Zhange Feng
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Zhange Feng has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Katherine Betts
University of Nevada, Las Vegas
4 shared publications Kidus Yohannes
Department of Chemistry and Biochemistry, University of Nevada, Las Vegas, Las Vegas, Nevada 89154, United States of America
2 shared publicationsMichael Frailey
Department of Chemistry and Biochemistry, University of Nevada, Las Vegas, Las Vegas, Nevada 89154, United States of America
2 shared publicationsYuhan Jiang
Department of Chemistry and Biochemistry
2 shared publicationsAndrew Yanagimachi
Department of Chemistry and Biochemistry
1 shared publication- Bryan Jacome
University of Nevada, Las Vegas
1 shared publication
Latest Publications
- 18 July 2025
- Published by American Chemical Society (ACS) in Analytical Chemistry
- Vol. 97 (29) , 15762-15770
Potential-Dependent SEIRAS Study of PFAS Surface Adsorption
Per- and polyfluoroalkyl substances (PFAS) and their bioaccumulation are growing priorities for water remediation efforts. Using surface-enhanced infrared absorption spectroscopy (SEIRAS), our measurements allowed observations of PFAS adsorption in response to surface charge. Increased adsorption of perfluorooctanoic acid (PFOA) was observed at positive potentials via the molecule's hydrophobic long-chain carbon-fluorine tail, despite the electronegativity of the carboxylic acid head. This behavior was observed at pH 2, 3, and 4, with a continued lay-flat orientation of the surface molecules due to the dominance of the hydrophobic interaction versus electrostatic interaction. Potential cycling demonstrated weak adsorption hysteresis, and a disruption of surface interactions was observed in the presence of potassium bromide. For comparison, perfluorooctanesulfonate (PFOS) was also tested and observed to adsorb via the hydrophobic carbon-fluorine tail. Time-dependent adsorption behavior for PFOS was noted, with a higher pH solution showing a higher rate of surface adsorption. These findings demonstrate the complexities involved in the competition between electrostatic and hydrophobic interactions and contribute to future innovation in electrosorption methods for remediation of PFAS contamination.
- 18 July 2025
- Published by American Chemical Society (ACS) in Analytical Chemistry
- Vol. 97 (29) , 15762-15770
Potential-Dependent SEIRAS Study of PFAS Surface Adsorption
Per- and polyfluoroalkyl substances (PFAS) and their bioaccumulation are growing priorities for water remediation efforts. Using surface-enhanced infrared absorption spectroscopy (SEIRAS), our measurements allowed observations of PFAS adsorption in response to surface charge. Increased adsorption of perfluorooctanoic acid (PFOA) was observed at positive potentials via the molecule's hydrophobic long-chain carbon-fluorine tail, despite the electronegativity of the carboxylic acid head. This behavior was observed at pH 2, 3, and 4, with a continued lay-flat orientation of the surface molecules due to the dominance of the hydrophobic interaction versus electrostatic interaction. Potential cycling demonstrated weak adsorption hysteresis, and a disruption of surface interactions was observed in the presence of potassium bromide. For comparison, perfluorooctanesulfonate (PFOS) was also tested and observed to adsorb via the hydrophobic carbon-fluorine tail. Time-dependent adsorption behavior for PFOS was noted, with a higher pH solution showing a higher rate of surface adsorption. These findings demonstrate the complexities involved in the competition between electrostatic and hydrophobic interactions and contribute to future innovation in electrosorption methods for remediation of PFAS contamination.
- Open Access
- 1 April 2025
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 172 (4) , 040521
In Situ Double Probe Beam Deflection Estimating Concentration Profiles of Battery Electrolytes
An in situ double probe beam deflection (PBD) technique has been developed using two laser beams to map the concentration profile of the diffusion layer in an electrochemical cell. A microscale moving upper probe and a fixed position secondary beam offer real-time concentration gradients to be profiled throughout the depth of the diffusion layer. The double PBD technique was used to plot concentration profiles for 0.1 mol kg−1 CuSO4 and ZnSO4 within a range of applied currents, showing increased magnitudes of gradients for higher currents. Both single and double beam PBD were explored, demonstrating the distance and time dependence of the developing concentration gradient. While CuSO4 showed a systematic trend of increased response delay and decreased deflection with increased distance from the electrode, ZnSO4 experienced some additional phenomena affecting the refractive index within the diffusion layer. The in situ double probe beam deflection was shown to be highly sensitive and offers future work in quantifying charge migration within this important region of the electrochemical cell.
- 1 April 2025
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 172 (4) , 040521
Open AccessIn Situ Double Probe Beam Deflection Estimating Concentration Profiles of Battery Electrolytes
An in situ double probe beam deflection (PBD) technique has been developed using two laser beams to map the concentration profile of the diffusion layer in an electrochemical cell. A microscale moving upper probe and a fixed position secondary beam offer real-time concentration gradients to be profiled throughout the depth of the diffusion layer. The double PBD technique was used to plot concentration profiles for 0.1 mol kg−1 CuSO4 and ZnSO4 within a range of applied currents, showing increased magnitudes of gradients for higher currents. Both single and double beam PBD were explored, demonstrating the distance and time dependence of the developing concentration gradient. While CuSO4 showed a systematic trend of increased response delay and decreased deflection with increased distance from the electrode, ZnSO4 experienced some additional phenomena affecting the refractive index within the diffusion layer. The in situ double probe beam deflection was shown to be highly sensitive and offers future work in quantifying charge migration within this important region of the electrochemical cell.
- 4 November 2024
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 16 (45) , 63026-63038
Potential-Dependent ATR-SEIRAS and EQCM-D Analysis of Interphase Formation in Zinc Battery Electrolytes
With the heightening interest in bivalent battery technology, there arises a necessity for a thorough investigation into zinc-ion battery (ZIB) electrolytes, accommodating their chemical attributes and potential-dependent structural dynamics. While the phenomenon of in situ solid electrolyte interphase formation is extensively documented in lithium-ion batteries, its analogous occurrences in ZIBs remain limited. Herein is a comparative study of three zinc electrolytes of interest: ZnSO4, ZnOTF, and Zn(TFSI)2/LiTFSI hybrid water-in-salt electrolyte. Additionally, the impact of an acetonitrile additive is scrutinized, with a comparative assessment of the interfacial behavior in aqueous solutions. Utilizing ATR-SEIRAS, potential-dependent alterations in the composition of the electrolyte/electrode interface were monitored, while EQCM-D facilitated a comprehensive understanding of variations in the mass and structural properties of the adsorbed layer. Aqueous ZnSO4 demonstrated the accumulation of porous Zn4SO4(OH)6·xH2O at negative potentials, leading to a mass of 1.47 μg cm-2 after five cycles. Bisulfate formation was observed at positive potentials. SEIRAS measurements for ZnOTF demonstrated reorientation and surface adsorption of CF3SO3- to favor CF3 at the surface for positive potentials, and acetonitrile showed increased stability for the electrode at negative potentials. The additive was also reported to lead to the accumulation of a substantial passivation layer with viscoelastic properties. The zinc water-in-salt showed exceptional surface stability at negative potentials and a widened potential window. A thin rigid zinc SEI layer is reported with a mass of 0.7 μg cm-2. The compositional intricacies of these surface structures are discussed in relation to their solvent conditions. This investigation not only sheds light on the initial charge/discharge cycles in ZIBs but also underscores their pivotal role in instigating enduring transformations that can significantly influence their long-term cycling performance.
- 4 November 2024
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 16 (45) , 63026-63038
Potential-Dependent ATR-SEIRAS and EQCM-D Analysis of Interphase Formation in Zinc Battery Electrolytes
With the heightening interest in bivalent battery technology, there arises a necessity for a thorough investigation into zinc-ion battery (ZIB) electrolytes, accommodating their chemical attributes and potential-dependent structural dynamics. While the phenomenon of in situ solid electrolyte interphase formation is extensively documented in lithium-ion batteries, its analogous occurrences in ZIBs remain limited. Herein is a comparative study of three zinc electrolytes of interest: ZnSO4, ZnOTF, and Zn(TFSI)2/LiTFSI hybrid water-in-salt electrolyte. Additionally, the impact of an acetonitrile additive is scrutinized, with a comparative assessment of the interfacial behavior in aqueous solutions. Utilizing ATR-SEIRAS, potential-dependent alterations in the composition of the electrolyte/electrode interface were monitored, while EQCM-D facilitated a comprehensive understanding of variations in the mass and structural properties of the adsorbed layer. Aqueous ZnSO4 demonstrated the accumulation of porous Zn4SO4(OH)6·xH2O at negative potentials, leading to a mass of 1.47 μg cm-2 after five cycles. Bisulfate formation was observed at positive potentials. SEIRAS measurements for ZnOTF demonstrated reorientation and surface adsorption of CF3SO3- to favor CF3 at the surface for positive potentials, and acetonitrile showed increased stability for the electrode at negative potentials. The additive was also reported to lead to the accumulation of a substantial passivation layer with viscoelastic properties. The zinc water-in-salt showed exceptional surface stability at negative potentials and a widened potential window. A thin rigid zinc SEI layer is reported with a mass of 0.7 μg cm-2. The compositional intricacies of these surface structures are discussed in relation to their solvent conditions. This investigation not only sheds light on the initial charge/discharge cycles in ZIBs but also underscores their pivotal role in instigating enduring transformations that can significantly influence their long-term cycling performance.
- Open Access
- 1 November 2024
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 171 (11) , 112505
Fabrication of High-Performance Neural Stimulation Electrode through Pulsed Electrochemical Deposition of IrOx onto Nano-Porous Platinum
Electrodes for neural stimulation are pivotal in medical and brain science applications. This study aims to prepare novel neural stimulating electrodes with enhanced electrochemical performance and improved mechanical stability through a two-step electrochemical deposition process. Initially, a highly porous platinum (Porous-Pt) electrode with high nanoscale roughness is fabricated, followed by the incorporation of IrOx onto the Porous-Pt surface. The resulting IrOx/Porous-Pt electrode combines the advantages of both materials, offering low impedance, significantly increased CIC, and improved mechanical stability. Scanning electron microscopy revealed that the porous surface of the electrode consisting of sphere-shaped Pt nanoparticles offers a significant effective surface area, promoting strong adhesion and stability for uniform IrOx deposition onto Porous-Pt. This characteristic contributed to the long-term mechanical stability of the IrOx/Porous-Pt electrode.
- 1 November 2024
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 171 (11) , 112505
Open AccessFabrication of High-Performance Neural Stimulation Electrode through Pulsed Electrochemical Deposition of IrOx onto Nano-Porous Platinum
Electrodes for neural stimulation are pivotal in medical and brain science applications. This study aims to prepare novel neural stimulating electrodes with enhanced electrochemical performance and improved mechanical stability through a two-step electrochemical deposition process. Initially, a highly porous platinum (Porous-Pt) electrode with high nanoscale roughness is fabricated, followed by the incorporation of IrOx onto the Porous-Pt surface. The resulting IrOx/Porous-Pt electrode combines the advantages of both materials, offering low impedance, significantly increased CIC, and improved mechanical stability. Scanning electron microscopy revealed that the porous surface of the electrode consisting of sphere-shaped Pt nanoparticles offers a significant effective surface area, promoting strong adhesion and stability for uniform IrOx deposition onto Porous-Pt. This characteristic contributed to the long-term mechanical stability of the IrOx/Porous-Pt electrode.
- Open Access
- 1 February 2024
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 171 (2) , 020551
Refractive Laser Beam Measuring Diffusion Coefficient of Concentrated Battery Electrolytes
A thorough understanding of electrolyte transport properties is crucial in the development of alternative battery technology. As a key parameter, the diffusion coefficient offers important insights into the behavior of electrolytes, especially for fast charge of high-energy batteries. Existing methods of measurement are often limited by redox species or offer questionable accuracy due to side reactions and/or disruption of the diffusion profile. This work provides a novel optical method for measuring diffusion coefficients of liquid-phase concentrated battery electrolytes without electrochemical reactions. The method relies on the deflection of a refractive laser beam passing through an electrolyte of a minor concentration gradient in a triangular diffusion column. The diffusion coefficient, D, for a range of zinc sulfate electrolytes was successfully extracted by correlating the position of the laser beam to its concentration. Several other physicochemical properties of the same electrolytes are studied to correlate to the concentration-dependent diffusion coefficients, including viscosity, conductivity, and microstructure analysis based on vibrational spectroscopy (Infrared and Raman). Also included is the future application of the triangular column for in situ electrochemical measurements.
- 1 February 2024
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 171 (2) , 020551
Open AccessRefractive Laser Beam Measuring Diffusion Coefficient of Concentrated Battery Electrolytes
A thorough understanding of electrolyte transport properties is crucial in the development of alternative battery technology. As a key parameter, the diffusion coefficient offers important insights into the behavior of electrolytes, especially for fast charge of high-energy batteries. Existing methods of measurement are often limited by redox species or offer questionable accuracy due to side reactions and/or disruption of the diffusion profile. This work provides a novel optical method for measuring diffusion coefficients of liquid-phase concentrated battery electrolytes without electrochemical reactions. The method relies on the deflection of a refractive laser beam passing through an electrolyte of a minor concentration gradient in a triangular diffusion column. The diffusion coefficient, D, for a range of zinc sulfate electrolytes was successfully extracted by correlating the position of the laser beam to its concentration. Several other physicochemical properties of the same electrolytes are studied to correlate to the concentration-dependent diffusion coefficients, including viscosity, conductivity, and microstructure analysis based on vibrational spectroscopy (Infrared and Raman). Also included is the future application of the triangular column for in situ electrochemical measurements.