Junho Hwang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Junho Hwang has a total of 34 co-authors. Here are the top co-authors by number of shared publications:
- Wooyoung Lee
Department of Materials Science and Engineering , Yonsei University, 50 Yonsei-ro, Seodaemun-gu, Seoul, 120-749, Korea (the Republic of)
3 shared publications - Donghwi Cho
Korea Research Institute of Chemical Technology
2 shared publications Hyun-Sook Lee
2 shared publications- Kwangjae Lee
Department of Information Security Engineering Sang Myung University Cheonan-si Chungcheongnam-do 31066 Republic of Korea
2 shared publications Dohyeon Shin
1 shared publication- Dong-Hyuk Park
Department of Sport Industry Studies, Yonsei University, Seoul, Korea
1 shared publication
Latest Publications
- Open Access
- 4 August 2026
- Published by Elsevier in SSRN Electronic Journal
Self-Enhancing and Thermally Robust Dual-Mode Hydrogen Sensors via Percolation-Engineered Corrugated Pd Nanostructures
Palladium (Pd)-based nanogap hydrogen sensors are essential for the safety of Fuel Cell Electric Vehicles (FCEVs). but typically suffer from severe thermal instability at elevated temperatures due to the coefficient of thermal expansion (CTE) mismatch between the metal film and elastomeric substrates. Here, we report a percolation-engineered corrugated Pd nanostructure where the sensing modality is fundamentally governed by a structural percolation transition. A critical percolation threshold is identified at a Pd thickness of t = 20 nm, marking the transition from an electrically disconnected regime to a partially percolated conductive network. This unique architecture enables dual-mode sensing, combining abrupt on-off switching for rapid safety alarms at high concentrations (~ 4% H2) with continuous, linear responses for high-resolution monitoring at low-ppm levels. The optimized 20 nm sensor demonstrates a broad detection range from 5 ppm to 4% H2, with superior signal amplification (> 400%) and rapid response times (~ 1.5–2 s) under air even at elevated temperatures. Notably, the device exhibits self-enhancing reliability during repeated hydrogen cycling; structural refinement narrows the nanogaps from 126 nm to 45.4 nm, which maintains a stable hydrogen-exposed resistance (RH) while progressively increasing the signal contrast. These findings establish a robust structural design rule for developing self-enhancing and thermally robust, dual-mode hydrogen sensors capable of stable operation up to 150 °C in demanding automotive and industrial environments.
- 4 August 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessSelf-Enhancing and Thermally Robust Dual-Mode Hydrogen Sensors via Percolation-Engineered Corrugated Pd Nanostructures
Palladium (Pd)-based nanogap hydrogen sensors are essential for the safety of Fuel Cell Electric Vehicles (FCEVs). but typically suffer from severe thermal instability at elevated temperatures due to the coefficient of thermal expansion (CTE) mismatch between the metal film and elastomeric substrates. Here, we report a percolation-engineered corrugated Pd nanostructure where the sensing modality is fundamentally governed by a structural percolation transition. A critical percolation threshold is identified at a Pd thickness of t = 20 nm, marking the transition from an electrically disconnected regime to a partially percolated conductive network. This unique architecture enables dual-mode sensing, combining abrupt on-off switching for rapid safety alarms at high concentrations (~ 4% H2) with continuous, linear responses for high-resolution monitoring at low-ppm levels. The optimized 20 nm sensor demonstrates a broad detection range from 5 ppm to 4% H2, with superior signal amplification (> 400%) and rapid response times (~ 1.5–2 s) under air even at elevated temperatures. Notably, the device exhibits self-enhancing reliability during repeated hydrogen cycling; structural refinement narrows the nanogaps from 126 nm to 45.4 nm, which maintains a stable hydrogen-exposed resistance (RH) while progressively increasing the signal contrast. These findings establish a robust structural design rule for developing self-enhancing and thermally robust, dual-mode hydrogen sensors capable of stable operation up to 150 °C in demanding automotive and industrial environments.
- Open Access
- 3 February 2025
- Published by Elsevier in Applied Surface Science
- Vol. 690
Fast-responding ethanol sensor with extremely low detection limit: Influence of Pt film thickness on gas sensing properties
- 3 February 2025
- Published by Elsevier in Applied Surface Science
- Vol. 690
Open AccessFast-responding ethanol sensor with extremely low detection limit: Influence of Pt film thickness on gas sensing properties
- 18 January 2024
- Published by IOP Publishing in Journal of Breath Research
- Vol. 18 (2) , 026001
Effectiveness of breath acetone monitoring in reducing body fat and improving body composition: a randomized controlled study
When attempts to lose body fat mass frequently fail, breath acetone (BA) monitoring may assist fat mass loss during a low-carbohydrate diet as it can provide real-time body fat oxidation levels. This randomized controlled study aimed to evaluate the effectiveness of monitoring BA levels and providing feedback on fat oxidation during a three-week low-carbohydrate diet intervention. Forty-seven participants (mean age = 27.8 ± 4.4 years, 53.3% females, body mass index = 24.1 ± 3.4 kg m−2) were randomly assigned to three groups (1:1:1 ratio): daily BA assessment with a low-carbohydrate diet, body weight assessment (body scale (BS)) with a low-carbohydrate diet, and low-carbohydrate diet only. Primary outcome was the change in fat mass and secondary outcomes were the changes in body weight and body composition. Forty-five participants completed the study (compliance rate: 95.7%). Fat mass was significantly reduced in all three groups (all P < 0.05); however, the greatest reduction in fat mass was observed in the BA group compared to the BS (differences in changes in fat mass, −1.1 kg; 95% confidence interval: −2.3, −0.2; P = 0.040) and control (differences in changes in fat mass, −1.3 kg; 95% confidence interval: −2.1, −0.4; P = 0.013) groups. The BA group showed significantly greater reductions in body weight and visceral fat mass than the BS and control groups (all P < 0.05). In addition, the percent body fat and skeletal muscle mass were significantly reduced in both BA and BS groups (all P < 0.05). However, no significant differences were found in changes in body fat percentage and skeletal muscle mass between the study groups. Monitoring BA levels, which could have motivated participants to adhere more closely to the low-carbohydrate diet, to assess body fat oxidation rates may be an effective intervention for reducing body fat mass (compared to body weight assessment or control conditions). This approach could be beneficial for individuals seeking to manage body fat and prevent obesity.
- 18 January 2024
- Published by IOP Publishing in Journal of Breath Research
- Vol. 18 (2) , 026001
Effectiveness of breath acetone monitoring in reducing body fat and improving body composition: a randomized controlled study
When attempts to lose body fat mass frequently fail, breath acetone (BA) monitoring may assist fat mass loss during a low-carbohydrate diet as it can provide real-time body fat oxidation levels. This randomized controlled study aimed to evaluate the effectiveness of monitoring BA levels and providing feedback on fat oxidation during a three-week low-carbohydrate diet intervention. Forty-seven participants (mean age = 27.8 ± 4.4 years, 53.3% females, body mass index = 24.1 ± 3.4 kg m−2) were randomly assigned to three groups (1:1:1 ratio): daily BA assessment with a low-carbohydrate diet, body weight assessment (body scale (BS)) with a low-carbohydrate diet, and low-carbohydrate diet only. Primary outcome was the change in fat mass and secondary outcomes were the changes in body weight and body composition. Forty-five participants completed the study (compliance rate: 95.7%). Fat mass was significantly reduced in all three groups (all P < 0.05); however, the greatest reduction in fat mass was observed in the BA group compared to the BS (differences in changes in fat mass, −1.1 kg; 95% confidence interval: −2.3, −0.2; P = 0.040) and control (differences in changes in fat mass, −1.3 kg; 95% confidence interval: −2.1, −0.4; P = 0.013) groups. The BA group showed significantly greater reductions in body weight and visceral fat mass than the BS and control groups (all P < 0.05). In addition, the percent body fat and skeletal muscle mass were significantly reduced in both BA and BS groups (all P < 0.05). However, no significant differences were found in changes in body fat percentage and skeletal muscle mass between the study groups. Monitoring BA levels, which could have motivated participants to adhere more closely to the low-carbohydrate diet, to assess body fat oxidation rates may be an effective intervention for reducing body fat mass (compared to body weight assessment or control conditions). This approach could be beneficial for individuals seeking to manage body fat and prevent obesity.