Xia Li
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Xia Li has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Jun Du
School of Architectural Engineering, Kunming University, Kunming 650214, China
1 shared publication - Lei Liu
Faculty of Land Resources Engineering, Kunming University of Science and Technology, Kunming 650093, China
1 shared publication - Xinggang Shen
College of Architecture and Civil Engineering, Kunming University, Kunming 650214, China
1 shared publication - Xinzuo Chen
Faculty of Public Safety and Emergency Management, Kunming University of Science and Technology, Kunming 650093, China
1 shared publication
Latest Publications
- Open Access
- 30 April 2024
- Published by MDPI AG in Applied Sciences
- Vol. 14 (9) , 3861
Research on Mechanical Properties of Steel-Polypropylene Fiber-Reinforced Concrete after High-Temperature Treatments
A mechanical property experiment was carried out on steel-polypropylene fiber-reinforced concrete after elevated temperatures by using a 50 mm diameter SHPB apparatus. The regulations of compressive strength, elastic modulus, Poisson’s ratio, and other mechanical properties under six heating temperature levels (normal temperature, 100 °C, 200 °C, 400 °C, 600 °C, and 800 °C) and three impact pressures (0.3 MPa, 0.4 MPa, 0.5 MPa) were studied. Using ANSYS/LS-DYNA 19.0 numerical simulation software and LS-PrePost post-processing software, numerical simulation analysis was conducted on the dynamic Hopkinson uniaxial impact compression and uniaxial dynamic impact splitting mechanical experiments of C40 plain concrete and steel-polypropylene hybrid fiber concrete. The results show that the dynamic compressive strength of hybrid fiber concrete with the optimal dosage reaches its maximum at a temperature group of 200 °C, and the dynamic compressive strength of hybrid fiber concrete with the optimal dosage increases by 97.1% compared to C40 plain concrete at a temperature group of 800 °C. The impact waveform and stress-strain curve results of the numerical simulation are very similar to the experimental results. The errors in calculating the peak stress and peak strain are within 6%, which can truly and accurately simulate the static mechanical properties and failure process of hybrid fiber-reinforced concrete.
- 30 April 2024
- Published by MDPI AG in Applied Sciences
- Vol. 14 (9) , 3861
Open AccessResearch on Mechanical Properties of Steel-Polypropylene Fiber-Reinforced Concrete after High-Temperature Treatments
A mechanical property experiment was carried out on steel-polypropylene fiber-reinforced concrete after elevated temperatures by using a 50 mm diameter SHPB apparatus. The regulations of compressive strength, elastic modulus, Poisson’s ratio, and other mechanical properties under six heating temperature levels (normal temperature, 100 °C, 200 °C, 400 °C, 600 °C, and 800 °C) and three impact pressures (0.3 MPa, 0.4 MPa, 0.5 MPa) were studied. Using ANSYS/LS-DYNA 19.0 numerical simulation software and LS-PrePost post-processing software, numerical simulation analysis was conducted on the dynamic Hopkinson uniaxial impact compression and uniaxial dynamic impact splitting mechanical experiments of C40 plain concrete and steel-polypropylene hybrid fiber concrete. The results show that the dynamic compressive strength of hybrid fiber concrete with the optimal dosage reaches its maximum at a temperature group of 200 °C, and the dynamic compressive strength of hybrid fiber concrete with the optimal dosage increases by 97.1% compared to C40 plain concrete at a temperature group of 800 °C. The impact waveform and stress-strain curve results of the numerical simulation are very similar to the experimental results. The errors in calculating the peak stress and peak strain are within 6%, which can truly and accurately simulate the static mechanical properties and failure process of hybrid fiber-reinforced concrete.