HLHuaming Lai

Huaming Lai

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Huaming Lai has a total of 8 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Axial Impact Resistance of High-Strength Engineering Geopolymer Composites: Effect of Polyethylene Fiber Content and Strain Rate

    by Yu Ling, Xiafei Zhang, Weiyu Zou, Chang Feng, Huaming Lai, Jialin Yang, Beixin Xie

    High-strength engineered geopolymer composite (EGC) materials exhibit excellent mechanical properties under quasistatic loading, thus showing great potential in military and civilian facilities subjected to impact or explosive loading. However, its dynamic mechanical response under high-speed loading is not fully understood. In this study, dynamic compressive test was performed on EGC with PE fiber contents of 0%, 0.5%, 1.0%, 1.5%, and 2.0% using the Split Hopkinson Pressure Bar (SHPB) test. The results indicated that EGC reinforced with 1.5% fiber exhibited optimal static and dynamic mechanical performance. In the strain rate range of 181 s−1 to 201 s−1, when the fiber content increased from 1.0% to 1.5% and 2.0%, the dynamic compressive strength of the EGC increased by 24.3%, 28.8%, and 44.0%, respectively, compared to the matrix without fiber. Dynamic parameters of the EGC, including dynamic compressive strength, dynamic increase factor, and impact toughness, showed sensitivity to strain rates and increased with strain rate. A modified model, incorporating the fiber bridging effect, was proposed based on the CEB-FIP model, providing important guidance for practical engineering applications.


  • Open Access

    Comprehensive Analysis of Mechanical, Economic, and Environmental Characteristics of Hybrid PE/PP Fiber-Reinforced Engineered Geopolymer Composites

    by Xiafei Zhang, Yu Ling, Yanwei Wu, Huaming Lai, Yingchang Wang, Zhanbiao Chen

    Engineered Geopolymer Composites (EGCs), known for their excellent tensile properties and lower carbon emissions, have gained widespread attention in the field of fiber-reinforced concrete. However, the high cost of high-performance synthetic fibers, a crucial component of EGCs, limits their practical engineering applications. In this study, by using low-cost PP fibers hybridized with PE fibers and adjusting the fly ash/ground granulated blast furnace slag (FA/GGBS) ratio, cost-effective, high-performing hybrid PE/PP-reinforced engineered geopolymer composites (H-EGCs) were developed. This study conducted axial compressive and tensile tests on H-EGCs with different FA/GGBS ratios (7:3, 6:4, and 5:5) and PP fiber replacement ratios (0%, 25%, 50%, 75%, and 100%), investigated the influence of FA/GGBS and PP fiber replacement ratio on static mechanical behavior, and evaluated the economic and environmental benefits based on mechanical performance indicators. The result indicated that the compressive strength of H-EGCs can reach 120 MPa when the FA/GGBS ratio is 5:5; however, an increase in FA/GGBS and PP fiber replacement ratio leads to a loss in compressive strength and elastic modulus. The incorporation of PP fibers in moderate amounts enhances ultimate tensile strain by reducing crack control ability, and the maximum tensile deformation capacity (7.82–9.66%) was obtained for H-EGCs with a PP fiber replacement ratio of 50%. The optimal economic and environmental benefits of H-EGCs are observed when the FA/GGBS ratio is 5:5 and the PP fiber replacement ratio is set at 50%.