linear Regression with Cauchy Prior and Its Application in Sparse MIMO Radar
In this paper, a sparse signal recovery algorithm using Bayesian linear regression with Cauchy prior (BLRC) is proposed. Utilizing an approximate expectation maximization(AEM) scheme, a systematic hyper-parameter updating strategy is developed to make BLRC practical in highly dynamic scenarios. Remarkably, with a more compact latent space, BLRC not only possesses essential features of the well-known sparse Bayesian learning (SBL) and iterative reweighted l2 (IR-l2) algorithms but also outperforms them. Using sparse array (SPA) and coprime array (CPA), numerical analyses are first performed to show the superior performance of BLRC under various noise levels, array sizes, and sparsity levels. Applications of BLRC to sparse multiple-input and multiple-output (MIMO) radar array signal processing are then carried out to show that the proposed BLRC can efficiently produce high-resolution images of the targets.
Open AccessBayesian Linear Regression with Cauchy Prior and Its Application in Sparse MIMO Radar
In this paper, a sparse signal recovery algorithm using Bayesian linear regression with Cauchy prior (BLRC) is proposed. Utilizing an approximate expectation maximization(AEM) scheme, a systematic hyper-parameter updating strategy is developed to make BLRC practical in highly dynamic scenarios. Remarkably, with a more compact latent space, BLRC not only possesses essential features of the well-known sparse Bayesian learning (SBL) and iterative reweighted l2 (IR-l2) algorithms but also outperforms them. Using sparse array (SPA) and coprime array (CPA), numerical analyses are first performed to show the superior performance of BLRC under various noise levels, array sizes, and sparsity levels. Applications of BLRC to sparse multiple-input and multiple-output (MIMO) radar array signal processing are then carried out to show that the proposed BLRC can efficiently produce high-resolution images of the targets.
- 12 January 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 57-60
Via-Less Waveguide-to-Stripline Transition Using 2D Electromagnetic Bandgap Structure
A novel waveguide-to-stripline transition utilizing an electromagnetic bandgap (EBG) structure is presented. The proposed transition, which does not require vias or waveguide shorts, delivers a simpler implementation option and allows the stripline to be mounted directly to the flange of a waveguide. The EBG structure is added to suppress parallel plate mode propagation and to ensure the transition can maintain the desired performance when used with arbitrary board dimensions. A 1.0dB insertion loss from 10.6GHz to 11.5GHz and a 10dB return loss bandwidth of 8.1% are achieved and verified by measurement.
- 12 January 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 57-60
Via-Less Waveguide-to-Stripline Transition Using 2D Electromagnetic Bandgap Structure
A novel waveguide-to-stripline transition utilizing an electromagnetic bandgap (EBG) structure is presented. The proposed transition, which does not require vias or waveguide shorts, delivers a simpler implementation option and allows the stripline to be mounted directly to the flange of a waveguide. The EBG structure is added to suppress parallel plate mode propagation and to ensure the transition can maintain the desired performance when used with arbitrary board dimensions. A 1.0dB insertion loss from 10.6GHz to 11.5GHz and a 10dB return loss bandwidth of 8.1% are achieved and verified by measurement.