Berke Akgül
Berke Akgül has a total of 580 co-authors. Here are the top co-authors by number of shared publications:
- Andre David
CERN
2 shared publications - Burcu Erkmen
Department of Electronics and Communication Engineering, Yıldız Technical University, 34220 İstanbul, Türkiye
2 shared publications - O. Yuksel
Electronics and Communications Engineering Department, Yıldız Technical University, Davutpaşa Caddesi No:1, Esenler, Istanbul, Türkiye
2 shared publications - Paul Dauncey
Physics Department, Imperial College London, Prince Consort Road, London, SW7 2BW, U.K.
2 shared publications - R. Shukla
Physics Department, Imperial College London, Prince Consort Road, London, SW7 2BW, U.K.
2 shared publications - Sadiye Nergis Tural Polat
Department of Electronics and Communications Engineering, Yildiz Technical University, Istanbul 34220, Turkey
2 shared publications
Latest Publications
- 30 June 2026
- Published by Muhendislik Bilimleri ve Tasarim Dergisi in Mühendislik Bilimleri ve Tasarım Dergisi
- Vol. 14 (2) , 182-194
PIPELINED AES-CTR FOR UNDERWATER RGB IMAGE ENCRYPTION/DECRYPTION ON FPGA
This paper presents a pipelined FPGA implementation of the AES algorithm in the Counter (CTR) mode, specifically optimized for underwater RGB image encryption and decryption. Underwater imaging often suffers from limited bandwidth, so it requires secure transmission in real-time applications. These applications include, but are not limited to, autonomous underwater vehicles (AUVs) and remotely operated vehicles (ROVs). The proposed design achieves high throughput while maintaining low latency. By utilizing a multistage pipeline architecture implemented in Verilog, four pipeline configurations were developed and evaluated, ranging from a non-pipelined baseline to a fully pipelined design. The non-pipelined implementation achieves 1.16 Gb/s with 3106 LUTs and 2193 FFs. Moreover, the 2-stage and 6-stage versions reach 2.56 Gb/s and 6.40 Gb/s, respectively, while the fully pipelined implementation attains 12.80 Gb/s at a clock frequency of 100 MHz, utilizing 6403 LUTs and 2943 FFs. These results demonstrate the efficiency of deep pipelining and provide a favourable balance between performance and resource utilization compared to prior AES implementations.
- 30 June 2026
- Published by Muhendislik Bilimleri ve Tasarim Dergisi in Mühendislik Bilimleri ve Tasarım Dergisi
- Vol. 14 (2) , 182-194
PIPELINED AES-CTR FOR UNDERWATER RGB IMAGE ENCRYPTION/DECRYPTION ON FPGA
This paper presents a pipelined FPGA implementation of the AES algorithm in the Counter (CTR) mode, specifically optimized for underwater RGB image encryption and decryption. Underwater imaging often suffers from limited bandwidth, so it requires secure transmission in real-time applications. These applications include, but are not limited to, autonomous underwater vehicles (AUVs) and remotely operated vehicles (ROVs). The proposed design achieves high throughput while maintaining low latency. By utilizing a multistage pipeline architecture implemented in Verilog, four pipeline configurations were developed and evaluated, ranging from a non-pipelined baseline to a fully pipelined design. The non-pipelined implementation achieves 1.16 Gb/s with 3106 LUTs and 2193 FFs. Moreover, the 2-stage and 6-stage versions reach 2.56 Gb/s and 6.40 Gb/s, respectively, while the fully pipelined implementation attains 12.80 Gb/s at a clock frequency of 100 MHz, utilizing 6403 LUTs and 2943 FFs. These results demonstrate the efficiency of deep pipelining and provide a favourable balance between performance and resource utilization compared to prior AES implementations.
- 9 April 2026
- Published by Springer Nature in Circuits, Systems, and Signal Processing
- Vol. 45 (11) , 9040-9063
Resource-Efficient Design of High-Speed FIR Filter: Fractional-Order Integrator/Differentiator on FPGAs
- 9 April 2026
- Published by Springer Nature in Circuits, Systems, and Signal Processing
- Vol. 45 (11) , 9040-9063
Resource-Efficient Design of High-Speed FIR Filter: Fractional-Order Integrator/Differentiator on FPGAs
- Open Access
- 1 April 2026
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 21 (04) , C04003
Development and implementation of a non-zero suppression system for HGCAL back-end electronics
In preparation for operations at the HL-LHC, the CMS Collaboration is upgrading its endcap calorimeters with a high granularity calorimeter (HGCAL). The HGCAL back-end electronics includes two Non-Zero Suppression (NZS) boards, which dynamically disable zero-suppression in designated regions of interest. This paper presents a detailed discussion of the principal components of the implemented NZS firmware and a comprehensive account of the hardware testing performed on the Serenity platform, including validation against a Python-based emulator. Each of the 48 DAQ (Data Acquisition) boards of a single endcap receives 432-bit NZS flags, which are generated non-zero-suppression control flags to disable zero suppression for designated regions of interest on the front-end sections and sent via high-speed output channels operating at 25 Gbps. The NZS firmware processes data from six EMTF input links operating at 25 Gbps, and produces the necessary non-zero suppression control flags for real-time selection and spatial mapping of up to 27 muon candidates per bunch crossing under a 360 MHz system clock constraint. To meet the stringent timing requirements, the design adopts a fully pipelined FPGA architecture, enabling deterministic latency while sustaining continuous high-throughput operation.
- 1 April 2026
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 21 (04) , C04003
Open AccessDevelopment and implementation of a non-zero suppression system for HGCAL back-end electronics
In preparation for operations at the HL-LHC, the CMS Collaboration is upgrading its endcap calorimeters with a high granularity calorimeter (HGCAL). The HGCAL back-end electronics includes two Non-Zero Suppression (NZS) boards, which dynamically disable zero-suppression in designated regions of interest. This paper presents a detailed discussion of the principal components of the implemented NZS firmware and a comprehensive account of the hardware testing performed on the Serenity platform, including validation against a Python-based emulator. Each of the 48 DAQ (Data Acquisition) boards of a single endcap receives 432-bit NZS flags, which are generated non-zero-suppression control flags to disable zero suppression for designated regions of interest on the front-end sections and sent via high-speed output channels operating at 25 Gbps. The NZS firmware processes data from six EMTF input links operating at 25 Gbps, and produces the necessary non-zero suppression control flags for real-time selection and spatial mapping of up to 27 muon candidates per bunch crossing under a 360 MHz system clock constraint. To meet the stringent timing requirements, the design adopts a fully pipelined FPGA architecture, enabling deterministic latency while sustaining continuous high-throughput operation.
- Open Access
- 1 November 2024
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 19 (11) , P11025
Using graph neural networks to reconstruct charged pion showers in the CMS High Granularity Calorimeter
A novel method to reconstruct the energy of hadronic showers in the CMS High Granularity Calorimeter (HGCAL) is presented. The HGCAL is a sampling calorimeter with very fine transverse and longitudinal granularity. The active media are silicon sensors and scintillator tiles readout by SiPMs and the absorbers are a combination of lead and Cu/CuW in the electromagnetic section, and steel in the hadronic section. The shower reconstruction method is based on graph neural networks and it makes use of a dynamic reduction network architecture. It is shown that the algorithm is able to capture and mitigate the main effects that normally hinder the reconstruction of hadronic showers using classical reconstruction methods, by compensating for fluctuations in the multiplicity, energy, and spatial distributions of the shower's constituents. The performance of the algorithm is evaluated using test beam data collected in 2018 prototype of the CMS HGCAL accompanied by a section of the CALICE AHCAL prototype. The capability of the method to mitigate the impact of energy leakage from the calorimeter is also demonstrated.
- 1 November 2024
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 19 (11) , P11025
Open AccessUsing graph neural networks to reconstruct charged pion showers in the CMS High Granularity Calorimeter
A novel method to reconstruct the energy of hadronic showers in the CMS High Granularity Calorimeter (HGCAL) is presented. The HGCAL is a sampling calorimeter with very fine transverse and longitudinal granularity. The active media are silicon sensors and scintillator tiles readout by SiPMs and the absorbers are a combination of lead and Cu/CuW in the electromagnetic section, and steel in the hadronic section. The shower reconstruction method is based on graph neural networks and it makes use of a dynamic reduction network architecture. It is shown that the algorithm is able to capture and mitigate the main effects that normally hinder the reconstruction of hadronic showers using classical reconstruction methods, by compensating for fluctuations in the multiplicity, energy, and spatial distributions of the shower's constituents. The performance of the algorithm is evaluated using test beam data collected in 2018 prototype of the CMS HGCAL accompanied by a section of the CALICE AHCAL prototype. The capability of the method to mitigate the impact of energy leakage from the calorimeter is also demonstrated.
- Open Access
- 19 March 2024
- Published by MDPI AG in Electronics
- Vol. 13 (6) , 1121
An Energy Consumption Model for SRAM-Based In-Memory-Computing Architectures
In this paper, a mathematical model for obtaining energy consumption of IMC architectures is constructed. This model provides energy estimation based on the distribution of a specific dataset. In addition, the estimation reduces the required simulation time to create an energy consumption model of SRAM-based IMC architectures. To validate our model with realistic data, the energy consumption of IMC is compared by using NeuroSim V3.0 for the CIFAR-10 and MNIST-like datasets. Furthermore, an application is created with our model to select highest performing quantization mapping based upon the parameters of energy consumption and accuracy.
- 19 March 2024
- Published by MDPI AG in Electronics
- Vol. 13 (6) , 1121
Open AccessAn Energy Consumption Model for SRAM-Based In-Memory-Computing Architectures
In this paper, a mathematical model for obtaining energy consumption of IMC architectures is constructed. This model provides energy estimation based on the distribution of a specific dataset. In addition, the estimation reduces the required simulation time to create an energy consumption model of SRAM-based IMC architectures. To validate our model with realistic data, the energy consumption of IMC is compared by using NeuroSim V3.0 for the CIFAR-10 and MNIST-like datasets. Furthermore, an application is created with our model to select highest performing quantization mapping based upon the parameters of energy consumption and accuracy.