Christof Zink
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Christof Zink has a total of 27 co-authors. Here are the top co-authors by number of shared publications:
- Jörg Fricke
Ferdinand-Braun-Institut (FBH), Berlin, Germany
4 shared publications - Andrea Knigge
Ferdinand-Braun-Institut (FBH)
3 shared publications - Hans Wenzel
Ferdinand-Braun-Institut (FBH)
3 shared publications - Jos Emiel Boschker
Ferdinand-Braun-Institut (FBH)
2 shared publications - Pietro Della Casa
Ferdinand-Braun-Institut (FBH), Berlin, Germany
2 shared publications - Thomas Tenzler
Ferdinand-Braun-Institut (FBH)
2 shared publications
Latest Publications
- Open Access
- 1 January 2025
- Published by Institution of Engineering and Technology (IET) in Electronics Letters
- Vol. 61 (1)
Tunable and Wavelength‐Stabilised Laser Based on a Bragg Reflection Waveguide for Spontaneous Parametric Down Conversion
Bragg reflection waveguide lasers offer compact solutions for the generation of photon pairs through spontaneous parametric down conversion, by simultaneously generating the lasing pump light and converting it into photon pairs within the same device. However, the acceptance bandwidth of the lasing light for this conversion process is small, which makes free‐runnning Fabry–Pérot lasers with no wavelength stabilisation less suitable for nonlinear processes. We present the emission characteristics of a Bragg reflection ridge waveguide laser where a surface Bragg grating is implemented in one segment of the device. The lasing wavelength, determined by the Bragg condition, can be adjusted by the period of the grating between 775 and 785 nm. Furthermore, a micro heater in the grating section enables additional tuning of the lasing wavelength by 2 nm.
- 1 January 2025
- Published by Institution of Engineering and Technology (IET) in Electronics Letters
- Vol. 61 (1)
Open AccessTunable and Wavelength‐Stabilised Laser Based on a Bragg Reflection Waveguide for Spontaneous Parametric Down Conversion
Bragg reflection waveguide lasers offer compact solutions for the generation of photon pairs through spontaneous parametric down conversion, by simultaneously generating the lasing pump light and converting it into photon pairs within the same device. However, the acceptance bandwidth of the lasing light for this conversion process is small, which makes free‐runnning Fabry–Pérot lasers with no wavelength stabilisation less suitable for nonlinear processes. We present the emission characteristics of a Bragg reflection ridge waveguide laser where a surface Bragg grating is implemented in one segment of the device. The lasing wavelength, determined by the Bragg condition, can be adjusted by the period of the grating between 775 and 785 nm. Furthermore, a micro heater in the grating section enables additional tuning of the lasing wavelength by 2 nm.
- Open Access
- 1 October 2024
- Published by AIP Publishing in APL Photonics
- Vol. 9 (10)
GaAs-based photonic integrated circuit platform enabling monolithic ring-resonator-coupled lasers
This paper reports on a monolithically integrated gallium arsenide (GaAs)-based photonic integrated circuit platform for wavelengths around 1064 nm. Enabled by spatially selective quantum well removal and two-step epitaxial growth, it supports on-chip gain as well as passive waveguides. In addition, shallow- and deep-etched waveguides are realized. The former result in waveguide losses of less than 2 dB/cm, while the latter enable compact integrated waveguide components. To demonstrate the performance of the platform, racetrack ring resonators based on deep-etched Euler bends and shallow-etched directional couplers are realized, achieving high intrinsic quality factors of 2.6 × 105 and 3.2 × 105 for the fundamental TE and TM mode, respectively. To demonstrate the use of these resonators, ring-resonator-coupled lasers are fabricated, resulting in one-sided output powers of up to 14 mW and single-mode operation with 40 dB side-mode suppression. The successful integration of ring resonators on a GaAs-based active/passive photonic integrated circuit platform paves the way for the realization of fully monolithic, widely tunable, and narrow linewidth ring-resonator-coupled laser sources.
- 1 October 2024
- Published by AIP Publishing in APL Photonics
- Vol. 9 (10)
Open AccessGaAs-based photonic integrated circuit platform enabling monolithic ring-resonator-coupled lasers
This paper reports on a monolithically integrated gallium arsenide (GaAs)-based photonic integrated circuit platform for wavelengths around 1064 nm. Enabled by spatially selective quantum well removal and two-step epitaxial growth, it supports on-chip gain as well as passive waveguides. In addition, shallow- and deep-etched waveguides are realized. The former result in waveguide losses of less than 2 dB/cm, while the latter enable compact integrated waveguide components. To demonstrate the performance of the platform, racetrack ring resonators based on deep-etched Euler bends and shallow-etched directional couplers are realized, achieving high intrinsic quality factors of 2.6 × 105 and 3.2 × 105 for the fundamental TE and TM mode, respectively. To demonstrate the use of these resonators, ring-resonator-coupled lasers are fabricated, resulting in one-sided output powers of up to 14 mW and single-mode operation with 40 dB side-mode suppression. The successful integration of ring resonators on a GaAs-based active/passive photonic integrated circuit platform paves the way for the realization of fully monolithic, widely tunable, and narrow linewidth ring-resonator-coupled laser sources.
- Open Access
- 22 May 2023
- Published by AIP Publishing in Applied Physics Letters
- Vol. 122 (21)
Carrier density non-pinning at stripe edges and widened lateral far field due to longitudinal temperature variation in broad-area high power diode lasers
Broad area lasers operating at high power with improved beam quality are needed in many applications. In typical high-power diode lasers with asymmetric facet coating, it is observed that the carrier density fails to completely pin above threshold with significant levels of lateral carrier accumulation (LCA) at the front facet stripe edges. Systematic experimental data are presented to quantify such non-pinning and its effect on lateral far field in multiple diode lasers with varying longitudinal temperature variation (LTV) using spontaneous emission imaging. LTV is quantified and correlated with the carrier accumulation and its dependence on facet reflectivity and cavity length. Results of measurements under continuous wave (CW) and quasi-CW conditions are used to regulate the level of heating and, hence, to isolate the contribution of LTV and optical field profile. Conventional long resonator asymmetric-coated devices show a twofold increase in LCA from threshold to 10 A current at the front stripe edge, but LCA varies less than 20% for lower facet asymmetry or short resonators. Similarly, strong temperature driven far field broadening is observed for conventional long-resonator asymmetric-coated devices (3°–4° variation with temperature at 10 A), which is strongly reduced for lower facet asymmetry or short resonators (<1° at 10 A).
- 22 May 2023
- Published by AIP Publishing in Applied Physics Letters
- Vol. 122 (21)
Open AccessCarrier density non-pinning at stripe edges and widened lateral far field due to longitudinal temperature variation in broad-area high power diode lasers
Broad area lasers operating at high power with improved beam quality are needed in many applications. In typical high-power diode lasers with asymmetric facet coating, it is observed that the carrier density fails to completely pin above threshold with significant levels of lateral carrier accumulation (LCA) at the front facet stripe edges. Systematic experimental data are presented to quantify such non-pinning and its effect on lateral far field in multiple diode lasers with varying longitudinal temperature variation (LTV) using spontaneous emission imaging. LTV is quantified and correlated with the carrier accumulation and its dependence on facet reflectivity and cavity length. Results of measurements under continuous wave (CW) and quasi-CW conditions are used to regulate the level of heating and, hence, to isolate the contribution of LTV and optical field profile. Conventional long resonator asymmetric-coated devices show a twofold increase in LCA from threshold to 10 A current at the front stripe edge, but LCA varies less than 20% for lower facet asymmetry or short resonators. Similarly, strong temperature driven far field broadening is observed for conventional long-resonator asymmetric-coated devices (3°–4° variation with temperature at 10 A), which is strongly reduced for lower facet asymmetry or short resonators (<1° at 10 A).
- Open Access
- 11 August 2022
- Published by IOP Publishing in Semiconductor Science and Technology
- Vol. 37 (9) , 095021
Ridge waveguide lasers with vertically stacked quantum wells and tunnel junctions
We report on the fabrication and electro-optical performance of ridge waveguide (RW) lasers emitting near 905 nm based on a vertical layer structure consisting of three single quantum wells (SQWs) as active regions separated by two tunnel junctions (TJs). The single waveguide core is designed in such a way that the third vertical mode is lasing. The width of the ridge is varied between 3 µm and 200 µm. Deep- and shallow-etched ridges were fabricated. The shallow etching stopped slightly above the topmost SQW, whereas the deep etch went through all TJs and stopped slightly above the lowest SQW. For comparison, we also fabricated conventional shallow-etched RW lasers based on a similar vertical structure having only one SQW and no TJs. The TJ RW lasers with deep-etched ridges provide the highest output power, lowest threshold current and best slope efficiency of 2.4 W A−1 for a ridge width of 6 µm. The performance of shallow-etched TJ RW lasers is lowest for small ridge widths but surpasses the performance of the conventional RW lasers when the ridge width is increased. The lateral far field angle of deep-etched TJ RW lasers is about 2° larger compared to the shallow etched ones.
- 11 August 2022
- Published by IOP Publishing in Semiconductor Science and Technology
- Vol. 37 (9) , 095021
Open AccessRidge waveguide lasers with vertically stacked quantum wells and tunnel junctions
We report on the fabrication and electro-optical performance of ridge waveguide (RW) lasers emitting near 905 nm based on a vertical layer structure consisting of three single quantum wells (SQWs) as active regions separated by two tunnel junctions (TJs). The single waveguide core is designed in such a way that the third vertical mode is lasing. The width of the ridge is varied between 3 µm and 200 µm. Deep- and shallow-etched ridges were fabricated. The shallow etching stopped slightly above the topmost SQW, whereas the deep etch went through all TJs and stopped slightly above the lowest SQW. For comparison, we also fabricated conventional shallow-etched RW lasers based on a similar vertical structure having only one SQW and no TJs. The TJ RW lasers with deep-etched ridges provide the highest output power, lowest threshold current and best slope efficiency of 2.4 W A−1 for a ridge width of 6 µm. The performance of shallow-etched TJ RW lasers is lowest for small ridge widths but surpasses the performance of the conventional RW lasers when the ridge width is increased. The lateral far field angle of deep-etched TJ RW lasers is about 2° larger compared to the shallow etched ones.
- 10 December 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 32 (1) , 59-62
Monolithic Master Oscillator Tilted Tapered Power Amplifier Emitting 9.5 W at 1060 nm
- 10 December 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 32 (1) , 59-62
Monolithic Master Oscillator Tilted Tapered Power Amplifier Emitting 9.5 W at 1060 nm