DHDmytro Herus

Dmytro Herus

*This is an algorithmically generated author record based on publicly available information.

Dmytro Herus has a total of 3 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • COMPARATIVE ANALYSIS OF METHODS FOR CUTTING SPUR GEARS BASED ON TECHNICAL AND ECONOMIC PARAMETERS

    by Ihor Hrytsai, Dmytro Herus, Serhii Hromniuk, Ukraine Spr Energo Llc

    The results of the simulation and study of the process of cutting gears by the traditional method of hobbing and the new radial-circular method (RCM), which is carried out by a thin disk cutter, but in the conditions of continuous profile generation, as it is in gear cutting with a hob. It has been shown that due to the peculiarities of this process, its kinematics, and the structure of the disk cutter, RCM is superior to hobbing in all the parameters studied: volumetric productivity, chip thickness ratio, and cutting forces, machining time and machining costs. The higher efficiency of the radial-circular method has thus been demonstrated and the feasibility of its practical application has been confirmed.

  • STUDY OF THE GEAR CUTTING PROCESS BY THE RADIAL-CIRCULAR METHOD

    by Ihor Hrytsai, Dmytro Herus

    The results of the study of the radial-circular method of gear cutting are presented. The cutting and shaping of teeth is carried out by a thin disc cutter under conditions of continuous generating, with a combination of axial feed of the cutter and its constructive radial movement due to eccentric installation on the spindle axis. The value of the eccentricity is determined by the gear module. A graph-analytical model was used to calculate the parameters of the cuts, and the cutting force and torque on the cutter axis were modeled using these data. It was found that the cutting process is characterized by significant load variations. The areas of maximum tool wear were predicted. It is shown that for under the same initial conditions, the cutting time using this method is two times less than the time of hobbing. Since a disc cutter can cut gears in a wide range of modules, this process is one of the most versatile. This method opens up great possibilities for the restoration and repair of gears and drives manufactured to standards other than those adopted in Europe.