Zhijian Zhang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Zhijian Zhang has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- Jian Chao Pang
Shenyang National Laboratory for Materials Science, Institute of Metal Research, Chinese Academy of Sciences, 72 Wenhua Road, Shenyang 110016, China
1 shared publication Jianying Li
State Key Laboratory of Electrical Insulation and Power Equipment, Xi’an Jiaotong University, Xi’an 710049, China
1 shared publication- Jin‐Yong Dong
CAS Key Laboratory of Engineering Plastics, Institute of Chemistry, Chinese Academy of Sciences, Beijing, China
1 shared publication Kai Yang
State Key Laboratory of Electrical Insulation and Power Equipment, Xi’an Jiaotong University, Xi’an 710049, China
1 shared publicationS. X. Li
Shenyang National Laboratory for Materials Science, Institute of Metal Research, Chinese Academy of Sciences, 72 Wenhua Road, Shenyang 110016, China
1 shared publication
Latest Publications
- 7 February 2024
- Published by American Chemical Society (ACS) in ACS Applied Polymer Materials
- Vol. 6 (4) , 2210-2222
Simultaneous Promotion of the Mechanical Flexibility and Dielectric Strength of Impact Polypropylene Copolymers Containing Multifold H-Shape Long-Chain-Branching Structures for Recyclable Power Cable Insulation Application
- 7 February 2024
- Published by American Chemical Society (ACS) in ACS Applied Polymer Materials
- Vol. 6 (4) , 2210-2222
Simultaneous Promotion of the Mechanical Flexibility and Dielectric Strength of Impact Polypropylene Copolymers Containing Multifold H-Shape Long-Chain-Branching Structures for Recyclable Power Cable Insulation Application
- 15 July 2012
- Published by Wiley in Fatigue & Fracture of Engineering Materials & Structures
- Vol. 36 (2) , 168-176
High‐cycle fatigue and fracture behaviours of Cu‐Be alloy with a wide strength range
The high‐cycle fatigue and fracture behaviours of Cu‐Be alloy with tensile strength ranging from 500 to 1300 MPa acquired by different treatments were studied. Fatigue crack initiation, fracture surface morphologies, S‐N curves and fatigue strength show obvious differences due to the change of microstructure. At relatively low‐strength level, some fatigue cracks originated from defects; while at high‐strength level, all the fatigue cracks initiated from cleavage facets. It was found that the fatigue ratio increases linearly and fatigue strength changes quadratically with increasing tensile strength, only considering one strengthening mechanism. Finally, the fatigue strengths of various Cu‐Be alloys were summarized.
- 15 July 2012
- Published by Wiley in Fatigue & Fracture of Engineering Materials & Structures
- Vol. 36 (2) , 168-176
High‐cycle fatigue and fracture behaviours of Cu‐Be alloy with a wide strength range
The high‐cycle fatigue and fracture behaviours of Cu‐Be alloy with tensile strength ranging from 500 to 1300 MPa acquired by different treatments were studied. Fatigue crack initiation, fracture surface morphologies, S‐N curves and fatigue strength show obvious differences due to the change of microstructure. At relatively low‐strength level, some fatigue cracks originated from defects; while at high‐strength level, all the fatigue cracks initiated from cleavage facets. It was found that the fatigue ratio increases linearly and fatigue strength changes quadratically with increasing tensile strength, only considering one strengthening mechanism. Finally, the fatigue strengths of various Cu‐Be alloys were summarized.