DYDeqiang Yang

Deqiang Yang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Deqiang Yang has a total of 7 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Electrochemical Characteristics of Steel Corrosion in Nano-SiO2 Modified Recycled Concrete under Dry-Wet Cycles

    by Yu Li, Xinyi Wang, Deqiang Yang

    To address the insufficient durability of recycled aggregate concrete (RAC) applied in the inland river bridge splash zone under low-chloride salt wet-dry cycling, this study systematically investigated the electrochemical corrosion characteristics of HRB400 steel reinforcement in nano-SiO2 modified RAC. With recycled coarse aggregate replacement ratios of 0% and 50% and nano-SiO2 dosages of 0%, 3%, and 6% as key variables, 300 accelerated dry-wet cycle tests were conducted in accordance with GB/T 50082-2009. Open circuit potential (OCP), linear polarization, and electrochemical impedance spectroscopy (EIS) were adopted to characterize the corrosion evolution of steel bars, combined with porosity analysis to clarify the modification mechanism. The results indicated that the passive film of steel in unmodified RAC (C0-R50) failed and initiated active corrosion at approximately 150 dry-wet cycles; 50% RAC incorporation increased the total porosity of concrete from 14.2% to 16.8%, accelerated the diffusion of oxygen and moisture, and significantly elevated the corrosion current density throughout the cycling process. NS modification effectively retarded carbonation-induced depassivation via pozzolanic reaction and micro-filling effect: after 300 cycles, the |Z| of the 3% NS natural aggregate group (C3-R0) reached 1380 Ω⋅cm2, while that of the 6% NS group (C6-R0) maintained 2087.4 Ω⋅cm2, both far exceeding the control group C0-R0 (544.5 Ω⋅cm2). The optimal anti-corrosion performance was achieved by 6% NS dosage, which reduced the final Icorr of C6-R0 by 91% compared with C0-R0, lowered the porosity of 50% RAC to 13.6%, and maintained a high charge transfer resistance (Rct) of 10,046.0 Ω⋅cm2 after 300 cycles. Even in the 50% RAC system, 6% NS retained a high |Z| of 2191.1 Ω⋅cm2 at 150 cycles, effectively compensating for the interfacial defects of recycled aggregate. Notably, the C3-R0 group presented a localized impedance peak at 200 cycles, attributed to the temporary accumulation of dense hydration/corrosion products. This study provides quantitative experimental data and a microscopic mechanism support for the engineering application of high-dosage nano-SiO2 modified recycled concrete in the splash zone of inland river bridges.

  • Open Access

    Model of Mechanical Properties of Concrete in Western Saline Soil Regions Based on Grey Theory

    by Deqiang Yang, Tian Su, Bangxiang Li, Xuefeng Mei, Fakai Dou

    Concrete structures in western saline soil regions are subjected to extreme environments with coupled dry-wet cycles and high concentrations of erosive ions such as Cl−, SO42−, and Mg2+, leading to severe degradation of mechanical properties. This study employed a simulated accelerated, high-concentration solution (Solution A, ~8× seawater salinity) similar to the composition of actual saline soil to perform accelerated dry-wet cycling corrosion tests on ordinary C40 concrete specimens for six corrosion ages (0, 5, 8, 10, 15, and 20 months). For each age, three replicate cube specimens were tested per property. The changes in cube compressive strength, splitting tensile strength, prism stress–strain full curves, and microstructure were systematically investigated. Results show that in the initial corrosion stage (0–5 months), strength exhibits a brief increase (compressive strength by 11.87%, splitting tensile strength by 9.23%) due to pore filling by corrosion products such as ettringite, gypsum, and Friedel’s salt. It then enters a slow deterioration stage (5–15 months), with significant strength decline by 20 months, where splitting tensile strength is most sensitive to corrosion. Long-term prediction models for key parameters such as compressive strength, splitting tensile strength, elastic modulus, peak stress, and peak strain were established based on grey GM(1,1) theory using the measured data from 0 to 20 months, achieving “excellent” accuracy (C ≤ 0.1221, p = 1). A segmented compressive constitutive model that considers the effect of corrosion time was proposed by combining continuous damage mechanics and the Weibull distribution. The ascending branch showed high consistency with the experimental curves. Life prediction indicates that under natural dry-wet cycling conditions, the service life of ordinary concrete in this region is only about 7.5 years when splitting tensile strength drops to 50% of initial value as the failure criterion, far below the 50-year design benchmark period. This study provides reliable theoretical models and a quantitative basis for durability design and life assessment of concrete structures in western saline soil regions.


  • Open Access

    Compression and Splitting Tensile Strength Model of Recycled Seawater and Sea Sand Concrete after Seawater Freeze–Thaw Cycles

    by Zhenyu Tan, Deqiang Yang

    Using seawater, sea sand, and recycled bricks to make concrete for nearshore and marine engineering can save resources and protect the environment. Therefore, this article studies the mechanical degradation law and failure mechanism of recycled seawater and sea sand concrete (SSC) after seawater freeze–thaw (SFT) cycles. Using the replacement rate of recycled brick coarse aggregate as a variable, the mass loss rate, relative dynamic elastic modulus, compression and splitting tensile strength, and microstructure changes of specimens under different SFT cycles were tested, and a mechanical performance degradation model was established. The results indicate that the SFT failure of recycled brick coarse aggregate SSC results from the action of physical SFT and chemical crystallization. Friedel’s salts without cementitious properties and ettringite with expansive properties are generated inside the concrete due to the chloride and sulfate ions in the internal concrete and external seawater reacting with cement hydration products. The formation of harmful crystals leads to the loosening of the concrete, especially in the interface area between brick aggregates and cement. The calculated results of the mechanical model established in this article agree with the test results. The compression and splitting tensile strength decrease linearly with the increase in SFT cycles.