Ziao Yuan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Ziao Yuan has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Siyuan Liu
Xi’an Jiaotong University
3 shared publications Jinchao Chen
Xi’an Jiaotong University
1 shared publication- Jinchao Chen
State Key Laboratory of Electrical Insulation and Power Equipment, Xi’an Jiaotong University, Xi’an 710049, China
1 shared publication Liuhuo Wang
1 shared publicationMengze Yu
1 shared publication- Mengze Yu
Grid Planning & Research Center of Guangdong Power Grid Corporation, CSG, Guangzhou 510080, China
1 shared publication
Latest Publications
- 28 January 2025
- Published by Springer Nature
- p. 569-577
A Low-Cost and Low-Loss Multi-Port Incremental Oscillating DC Circuit Breaker
- 28 January 2025
- Published by Springer Nature
- p. 569-577
A Low-Cost and Low-Loss Multi-Port Incremental Oscillating DC Circuit Breaker
- Open Access
- 16 May 2024
- Published by MDPI AG in Electronics
- Vol. 13 (10) , 1948
A Cost-Effective Current-Limiting Hybrid DC Circuit Breaker Based on Hybrid Semiconductors
DC circuit breakers (DCCBs) are the key equipment to rapidly interrupt the fault current in high-voltage DC power grids and ensure the safe operation of the system. However, most DCCBs do not take current-limiting measures and rely solely on current-limiting reactors in the system to limit the rate of current rise during the interruption process. The extensive use of fully controlled power electronic devices in circuit breakers (CBs) results in high costs. To address the issues above, this paper proposes a DCCB topology with a current-limiting function based on thyristors and diodes, which can reduce the cost of CB while ensuring reliable interruption. The impact of various parameters on CB performance is analyzed using numerical calculations to optimize the parameters. Then, a simulation model of a 500 kV/16 kA DCCB is built in PSCAD/EMTDC, and the performance of the proposed CB topology is compared with the other CB topologies. By comparison, the proposed DCCB topology can reliably isolate fault currents and reduce the amplitude of fault currents and the cost of CBs. Significantly, the energy absorbed by the metal oxide varistor (MOV) during the interruption process decreases by 64.2%, reducing the cost and volume of the MOV. Finally, the feasibility of the CB is further verified in the ±500 kV 4-terminal high-voltage DC power grid simulation model. The results show that the proposed DCCB topology can limit the fault current rise rate, interrupt and isolate the fault reliably, and reduce the cost.
- 16 May 2024
- Published by MDPI AG in Electronics
- Vol. 13 (10) , 1948
Open AccessA Cost-Effective Current-Limiting Hybrid DC Circuit Breaker Based on Hybrid Semiconductors
DC circuit breakers (DCCBs) are the key equipment to rapidly interrupt the fault current in high-voltage DC power grids and ensure the safe operation of the system. However, most DCCBs do not take current-limiting measures and rely solely on current-limiting reactors in the system to limit the rate of current rise during the interruption process. The extensive use of fully controlled power electronic devices in circuit breakers (CBs) results in high costs. To address the issues above, this paper proposes a DCCB topology with a current-limiting function based on thyristors and diodes, which can reduce the cost of CB while ensuring reliable interruption. The impact of various parameters on CB performance is analyzed using numerical calculations to optimize the parameters. Then, a simulation model of a 500 kV/16 kA DCCB is built in PSCAD/EMTDC, and the performance of the proposed CB topology is compared with the other CB topologies. By comparison, the proposed DCCB topology can reliably isolate fault currents and reduce the amplitude of fault currents and the cost of CBs. Significantly, the energy absorbed by the metal oxide varistor (MOV) during the interruption process decreases by 64.2%, reducing the cost and volume of the MOV. Finally, the feasibility of the CB is further verified in the ±500 kV 4-terminal high-voltage DC power grid simulation model. The results show that the proposed DCCB topology can limit the fault current rise rate, interrupt and isolate the fault reliably, and reduce the cost.
- 2 April 2024
- Published by Springer Nature
- p. 578-589
Design and Simulation of High Voltage DC Circuit Breaker Based on Voltage Source Inverter Assisted Oscillation
- 2 April 2024
- Published by Springer Nature
- p. 578-589
Design and Simulation of High Voltage DC Circuit Breaker Based on Voltage Source Inverter Assisted Oscillation