Raden Sumarbagiono
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Interests
Raden Sumarbagiono has a total of 91 co-authors. Here are the top co-authors by number of shared publications:
- Muhammad Yusuf
Interdisciplinary Research Center for Industrial Nuclear Energy (IRC-INE), King Fahd University of Petroleum and Minerals (KFUPM), Dhahran, Kingdom of Saudi Arabia
6 shared publications - Dadong Iskandar
Research Center for Nuclear Material and Radioactive Waste Technology (PRTBNLR), Research Organization for Nuclear Energy (ORTN), National Research and Innovation Agency (BRIN), South Tangerang, 15314, Indonesia
4 shared publications - Moch Romli
Directorate of Nuclear Facility Management (DPFK), Deputy for Research and Innovation Infrastructure, National Research and Innovation Agency (BRIN), South Tangerang, 15314, Indonesia; Department of Environmental Sciences, Faculty of Environmental Sciences, King Abdulaziz University, Jeddah, 21589, Kingdom of Saudi Arabia
4 shared publications Ajrieh Setyawan
3 shared publications- Djarot Sulistio Wisnubroto
Research Center for Radioactive Waste and Nuclear Fuel Cycle Technology, Research Organization for Nuclear Energy, National Research and Innovation Agency
3 shared publications - Hendra Adhi Pratama
Research Center for Nuclear Material and Radioactive Waste Technology, National Research and Innovation Agency, KST BJ Habibie, South Tangerang, 15314, Indonesia
3 shared publications
Latest Publications
- 29 July 2026
- Published by Elsevier in Chemosphere
- Vol. 410, 145046
Phytoremediation performance of various tropical plant species for environmental remediation of high 137Cs contaminated soils: A case study of Batan Indah soil
- 29 July 2026
- Published by Elsevier in Chemosphere
- Vol. 410, 145046
Phytoremediation performance of various tropical plant species for environmental remediation of high 137Cs contaminated soils: A case study of Batan Indah soil
- Open Access
- 22 August 2025
- Published by Elsevier in Nuclear Engineering and Technology
- Vol. 58 (1)
Phytoremediation of cesium-contaminated soils using Sorghum bicolor, Albizia falcataria, Amaranthus viridis, and Vetiveria zizanioides in tropical environments
- 22 August 2025
- Published by Elsevier in Nuclear Engineering and Technology
- Vol. 58 (1)
Open AccessPhytoremediation of cesium-contaminated soils using Sorghum bicolor, Albizia falcataria, Amaranthus viridis, and Vetiveria zizanioides in tropical environments
- Open Access
- 4 February 2025
- Published by Elsevier in Nuclear Engineering and Technology
- Vol. 57 (7)
Synthetic data for radioactive waste management: A comparative study for disused sealed radioactive sources in Indonesia
- 4 February 2025
- Published by Elsevier in Nuclear Engineering and Technology
- Vol. 57 (7)
Open AccessSynthetic data for radioactive waste management: A comparative study for disused sealed radioactive sources in Indonesia
- 16 July 2024
- Published by Elsevier in Nuclear Engineering and Design
- Vol. 427
Literature survey and analysis of phytoremediation strategies for Cs-137 decontamination
- 16 July 2024
- Published by Elsevier in Nuclear Engineering and Design
- Vol. 427
Literature survey and analysis of phytoremediation strategies for Cs-137 decontamination
- Open Access
- 6 February 2022
- Published by MDPI AG in Sustainability
- Vol. 14 (3) , 1859
Theoretical and Experimental Analysis on Influence of Natural Airflow on Spent Fuel Heat Removal in Dry Cask Storage
A key issue contributing to the success of NPP technology is the safe handling of radioactive waste, particularly spent nuclear fuel. According to the IAEA safety standard, the spent fuel must be stored in interim wet storage for several years so the radiation and the decay heat of the spent fuel will decrease to the safe limit values, after which the spent fuel can be moved to dry storage. In this study, we performed a theoretical analysis of heat removal by natural convection airflow in spent nuclear fuel dry storage. The temperature difference between the air inside and outside dry storage produces an air density difference. The air density difference causes a pressure difference, which then generates natural airflow. The result of the theoretical analysis was validated with simulation software and experimental investigation using a reduced-scale dry storage prototype. The dry storage prototype consisted of a dry cask body and two canisters stacked to store materials testing reactor (MTR) spent fuel, which generates decay heat. The cask body had four air inlet vents on the bottom and four air outlet vents at the top. To simulate the decay heat from the spent fuel in the two canisters, the canisters were wrapped with an electric wire heater that was connected to a voltage regulator to adjust the heat power. The theoretical analysis results of this study are relatively consistent with the experimental results, with the mean relative deviation (MRD) values for the prediction of air velocity, the heat rate using natural airflow, and the heat rate using the thermal resistance network equation are +0.76, −23.69, and −29.54%, respectively.
- 6 February 2022
- Published by MDPI AG in Sustainability
- Vol. 14 (3) , 1859
Open AccessTheoretical and Experimental Analysis on Influence of Natural Airflow on Spent Fuel Heat Removal in Dry Cask Storage
A key issue contributing to the success of NPP technology is the safe handling of radioactive waste, particularly spent nuclear fuel. According to the IAEA safety standard, the spent fuel must be stored in interim wet storage for several years so the radiation and the decay heat of the spent fuel will decrease to the safe limit values, after which the spent fuel can be moved to dry storage. In this study, we performed a theoretical analysis of heat removal by natural convection airflow in spent nuclear fuel dry storage. The temperature difference between the air inside and outside dry storage produces an air density difference. The air density difference causes a pressure difference, which then generates natural airflow. The result of the theoretical analysis was validated with simulation software and experimental investigation using a reduced-scale dry storage prototype. The dry storage prototype consisted of a dry cask body and two canisters stacked to store materials testing reactor (MTR) spent fuel, which generates decay heat. The cask body had four air inlet vents on the bottom and four air outlet vents at the top. To simulate the decay heat from the spent fuel in the two canisters, the canisters were wrapped with an electric wire heater that was connected to a voltage regulator to adjust the heat power. The theoretical analysis results of this study are relatively consistent with the experimental results, with the mean relative deviation (MRD) values for the prediction of air velocity, the heat rate using natural airflow, and the heat rate using the thermal resistance network equation are +0.76, −23.69, and −29.54%, respectively.