NVNejc Vovk

Nejc Vovk

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Nejc Vovk has a total of 44 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Fluctuations, Clustering, and Interaction-Driven Dynamics in Sedimenting Particles at Low Galileo Numbers: A Neural Network Approach

    by Nejc Vovk, Jana Wedel, Paul Steinmann, Jure Ravnik

    In this study, we investigate the behaviour of sedimenting solid particles and the influence of microscopic particle dynamics on the collective motion of a sedimenting cloud. Departing from conventional direct numerical simulations (DNS), we introduce a novel machine learning framework, the Interaction-Decomposed Neural Network (IDNN), to model hydrodynamic particle interactions. The IDNN acts as a black-box module within a Lagrangian solver, predicting the particle drag force based on the relative positions of the nearest neighbours. This enables the recovery of force fluctuations, capturing effects previously accessible only through DNS. Our results show an increase in collective settling velocity in the dilute regime, consistent with earlier experimental and numerical studies, which we attribute to (i) fluctuations in the streamwise particle force around a value that is lower than the Stokes limit and (ii) the formation of particle clusters sedimenting at enhanced velocities. These fluctuations originate from persistent entrainment and ejection of particles in and out of the long, diffusive wakes generated by upstream particles at low Galileo numbers. Energy spectra of particle velocity fluctuations reveal a scale-dependent transfer of fluctuation energy, analogous to a turbulent-like cascade, with pronounced large-scale fluctuations at higher volume fractions. At very low volume fractions, fluctuation intensity and energy spectrum amplitudes diminish, though hydrodynamic interactions still remain appreciable.

  • Open Access

    Comparison of 1D Euler Equation Based and 3D Navier-Stokes Simulation Methods for Water Hammer Phenomena

    by Nejc Vovk, Jure Ravnik

    Water hammer phenomena in pipelines can induce significant transient pressure surges, leading to structural failures and operational inefficiencies. This study presents a comparative analyzis of two numerical approaches for simulating water hammer: a one-dimensional (1D) inviscid model with added friction based on the Euler equations and the method of characteristics, and a three-dimensional (3D) viscous model utilizing the Navier-Stokes equations in OpenFOAM. Benchmarking problems are solved first, then both methods are used to study a 3.4 km long DN400 pipeline subject to sudden pump failure by analyzing pressure surges, cavitation, and water column separation. The 1D model effectively predicts transient pressure waves and cavitation conditions with minimal computational cost, while the 3D model provides a detailed representation of multiphase flow dynamics, including cavitation bubble growth and collapse via the volume of fluid method. To mitigate adverse effects, a dynamic combination air valve is introduced, and its effectiveness in reducing pressure surges and cavitation is demonstrated. The results highlight the trade-offs between computational efficiency and accuracy in modelling water hammer events and underscore the importance of protective measures in pipeline systems.


  • Open Access

    Euler–Euler Numerical Model for Transport Phenomena Modeling in a Natural Circulation Loop Operated by Nanofluids

    by Blaž Kamenik, Nejc Vovk, Elif Begum Elcioglu, Firat Sezgin, Erdem Ozyurt, Ziya Haktan Karadeniz, Alpaslan Turgut, Jure Ravnik

    This paper explores a computational approach to model multiphase heat transfer and fluid flow in a natural circulation loop utilizing nanofluids. We propose and implement an Euler–Euler framework in a CFD environment, incorporating an innovative boundary condition to preserve mass conservation during thermophoretic particle flux. The model’s accuracy is verified through a one-dimensional example, by comparing results against both an Euler–Lagrange model and an in-house finite volume solution. Experimental validation is conducted with aluminum oxide nanofluids at varying nanoparticle concentrations. We prepared the nanofluids and measured their thermophysical properties up to $$60^\circ$$ 60 ∘ C. We assess the thermal performance of the nanofluid in natural circulation loop at different heating powers via experiment and numerical simulations. The findings reveal that the heat transfer enhancement offered by the nanofluid is modest, with minimal differences observed between the proposed Euler–Euler approach and a simpler single-phase model. The results underscore that while the Euler–Euler model offers detailed particle–fluid interactions, its practical thermal advantage is limited in this context.


  • Computational fluid dynamics challenge on indoor dispersion of pathogen-laden aerosols

    by Jordi Pallares, Alexandre Fabregat, Akim Lavrinenko, Nelson Marques, Bruno Santos, Gabriele Mosca, Pedro Obando Vega, Jure Ravnik, Nejc Vovk, Bruño Fraga, et al.

    This paper presents and discusses the results of the “2024 International Computational Fluid Dynamics Challenge on the long-range indoor dispersion of pathogen-laden aerosols” aimed at assessing the ability of different computational codes and turbulence models to reproduce the dispersion of particles produced by a turbulent natural convection flow enclosed in a room sized cubical cavity. A total of 12 research groups from ten different countries have conducted 15 simulations of the same flow configuration by solving the Reynolds averaged Navier–Stokes (RANS) equations, the unsteady Reynolds averaged Navier–Stokes (URANS) equations or using scale adaptive simulations (SAS), large-eddy simulations (LES), or hybrid (URANS-LES) techniques. Results for the velocity field and the particle dispersion provided by the different simulations are compared extensively, including the reference results provided by a direct numerical simulation (DNS). In general, LES and hybrid methods reproduce the time-averaged flow field correctly, the spatial distribution of the turbulence kinetic energy, and the particle dispersion. The performance of SAS is similar to that of LES and hybrid methods while the predictions of the RANS and URANS simulations exhibit larger deviations with respect to DNS. In general, the particle dispersion is better reproduced by simulations that capture correctly the spatial distribution of the turbulence kinetic energy.


  • Open Access

    Numerical Modeling of Two-Phase Flow inside a Wet Flue Gas Absorber Sump

    by Nejc Vovk, Jure Ravnik

    A numerical model of a flue gas scrubber sump is developed with the aim of enabling optimization of the design of the sump in order to reduce energy consumption. In this model, the multiphase flow of the continuous phase, i.e., water, and the dispersed phase, i.e., air bubbles, is considered. The air that is blown in front of the agitators, as well as the influence of the flow field of the agitators on the distribution of the dispersed phase and the recirculation pumps as outlet, is modeled. The bubble Sauter mean diameter is modeled using the population balance model. The model is used to analyze operating parameters such as the bubble retention time, the average air volume fraction, bubble Sauter mean diameter, the local distribution of the bubble size and the amount of air escaping from the pump outlets at two operating points. The purpose of the model is to simulate the two-phase flow in the sump of the flue gas scrubber using air dispersion technology with a combination of spargers and agitators, which, when optimized, reduces energy consumption by 33%. The results show that the homogeneity of air is lower in the bottom part of the absorber sump and that the amount of air escaping through recirculation pipes equals 1.2% of the total air blown into the absorber sump. The escaping air consists mainly of bubbles smaller than 6 mm. Additional operating point results show that halving the magnitude of the linear momentum source lowers the air retention, as well as the average homogeneity of the dispersed air.