Zhuang Zhao
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Zhuang Zhao has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Bo Yang
School of Advanced Materials and Nanotechnology, Xidian University, Xi’an 710071, China
4 shared publications - Peixian Li
School of Advanced Materials and Nanotechnology, Xidian University, Xi’an 710071, China
4 shared publications - Xiaowei Zhou
School of Advanced Materials and Nanotechnology, Xidian University, Xi’an 710071, China
4 shared publications - Yang Liu
School of Advanced Materials and Nanotechnology, Xidian University, Xi’an 710071, China
4 shared publications - Yingru Xiang
School of Advanced Materials and Nanotechnology, Xidian University, Xi’an 710071, China
3 shared publications - Junchun Bai
State Key Discipline Laboratory of Wide Band Gap Semiconductor Technology, Xidian University, Xi’an 710071, China
2 shared publications
Latest Publications
- Open Access
- 28 December 2024
- Published by MDPI AG in Micromachines
- Vol. 16 (1) , 28
Performance Study of Ultraviolet AlGaN/GaN Light-Emitting Diodes Based on Superlattice Tunneling Junction
In this study, we aim to enhance the internal quantum efficiency (IQE) of AlGaN-based ultraviolet (UV) light-emitting diodes (LEDs) by using the short-period AlGaN/GaN superlattice as a tunnel junction (TJ) to construct polarized structures. We analyze in detail the effect of this polarized TJ on the carrier injection efficiency and investigate the increase in hole and electron density caused by the formation of 2D hole gas (2DHG) and 2D electron gas (2DEG) in the superlattice structure. In addition, a dielectric layer is introduced to evaluate the effect of stress changes on the tunneling probability and current spread in TJ. At a current of 140 mA, this method demonstrates effective current expansion. Our results not only improve the performance of UV LEDs but also provide an important theoretical and experimental basis for future research on UV LEDs based on superlattice TJ. In addition, our study also highlights the key role of group III nitride materials in achieving efficient UV luminescence, and the polarization characteristics and band structure of these materials are critical for optimizing carrier injection and recombination processes.
- 28 December 2024
- Published by MDPI AG in Micromachines
- Vol. 16 (1) , 28
Open AccessPerformance Study of Ultraviolet AlGaN/GaN Light-Emitting Diodes Based on Superlattice Tunneling Junction
In this study, we aim to enhance the internal quantum efficiency (IQE) of AlGaN-based ultraviolet (UV) light-emitting diodes (LEDs) by using the short-period AlGaN/GaN superlattice as a tunnel junction (TJ) to construct polarized structures. We analyze in detail the effect of this polarized TJ on the carrier injection efficiency and investigate the increase in hole and electron density caused by the formation of 2D hole gas (2DHG) and 2D electron gas (2DEG) in the superlattice structure. In addition, a dielectric layer is introduced to evaluate the effect of stress changes on the tunneling probability and current spread in TJ. At a current of 140 mA, this method demonstrates effective current expansion. Our results not only improve the performance of UV LEDs but also provide an important theoretical and experimental basis for future research on UV LEDs based on superlattice TJ. In addition, our study also highlights the key role of group III nitride materials in achieving efficient UV luminescence, and the polarization characteristics and band structure of these materials are critical for optimizing carrier injection and recombination processes.
- Open Access
- 26 November 2024
- Published by MDPI AG in Micromachines
- Vol. 15 (12) , 1420
Design and Growth of P-Type AlGaN Graded Composition Superlattice
A graded composition superlattice structure is proposed by combining simulation with experimentation. The structural factors affecting graded symmetric superlattices and graded asymmetric superlattices and their action modes are simulated and analyzed. A Mg-doped graded symmetric superlattice structure with high Al content, excellent structural quality, good surface morphology and excellent electrical properties was grown by MOCVD equipment. The AlxGa1−xN superlattice with Al composition of 0.7 in the barrier exhibits a hole concentration of approximately 5 × 1015 cm−3 and a resistivity of 66 Ω·cm.
- 26 November 2024
- Published by MDPI AG in Micromachines
- Vol. 15 (12) , 1420
Open AccessDesign and Growth of P-Type AlGaN Graded Composition Superlattice
A graded composition superlattice structure is proposed by combining simulation with experimentation. The structural factors affecting graded symmetric superlattices and graded asymmetric superlattices and their action modes are simulated and analyzed. A Mg-doped graded symmetric superlattice structure with high Al content, excellent structural quality, good surface morphology and excellent electrical properties was grown by MOCVD equipment. The AlxGa1−xN superlattice with Al composition of 0.7 in the barrier exhibits a hole concentration of approximately 5 × 1015 cm−3 and a resistivity of 66 Ω·cm.
- Open Access
- 6 June 2024
- Published by MDPI AG in Micromachines
- Vol. 15 (6) , 762
Enhanced Hole Injection in AlGaN-Based Ga-Polar Ultraviolet Light-Emitting Diodes with Polarized Electric-Field Reservoir Electron Barrier
In this study, we propose a polarized electron blocking layer (EBL) structure using AlxGa1−xN/AlxGa1−xN to enhance the internal quantum efficiency (IQE) of AlGaN-based ultraviolet light-emitting diodes (UV LEDs). Our findings indicate that this polarized EBL structure significantly improves IQE compared to conventional EBLs. Additionally, we introduce an electric-field reservoir (EFR) optimization method to maximize IQE. Specifically, optimizing the polarized EBL structure of AlxGa1−xN/AlxGa1−xN enhances the hole drift rate, resulting in an IQE improvement of 19% and an optical output power increase of 186 mW at a current of 210 mA.
- 6 June 2024
- Published by MDPI AG in Micromachines
- Vol. 15 (6) , 762
Open AccessEnhanced Hole Injection in AlGaN-Based Ga-Polar Ultraviolet Light-Emitting Diodes with Polarized Electric-Field Reservoir Electron Barrier
In this study, we propose a polarized electron blocking layer (EBL) structure using AlxGa1−xN/AlxGa1−xN to enhance the internal quantum efficiency (IQE) of AlGaN-based ultraviolet light-emitting diodes (UV LEDs). Our findings indicate that this polarized EBL structure significantly improves IQE compared to conventional EBLs. Additionally, we introduce an electric-field reservoir (EFR) optimization method to maximize IQE. Specifically, optimizing the polarized EBL structure of AlxGa1−xN/AlxGa1−xN enhances the hole drift rate, resulting in an IQE improvement of 19% and an optical output power increase of 186 mW at a current of 210 mA.
- Open Access
- 29 April 2024
- Published by MDPI AG in Micromachines
- Vol. 15 (5) , 596
Design and Growth of Low Resistivity P-Type AlGaN Superlattice Structure
This work investigated the impact of periodic thickness and doping region on the doping efficiency of the P-type AlGaN superlattice. In this paper, the band structure of the simulated superlattice was analyzed. The superlattice structure of Al0.1Ga0.3N/Al0.4Ga0.6N, and the AlGaN buffer on the sapphire substrate, achieved a resistivity of ~3.3 Ω·cm. The results indicate that barrier doping and low periodic thickness offer significant advantages in introducing a reduction of the resistivity of P-type AlGaN superlattice structures.
- 29 April 2024
- Published by MDPI AG in Micromachines
- Vol. 15 (5) , 596
Open AccessDesign and Growth of Low Resistivity P-Type AlGaN Superlattice Structure
This work investigated the impact of periodic thickness and doping region on the doping efficiency of the P-type AlGaN superlattice. In this paper, the band structure of the simulated superlattice was analyzed. The superlattice structure of Al0.1Ga0.3N/Al0.4Ga0.6N, and the AlGaN buffer on the sapphire substrate, achieved a resistivity of ~3.3 Ω·cm. The results indicate that barrier doping and low periodic thickness offer significant advantages in introducing a reduction of the resistivity of P-type AlGaN superlattice structures.