XPXuedong Pang

Xuedong Pang

*This is an algorithmically generated author record based on publicly available information.

Xuedong Pang has a total of 8 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Effects of Solid–Solution Temperature on Microstructures and Mechanical Properties of 2200 MPa Grade Secondary Hardening Steel

    by Cheng Yang, Yong Li, Shun Han, Xuedong Pang, Ruming Geng, Xinyang Li, Chunxu Wang

    With the increasing demands for mechanical properties of ultra–high–strength steels (UHSSs), enhancing their strength and obtaining an excellent strength–toughness matching have received widespread attention. In this paper, the influence of microstructure and primary carbides on the mechanical properties of 2200 MPa ultra–high–strength steel was studied by treating it at different solid–solution temperatures. The mechanical properties of the experimental steel following aging demonstrated a non–monotonic dependence on solid–solution temperature, manifested as an initial increase followed by a gradual decline in both strength and toughness. Microstructural evolution analysis reveals that elevated solid–solution temperatures induce coarsening of prior austenite and martensite grains in the steel, thereby promoting toughness enhancement. Concurrently, primary carbides progressively dissolve into the matrix with increasing solid–solution temperature, generating a supersaturated solid–solution that facilitates M2C carbide precipitation during aging, ultimately leading to strength improvement in the experimental steel. An exceptional combination of strength, ductility, and toughness with an ultimate tensile strength of 2142 MPa, yield strength of 1830 MPa, elongation of 12.5%, and Charpy U–notch impact energy of 60.5 J was obtained when the experimental steel was solid–solution treated at 910 °C.


  • Open Access

    Effects of Co on Mechanical Properties and Precipitates in a Novel Secondary−Hardening Steel with Duplex Strengthening of M2C and β−NiAl

    by Ruming Geng, Shun Han, Xuedong Pang, Xiaoyuan Yuan, Yue Liu, Yong Li, Chunxu Wang

    Synergistic strengthening of nano−scaled M2C and β−NiAl has become a new route to develop ultra−high secondary−hardening steel. At present, the effect of Co on the synergistic precipitation behavior of duplex phases of M2C and β−NiAl has been rarely reported. This paper revealed the effects of Co on the mechanical properties and duplex precipitates of M2C and β−NiAl in a novel 2.5 GPa ultra−high strength secondary−hardening steel. The tensile tests indicated that a 10% Co−alloy steel achieved a much stronger secondary−hardening effects compared to a Co−free steel during aging process, especially in the early−aging state. Needle−shaped M2C and spherical β−NiAl particles were observed in both Co−alloy and Co−free steels. However, the number density, and volume fraction of M2C were significantly enhanced in the 10% Co−alloy steel. The Mo contents in M2C carbide and α−Fe after aging treatment were both analyzed through experimental determination and thermodynamic calculation, and the results indicated that Co decreased the solubility of Mo in α−Fe, thus promoting the precipitation of Mo−rich carbides.