Lianjie Wang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Lianjie Wang has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
- Chushan Li
College of Electrical Engineering, Zhejiang University, Hangzhou, China
2 shared publications He Xu
College of Information Science and Electronic Engineering, Zhejiang University, Hangzhou, China
2 shared publications- Menglian Zhao
Institute of VLSI Design, Zhejiang University, Hangzhou, China
2 shared publications - Wuhua Li
Zhejiang University
2 shared publications Bo Qu
Zinsight-Tech, Shanghai, China
1 shared publicationChen Liang
Science and Technology on Reactor System Design Technology Laboratory, Nuclear Power Institute of China, Chengdu, China
1 shared publication
Latest Publications
- Open Access
- 24 September 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Vehicular Technology
- Vol. 74 (2) , 2620-2634
SiC MOSFETs: The Inevitable Trend for 800V Electric Vehicle Air Conditioning Compressors
Unlike traditional fuel vehicles, the air conditioning system of electric vehicles not only undertakes the thermal management of the cabin but also the thermal management of the battery system and even the thermal management of the electric motor control. The high demand for heating and cooling power leads to a significant reduction in cruising range. As the heart of the air conditioning system, E-compressors play the most critical role in the thermal management of electric vehicles. This paper shows that SiC MOSFETs are preferred for 800V electric vehicle E-compressors compared to Si IGBTs. A systematic comparison of SiC MOSFET and conventional IGBT solutions for E-compressor application in terms of system energy efficiency, compressor operation boundary, NVH performance, and system miniaturization trend is described in this paper. Besides, the cost reduction potential and gate oxide reliability issues of SiC MOSFET are also discussed.
- 24 September 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Vehicular Technology
- Vol. 74 (2) , 2620-2634
Open AccessSiC MOSFETs: The Inevitable Trend for 800V Electric Vehicle Air Conditioning Compressors
Unlike traditional fuel vehicles, the air conditioning system of electric vehicles not only undertakes the thermal management of the cabin but also the thermal management of the battery system and even the thermal management of the electric motor control. The high demand for heating and cooling power leads to a significant reduction in cruising range. As the heart of the air conditioning system, E-compressors play the most critical role in the thermal management of electric vehicles. This paper shows that SiC MOSFETs are preferred for 800V electric vehicle E-compressors compared to Si IGBTs. A systematic comparison of SiC MOSFET and conventional IGBT solutions for E-compressor application in terms of system energy efficiency, compressor operation boundary, NVH performance, and system miniaturization trend is described in this paper. Besides, the cost reduction potential and gate oxide reliability issues of SiC MOSFET are also discussed.
- 7 March 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Emerging and Selected Topics in Power Electronics
- Vol. 12 (3) , 2419-2430
A Dual-Current-Path State-Based Multistep Soft-Switching Modulation Scheme for Hybrid Device Multilevel Converters
In recent years, wide-band-gap (WBG) devices such as Silicon Carbide (SiC) MOSFET have shown a promising future for achieving high-power-density design in power electronic converters. However, its wide applications are still constrained by the high cost. The SiC & Si hybrid multilevel converter is a high-performance and cost-effective solution. However, these hybrid device converters have limited control degree of freedom for other control objectives such as DC bus capacitor voltage balancing. In this paper, a multi-step soft-switching modulation scheme is proposed for hybrid device multilevel converters. It utilizes dual-current-path (DCP) state and other intermediate states to create soft-switching conditions for all Si devices during the switching between multiple voltage levels. As a result, without adding huge additional switching losses, all switches in the hybrid device converters can operate in high frequency. The proposed modulation scheme is applied to a hybrid four-level converter and realizes the capacitor voltage balancing over the entire operation operating range but also guarantees the soft-switching of all Si devices. The modulation scheme and the control effects for four-level hybrid converters are verified by experiments.
- 7 March 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Emerging and Selected Topics in Power Electronics
- Vol. 12 (3) , 2419-2430
A Dual-Current-Path State-Based Multistep Soft-Switching Modulation Scheme for Hybrid Device Multilevel Converters
In recent years, wide-band-gap (WBG) devices such as Silicon Carbide (SiC) MOSFET have shown a promising future for achieving high-power-density design in power electronic converters. However, its wide applications are still constrained by the high cost. The SiC & Si hybrid multilevel converter is a high-performance and cost-effective solution. However, these hybrid device converters have limited control degree of freedom for other control objectives such as DC bus capacitor voltage balancing. In this paper, a multi-step soft-switching modulation scheme is proposed for hybrid device multilevel converters. It utilizes dual-current-path (DCP) state and other intermediate states to create soft-switching conditions for all Si devices during the switching between multiple voltage levels. As a result, without adding huge additional switching losses, all switches in the hybrid device converters can operate in high frequency. The proposed modulation scheme is applied to a hybrid four-level converter and realizes the capacitor voltage balancing over the entire operation operating range but also guarantees the soft-switching of all Si devices. The modulation scheme and the control effects for four-level hybrid converters are verified by experiments.
- Open Access
- 27 July 2023
- Published by Darcy & Roy Press Co. Ltd. in Highlights in Science, Engineering and Technology
- Vol. 62, 183-192
An Investigation into the Composition Analysis and Identification of Ancient Glass Artifacts
This study employs association analysis and chi-square tests to examine the relationship between weathering and glass type, color, and patterns in ancient glass artifacts. The findings reveal a stronger association between lead-barium glass and weathering, with weaker associations for color and patterns. Combining both methods demonstrates that glass type exhibits the strongest correlation with weathering, followed by color, while patterns remain unrelated. Utilizing kernel density plot analysis, the research investigates variations in chemical composition pre- and post-weathering, predicting component content before weathering. The classification of glass is based on intrinsic and extrinsic characteristics, highlighting notable differences in potassium oxide, lead oxide, and barium oxide between high-potassium and lead-barium glass. Scatter plots further illustrate these compositional disparities. Applying a decision tree, glass is classified according to patterns, color, and surface weathering, determining the influence of various factors. Hierarchical clustering is then used to categorize chemical compositions, identifying five categories for lead-barium glass and nine for high-potassium glass.
- 27 July 2023
- Published by Darcy & Roy Press Co. Ltd. in Highlights in Science, Engineering and Technology
- Vol. 62, 183-192
Open AccessAn Investigation into the Composition Analysis and Identification of Ancient Glass Artifacts
This study employs association analysis and chi-square tests to examine the relationship between weathering and glass type, color, and patterns in ancient glass artifacts. The findings reveal a stronger association between lead-barium glass and weathering, with weaker associations for color and patterns. Combining both methods demonstrates that glass type exhibits the strongest correlation with weathering, followed by color, while patterns remain unrelated. Utilizing kernel density plot analysis, the research investigates variations in chemical composition pre- and post-weathering, predicting component content before weathering. The classification of glass is based on intrinsic and extrinsic characteristics, highlighting notable differences in potassium oxide, lead oxide, and barium oxide between high-potassium and lead-barium glass. Scatter plots further illustrate these compositional disparities. Applying a decision tree, glass is classified according to patterns, color, and surface weathering, determining the influence of various factors. Hierarchical clustering is then used to categorize chemical compositions, identifying five categories for lead-barium glass and nine for high-potassium glass.
- Open Access
- 9 February 2022
- Published by Frontiers Media SA in Frontiers in Energy Research
- Vol. 9
Theoretically Modified Optical Length Research on the Physical Boundary of the Double-Heterogeneous System
Because of the double-heterogeneity (DH), dispersed particle-type systems cannot be described by traditional neutronic programs, and the volumetric homogenization method (VHM) will bring reactivity calculation deviation because of ignoring the spatial self-shielding effect of the particles. In this article, the relationship between the reactivity calculation deviation and the optical length of dispersed particle-type fuel and different types of burnable poisons is analyzed. Also then, it was proposed that the influencing factors of reactivity calculation deviation can be integrated to a physical quantity named theoretically modified optical length containing the influencing factors mentioned earlier. In addition, the DH physical boundary has forward that, when the theoretically modified optical length is larger than 10−4, reactivity calculation deviation of volumetric homogenization method will be larger than 100 pcm, and the DH of the dispersed particle-type systems should be considered.
- 9 February 2022
- Published by Frontiers Media SA in Frontiers in Energy Research
- Vol. 9
Open AccessTheoretically Modified Optical Length Research on the Physical Boundary of the Double-Heterogeneous System
Because of the double-heterogeneity (DH), dispersed particle-type systems cannot be described by traditional neutronic programs, and the volumetric homogenization method (VHM) will bring reactivity calculation deviation because of ignoring the spatial self-shielding effect of the particles. In this article, the relationship between the reactivity calculation deviation and the optical length of dispersed particle-type fuel and different types of burnable poisons is analyzed. Also then, it was proposed that the influencing factors of reactivity calculation deviation can be integrated to a physical quantity named theoretically modified optical length containing the influencing factors mentioned earlier. In addition, the DH physical boundary has forward that, when the theoretically modified optical length is larger than 10−4, reactivity calculation deviation of volumetric homogenization method will be larger than 100 pcm, and the DH of the dispersed particle-type systems should be considered.