TTThomas Tenzler

Thomas Tenzler

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Thomas Tenzler has a total of 20 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Design of a monolithic source of photon pairs comprising a semiconductor laser and a Bragg reflection waveguide

    by Thomas Tenzler, Jan-Philipp Koester, Hans Wenzel, Thorsten Passow, Quankui Yang, Marko Härtelt, Andrea Knigge

    We propose a monolithic, electrically driven source of photon pairs based on a nonlinear AlGaAs Bragg reflection waveguide and a laser structure stacked on top. By introducing lateral tapers, the fundamental mode of the lasing waveguide is vertically coupled into a higher-order mode of the Bragg reflection waveguide (Bragg mode) such that photon pairs can be generated through a type-II spontaneous parametric down-conversion process. According to numerical simulations, a coupling efficiency of 28% is achieved between both modes. Phase matching the Bragg mode with two fundamental modes at 1550 nm results in a photon pair rate of 1.7⋅10 8 pairs/s for a 2 mm long device, assuming 1 mW of power in the Bragg mode. Since the Bragg reflection waveguide does not require doping for this vertically coupled structure, free-carrier absorption losses and parasitic luminescence are avoided.

  • Open Access

    Theoretical study of Bragg reflection waveguide laser structures with surface gratings for spontaneous parametric down conversion

    by Thomas Tenzler, Jan-Philipp Koester, Hans Wenzel

    Bragg reflection waveguides (BRW) enable the generation of photon pairs in non-birefringent AlGaAs through spontaneous parametric down conversion (SPDC). Furthermore, the development of an electrically driven laser source from a passive BRW by introducing a suitable doping profile and an active region allows the simultaneous lasing of the pump field and the SPDC process within the same cavity. Here, we present an optimized design of a BRW to allow lasing at 775 nm and simultaneous conversion into photon pairs at 1550 nm. Based on the computed modes at 775 nm and 1550 nm, the non-linear emission characteristics of both SPDC and second harmonic generation of the proposed device is calculated. The design is particularly optimized regarding the monolithic integration of a distributed Bragg reflector (DBR) section to stabilize the laser wavelength. This is necessary because SPDC is highly sensitive to the pump wavelength. By using an eigenmode expansion approach, we calculate the reflection spectra of a 1 mm long, 9th order surface grating in dependence of various parameters. We demonstrate that a peak reflectivity of > 80% can be achieved with technologically feasible etch depths and groove widths. This paves the way for the promising application of DBR surface gratings for the selection of the pump wavelength for the SPDC process in BRW lasers, with the objective of improving the photon output.


  • Open Access

    Tunable and Wavelength‐Stabilised Laser Based on a Bragg Reflection Waveguide for Spontaneous Parametric Down Conversion

    by Thomas Tenzler, Christof Zink, Jörg Fricke, Pietro Della Casa, Jos Boschker, Maximilian Schäfer, Hans Wenzel, Andrea Knigge

    Bragg reflection waveguide lasers offer compact solutions for the generation of photon pairs through spontaneous parametric down conversion, by simultaneously generating the lasing pump light and converting it into photon pairs within the same device. However, the acceptance bandwidth of the lasing light for this conversion process is small, which makes free‐runnning Fabry–Pérot lasers with no wavelength stabilisation less suitable for nonlinear processes. We present the emission characteristics of a Bragg reflection ridge waveguide laser where a surface Bragg grating is implemented in one segment of the device. The lasing wavelength, determined by the Bragg condition, can be adjusted by the period of the grating between 775 and 785 nm. Furthermore, a micro heater in the grating section enables additional tuning of the lasing wavelength by 2 nm.


  • Open Access

    GaAs-based photonic integrated circuit platform enabling monolithic ring-resonator-coupled lasers

    by Jan-Philipp Koester, Hans Wenzel, Jörg Fricke, Matthias Reggentin, Pietro Della Casa, Poojitha Sammeta, Olaf Brox, Michael Ekterai, Mario Kohlbrenner, Andreas Renkewitz, et al.

    This paper reports on a monolithically integrated gallium arsenide (GaAs)-based photonic integrated circuit platform for wavelengths around 1064 nm. Enabled by spatially selective quantum well removal and two-step epitaxial growth, it supports on-chip gain as well as passive waveguides. In addition, shallow- and deep-etched waveguides are realized. The former result in waveguide losses of less than 2 dB/cm, while the latter enable compact integrated waveguide components. To demonstrate the performance of the platform, racetrack ring resonators based on deep-etched Euler bends and shallow-etched directional couplers are realized, achieving high intrinsic quality factors of 2.6 × 105 and 3.2 × 105 for the fundamental TE and TM mode, respectively. To demonstrate the use of these resonators, ring-resonator-coupled lasers are fabricated, resulting in one-sided output powers of up to 14 mW and single-mode operation with 40 dB side-mode suppression. The successful integration of ring resonators on a GaAs-based active/passive photonic integrated circuit platform paves the way for the realization of fully monolithic, widely tunable, and narrow linewidth ring-resonator-coupled laser sources.


  • Suppression and amplification of phonon sidebands in transition metal dichalcogenides by optical feedback

    by Thomas Tenzler, Andreas Knorr, Manuel Katzer

    Transition metal dichalcogenides (TMDCs) combine both strong light-matter interaction and strong Coulomb interaction for the formation of optically excitable excitons. Through radiative feedback control, a mechanism to control the linewidth can be applied, which modifies optical transition spectra. Here, we extend these investigations to the absorption spectra of TMDCs in a variety of geometries with respect to non-Markovian exciton-phonon-scattering contributions. Our approach is based on the self-consistent solution of the microscopic Bloch equations and the macroscopic solution of the wave equation. We discuss the formation of a phonon sideband for MoSe2 embedded in SiO2, and two setups for enhancing or suppressing the phonon sideband in the spectrum.

  • Open Access

    Suppression and amplification of phonon sidebands in transition metal dichalcogenides by optical feedback

    by Thomas Tenzler, Andreas Knorr, Manuel Katzer

    Transition metal dichalcogenides (TMDCs) combine both strong light-matter-interaction and strong Coulomb-interaction for the formation of optically excitable excitons. Through radiative feedback control, a mechanism to control the linewidth can be applied, which modifies optical transition spectra. Here, we extend these investigations to the absorption spectra of TMDCs in a variety of geometries with respect to non-Markovian exciton-phonon-scattering contributions. Our approach is based on the self consistent solution of the microscopic Bloch equations and the macroscopic solution of the wave equation. We discuss the formation of a phonon sideband for MoSe$_2$ embedded in SiO$_2$, and two setups for enhancing or suppressing the phonon sideband in the spectrum.