FKFatemeh Khakbaz

Fatemeh Khakbaz

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Fatemeh Khakbaz has a total of 3 co-authors. Here are the top co-authors by number of shared publications:

  • Mehdi Razzaghi-Kashani

    Polymer Engineering Department, Faculty of Chemical Engineering, Tarbiat Modares University, Tehran, Iran

    1 shared publication
  • Mehdi Razzaghi‐Kashani

    Polymer Engineering Department, Faculty of Chemical Engineering Tarbiat Modares University Tehran Islamic Republic of Iran

    1 shared publication
  • Shima Jalali

    Polymer Engineering Department, Faculty of Chemical Engineering Tarbiat Modares University Tehran Iran

    1 shared publication

Latest Publications

  • Mechanistic Evaluation of Silane Spacer Length on Mechanical and Dielectric Properties of Polydimethylsiloxane‐Graphene Nanocomposites

    by Shima Jalali, Fatemeh Khakbaz, Mehdi Razzaghi‐Kashani

    The main challenges of using conductive nano‐fillers in dielectric elastomer composites are the proper dispersion of particles as well as the trade‐off between dielectric permittivity and dielectric loss resulting from the interfacial polarization and the current leak leading to bulk conduction. To address these challenges, the role of the hydrocarbon spacer length of silane grafted on the surface of reduced graphene oxide (RGO) was investigated in this study. For this purpose, RGO was surface‐modified using two silane coupling agents with different hydrocarbon spacer lengths, short‐spacer triethoxypropylsilane (PTEO) and long‐spacer hexadecyltrimethoxysilane (HDTMS), and the effect on the mechanical and dielectric properties of polydimethylsiloxane nanocomposites was evaluated. It was shown that the longer spacer length of silane provides improved dispersion of RGO in PDMS and forms insulating layers that suppress charge leakage and bulk conduction. Composites containing silane with long spacer length exhibited significantly lower dielectric loss, enhanced dielectric breakdown strength, and improved dielectric efficiency compared to both uncoated and short‐spacer length silane. Most notably, the nanocomposite containing silane with long spacer length achieved approximately two times the maximum Maxwell stress, a key parameter related to actuation strain, highlighting the critical role of hydrocarbon spacer length in optimizing the barrier effect and minimizing electron hopping.


  • Effect of reduced graphene oxide on vulcanization of polydimethylsiloxane composites

    by Fatemeh Khakbaz, Mehdi Razzaghi‐Kashani

    This research aims to investigate the effect of reduced graphene oxide (rGO) on the kinetics of addition vulcanization in polydimethylsiloxane (PDMS) elastomers. For this purpose, the synthesis of graphene oxide (GO) and silane‐grafted GO followed by chemical reduction of particles was conducted to prepare rGOs with different surface chemistry. Particles were characterized by Fourier transform infrared spectroscopy, Raman spectroscopy, x‐ray diffraction, scanning electron microscopy, and energy‐dispersive x‐ray analysis. Composites of PDMS containing these particles were prepared by solution mixing, and vulcanization of composites was investigated using differential scanning calorimetry. Results showed that the rate and degree of vulcanization reaction increase up to a critical concentration of particles and then decrease afterward. This behavior was attributed to the catalytic effect of chemical groups on the surface of rGOs, whereas the reverse behavior above the critical concentration was correlated to the immobilization of trapped rubber in the network of particles. Grafting graphene oxide by a long alkyl‐chain silane covered these chemical groups, suppressed the catalytic effect, improved the dispersion of particles, and shifted the critical concentration lower. The critical concentration was correlated to the electrical percolation threshold of particles and confirmed by the solvent swelling method. It was also shown that rGO can itself act as the catalyst for the vulcanization of PDMS with no need for platinum. As the dynamic‐mechanical‐thermal analysis showed, the PDMS composites containing 0.75 wt% of particles did not vulcanize properly. However, composites containing fewer particles were vulcanized.Highlights: Reduced graphene oxide affects additional vulcanization of PDMS. Below a critical loading, rGO accelerates vulcanization by a catalytic effect. Above critical loading, rGO decelerates vulcanization by a networking effect. Surface groups of rGO control catalytic and networking mechanisms. Silane modification of rGO affects interfacial behavior, thus critical loading.