Ashenafi Abadi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Ashenafi Abadi has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Eslam Abubakr
Department of Mechanical Engineering and Intelligent Systems, Graduate School of Informatics and Engineering, The University of Electro-Communications, Tokyo, Japan
3 shared publications Daiji Noda
Micromachine Center, National Institute of Advanced Industrial Science and Technology (AIST), Tsukuba, Japan
2 shared publicationsRyo Ohta
Micromachine Center, National Institute of Advanced Industrial Science and Technology (AIST), Tsukuba, Japan
2 shared publications- Tetsuo Kan
Department of Mechanical and Intelligent Systems Engineering, Graduate School of Informatics and Engineering, The University of Electro-Communications, 1-5-1 Chofugaoka, Chofu, Tokyo 182-8585, Japan
2 shared publications Ashenafi Elyas
1 shared publicationMasaaki Oshita
1 shared publication
Latest Publications
- 17 March 2025
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 54 (5) , 4074-4082
Study on Temperature-Dependent Photoresponsivity and Stability of Mid-Infrared Photodetector Based on Si-Process-Compatible Plasmonic PtSi/p-Si Schottky Structure
- 17 March 2025
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 54 (5) , 4074-4082
Study on Temperature-Dependent Photoresponsivity and Stability of Mid-Infrared Photodetector Based on Si-Process-Compatible Plasmonic PtSi/p-Si Schottky Structure
- 11 March 2024
- Published by Elsevier in Optical Materials
- Vol. 150
Optimizing geometry and metal-dependent performance of Si-based Schottky plasmonic photodetectors
- 11 March 2024
- Published by Elsevier in Optical Materials
- Vol. 150
Optimizing geometry and metal-dependent performance of Si-based Schottky plasmonic photodetectors
- 4 March 2024
- Published by Optica Publishing Group in Applied Optics
- Vol. 63 (8) , 2046-2055
Characterization of an uncooled mid-infrared Schottky photodetector based on a 2D Au/PtSi/p-Si nanohole array at a higher light modulation frequency
In this study, an uncooled 2D nanohole array PtSi/p-Si Schottky mid-infrared (MIR) photodetector, which is essential for on-chip Si-based low-barrier MIR detectors, is presented. Room temperature operation introduces susceptibility to thermal noise and can impact stability. Through modulation frequency and reverse bias optimization, the stability improved by 7 times at 170 Hz and −3.5V, respectively. The effective light detection and stability were confirmed through ON/OFF response measurements over a longer time. The wavelength-dependent responsivity, measured with a tunable MIR laser, confirmed the responsiveness of the device in the MIR region of 2.5 µm to 4.0 µm, with a maximum specific detectivity (D*) of 2.0×103cmHz1/2W−1 at 3.0 µm; this result shows its potential applicability for noninvasive human lipid monitoring. Overall, this study focuses on the crucial role of signal analysis optimization in enhancing the performance of MIR photodetectors at room temperature.
- 4 March 2024
- Published by Optica Publishing Group in Applied Optics
- Vol. 63 (8) , 2046-2055
Characterization of an uncooled mid-infrared Schottky photodetector based on a 2D Au/PtSi/p-Si nanohole array at a higher light modulation frequency
In this study, an uncooled 2D nanohole array PtSi/p-Si Schottky mid-infrared (MIR) photodetector, which is essential for on-chip Si-based low-barrier MIR detectors, is presented. Room temperature operation introduces susceptibility to thermal noise and can impact stability. Through modulation frequency and reverse bias optimization, the stability improved by 7 times at 170 Hz and −3.5V, respectively. The effective light detection and stability were confirmed through ON/OFF response measurements over a longer time. The wavelength-dependent responsivity, measured with a tunable MIR laser, confirmed the responsiveness of the device in the MIR region of 2.5 µm to 4.0 µm, with a maximum specific detectivity (D*) of 2.0×103cmHz1/2W−1 at 3.0 µm; this result shows its potential applicability for noninvasive human lipid monitoring. Overall, this study focuses on the crucial role of signal analysis optimization in enhancing the performance of MIR photodetectors at room temperature.