Aina Hiyama Zazuli
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Aina Hiyama Zazuli has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
Kai Fujii
6 shared publications- Satoshi Kurai
Department of Electric and Electronic Engineering Yamaguchi University 2‐16‐1 Tokiwadai, Ube Yamaguchi 755‐8611 Japan
6 shared publications Taisei Kimoto
6 shared publicationsDaisuke Inahara
Department of Electric and Electronic Engineering, Yamaguchi University, Ube, Yamaguchi, JAPAN
4 shared publicationsKoki Hanasaku
Department of Electric and Electronic Engineering, Yamaguchi University, Ube, Yamaguchi, JAPAN
4 shared publicationsNarihito Okada
4 shared publications
Latest Publications
- Open Access
- 7 August 2026
- Published by Elsevier in Journal of Crystal Growth
- Vol. 694
Effect of F-value on GaN channel performance in N-polar GaN/AlGaN/AlN structure
- 7 August 2026
- Published by Elsevier in Journal of Crystal Growth
- Vol. 694
Open AccessEffect of F-value on GaN channel performance in N-polar GaN/AlGaN/AlN structure
- Open Access
- 9 July 2026
- Published by Elsevier in Journal of Crystal Growth
- Vol. 693
Improved electrical properties of N-polar GaN grown via MOVPE with TMGa pulsed supply method
- 9 July 2026
- Published by Elsevier in Journal of Crystal Growth
- Vol. 693
Open AccessImproved electrical properties of N-polar GaN grown via MOVPE with TMGa pulsed supply method
- Open Access
- 17 March 2026
- Published by Elsevier in SSRN Electronic Journal
Effect of F-value on GaN channel performance in N-polar GaN/AlGaN/AlN structure
N-polar GaN/ Al0.9Ga0.1N /AlN heterostructures were fabricated using metal organic vapor phase epitaxy to investigate the effect of the F-value of the carrier gas defined by the H₂/(H₂ + N₂) ratio, on GaN channel performance. Five samples were prepared with varying F-values during GaN growth, and their structural and electrical properties were systematically evaluated. The results revealed that GaN growth was not achieved at an F-value of 0. The lowest sheet resistance and optimal carrier mobility was observed at an F-value of 0.46, and further increase in F-value beyond this point led to decrease in both the growth rate and carrier mobility and an increase in sheet resistance. Surface roughness remained consistently low across all samples, indicating successful two-dimensional growth, but electrical properties were primarily influenced by impurity incorporation and interface quality. Temperature-dependent mobility and secondary ion mass spectrometry result suggested that lower impurity concentrations were achieved at the optimal F-value.
- 17 March 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessEffect of F-value on GaN channel performance in N-polar GaN/AlGaN/AlN structure
N-polar GaN/ Al0.9Ga0.1N /AlN heterostructures were fabricated using metal organic vapor phase epitaxy to investigate the effect of the F-value of the carrier gas defined by the H₂/(H₂ + N₂) ratio, on GaN channel performance. Five samples were prepared with varying F-values during GaN growth, and their structural and electrical properties were systematically evaluated. The results revealed that GaN growth was not achieved at an F-value of 0. The lowest sheet resistance and optimal carrier mobility was observed at an F-value of 0.46, and further increase in F-value beyond this point led to decrease in both the growth rate and carrier mobility and an increase in sheet resistance. Surface roughness remained consistently low across all samples, indicating successful two-dimensional growth, but electrical properties were primarily influenced by impurity incorporation and interface quality. Temperature-dependent mobility and secondary ion mass spectrometry result suggested that lower impurity concentrations were achieved at the optimal F-value.
- Open Access
- 2 September 2024
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 63 (9) , 09SP11
Impact of thick N-polar AlN growth on crystalline quality and electrical properties of N-polar GaN/AlGaN/AlN FET
In this study, we attempted to fabricate N-polar GaN/AlGaN/AlN heterostructure FET by changing the thickness of the AlN layer. An Al-polar tiny-pit AlN layer and a polarity inversion method were used to grow N-polar AlN on vicinal sapphire via the metal-organic vapor phase epitaxy. The samples with an AlN thickness of up to 3.4 μm exhibited a crack-free surface. Additionally, the twist component of the crystal quality improved with an increasing AlN thickness. Consequently, the mobility, sheet conductivity, and surface flatness improved. The FET fabricated from the sample with a thicker AlN layer achieved a higher drain current of 279 mA mm−1 at a gate bias of V G = 3 V.
- 2 September 2024
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 63 (9) , 09SP11
Open AccessImpact of thick N-polar AlN growth on crystalline quality and electrical properties of N-polar GaN/AlGaN/AlN FET
In this study, we attempted to fabricate N-polar GaN/AlGaN/AlN heterostructure FET by changing the thickness of the AlN layer. An Al-polar tiny-pit AlN layer and a polarity inversion method were used to grow N-polar AlN on vicinal sapphire via the metal-organic vapor phase epitaxy. The samples with an AlN thickness of up to 3.4 μm exhibited a crack-free surface. Additionally, the twist component of the crystal quality improved with an increasing AlN thickness. Consequently, the mobility, sheet conductivity, and surface flatness improved. The FET fabricated from the sample with a thicker AlN layer achieved a higher drain current of 279 mA mm−1 at a gate bias of V G = 3 V.
- 27 June 2024
- Published by Wiley in Physica Status Solidi (a)
- Vol. 221 (21)
Electrical Properties of N‐Polar GaN/AlGaN/AlN Grown via Metal‐Organic Vapor Phase Epitaxy
The metal‐organic vapor phase epitaxy (MOVPE) method faces several challenges when used for the growth of N‐polar GaN on foreign substrates, including the presence of a rough surface morphology characterized by step bunching or hexagonal hillocks. In this study, it is aimed to address these issues by establishing optimal growth conditions for the MOVPE method, enabling the growth of N‐polar GaN/Al0.9Ga0.1N/AlN heterostructures with a smooth surface morphology on a vicinal sapphire substrate. The formation of 2D electron gas (2DEG) in N‐polar GaN/AlGaN/AlN prepared using MOVPE is discussed. Additionally, in the study, the impact of growth conditions, such as temperature and V/III ratio, on the electrical properties of N‐polar GaN is investigated. In the results, it is revealed that growth at lower temperatures and a V/III ratio of 30 000 effectively suppresses 3D growth. Moreover, an increase in the V/III ratio correlates with a decrease in residual impurity concentrations (C and H); hence, electron mobility improves. Moreover, the N‐polar GaN/AlGaN/AlN field‐effect transistor, grown under optimized conditions, exhibits a higher maximum drain–source current (IDmax). In these results, possibilities are broadened for the high performance of N‐polar GaN channel high‐electron‐mobility transistors through MOVPE.
- 27 June 2024
- Published by Wiley in Physica Status Solidi (a)
- Vol. 221 (21)
Electrical Properties of N‐Polar GaN/AlGaN/AlN Grown via Metal‐Organic Vapor Phase Epitaxy
The metal‐organic vapor phase epitaxy (MOVPE) method faces several challenges when used for the growth of N‐polar GaN on foreign substrates, including the presence of a rough surface morphology characterized by step bunching or hexagonal hillocks. In this study, it is aimed to address these issues by establishing optimal growth conditions for the MOVPE method, enabling the growth of N‐polar GaN/Al0.9Ga0.1N/AlN heterostructures with a smooth surface morphology on a vicinal sapphire substrate. The formation of 2D electron gas (2DEG) in N‐polar GaN/AlGaN/AlN prepared using MOVPE is discussed. Additionally, in the study, the impact of growth conditions, such as temperature and V/III ratio, on the electrical properties of N‐polar GaN is investigated. In the results, it is revealed that growth at lower temperatures and a V/III ratio of 30 000 effectively suppresses 3D growth. Moreover, an increase in the V/III ratio correlates with a decrease in residual impurity concentrations (C and H); hence, electron mobility improves. Moreover, the N‐polar GaN/AlGaN/AlN field‐effect transistor, grown under optimized conditions, exhibits a higher maximum drain–source current (IDmax). In these results, possibilities are broadened for the high performance of N‐polar GaN channel high‐electron‐mobility transistors through MOVPE.
- 24 June 2024
- Published by Wiley in Physica Status Solidi (a)
- Vol. 221 (21)
Effect of the Twist Crystallinity of N‐Polar AlN Underlayer on the Electrical Properties of GaN/AlN Structures
Recently, N‐polar GaN/AlGaN/AlN high‐electron‐mobility transistors (HEMTs) have been demonstrated using molecular beam epitaxy (MBE). However, the MBE method is not suitable for mass production because of the need for ultrahigh vacuum, small chamber size, and long deposition time. This study fabricates N‐polar GaN‐ or AlGaN‐channel HEMTs on AlN with polarization directions opposite to those of Ga‐polar GaN‐based HEMTs without any cap layer and demonstrates field‐effect transistor static characteristics. In this article, the focus is on the crystal quality of the underlying layer and the effect of crystalline quality on electrical properties is investigated. The crystalline quality of the twist component of the N‐polar AlN layer is improved by combining the Al‐polar tiny‐pit layer and polarity inversion from Al‐ to N‐polar. Finally, it is shown that the crystalline quality of the twist component is a crucial factor for improving the electron mobility of the N‐polar GaN channel and simultaneously increasing IDS.
- 24 June 2024
- Published by Wiley in Physica Status Solidi (a)
- Vol. 221 (21)
Effect of the Twist Crystallinity of N‐Polar AlN Underlayer on the Electrical Properties of GaN/AlN Structures
Recently, N‐polar GaN/AlGaN/AlN high‐electron‐mobility transistors (HEMTs) have been demonstrated using molecular beam epitaxy (MBE). However, the MBE method is not suitable for mass production because of the need for ultrahigh vacuum, small chamber size, and long deposition time. This study fabricates N‐polar GaN‐ or AlGaN‐channel HEMTs on AlN with polarization directions opposite to those of Ga‐polar GaN‐based HEMTs without any cap layer and demonstrates field‐effect transistor static characteristics. In this article, the focus is on the crystal quality of the underlying layer and the effect of crystalline quality on electrical properties is investigated. The crystalline quality of the twist component of the N‐polar AlN layer is improved by combining the Al‐polar tiny‐pit layer and polarity inversion from Al‐ to N‐polar. Finally, it is shown that the crystalline quality of the twist component is a crucial factor for improving the electron mobility of the N‐polar GaN channel and simultaneously increasing IDS.
- 19 June 2024
- Published by Wiley in Physica Status Solidi (a)
- Vol. 221 (21)
Growth Mechanism of N‐Polar GaN on Vicinal N‐Polar AlN Templates in Metal‐Organic Vapor Phase Epitaxy
In this study, nitrogen‐polar (N‐polar) GaN/Al0.9Ga0.1N/aluminum nitride (AlN) structures are grown on a sapphire substrate with an offcut angle of 2.0° from the m axis using metal‐organic vapor phase epitaxy. Low‐growth temperatures of N‐polar GaN result in a shorter Ga‐migration length, and 2D GaN growth is successfully achieved. The growth temperature and V/III ratio dependence are investigated for N‐polar GaN. As a result, high‐quality and flat N‐polar GaN is successfully grown at a low temperature of 650 °C at a high V/III ratio and nonequilibrium conditions. Through X‐ray reciprocal space mapping, N‐polar GaN can be grown coherently on a N‐polar AlN template at low temperatures around 650 °C, relaxing at higher temperatures.
- 19 June 2024
- Published by Wiley in Physica Status Solidi (a)
- Vol. 221 (21)
Growth Mechanism of N‐Polar GaN on Vicinal N‐Polar AlN Templates in Metal‐Organic Vapor Phase Epitaxy
In this study, nitrogen‐polar (N‐polar) GaN/Al0.9Ga0.1N/aluminum nitride (AlN) structures are grown on a sapphire substrate with an offcut angle of 2.0° from the m axis using metal‐organic vapor phase epitaxy. Low‐growth temperatures of N‐polar GaN result in a shorter Ga‐migration length, and 2D GaN growth is successfully achieved. The growth temperature and V/III ratio dependence are investigated for N‐polar GaN. As a result, high‐quality and flat N‐polar GaN is successfully grown at a low temperature of 650 °C at a high V/III ratio and nonequilibrium conditions. Through X‐ray reciprocal space mapping, N‐polar GaN can be grown coherently on a N‐polar AlN template at low temperatures around 650 °C, relaxing at higher temperatures.