Loïc Becerra
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Loïc Becerra has a total of 29 co-authors. Here are the top co-authors by number of shared publications:
- Doan Nguyen Ba
Sorbonne Universite
2 shared publications - Martino LoBue
Université Paris‐Saclay, ENS Paris‐Saclay, CNRS, SATIE Gif‐sur‐Yvette France
2 shared publications - Massimiliano Marangolo
Sorbonne Universite
2 shared publications - Morgan Almanza
Université Paris‐Saclay, ENS Paris‐Saclay, CNRS, SATIE Gif‐sur‐Yvette France
2 shared publications - Andreas Zerr
Laboratoire des Sciences des Procédés et des Matériaux, CNRS UPR 3407, Université Sorbonne Paris Nord 3 , 93430 Villetaneuse
1 shared publication - Anton Khanas
Lab of Functional Materials and Devices for Nanoelectronics, Moscow Institute of Physics and Technology (National Research University) , Institutsky Lane 9, Dolgoprudny, Moscow Region 141700
1 shared publication
Latest Publications
- Open Access
- 15 October 2026
- Published by Wiley in Advanced Functional Materials
- p. e78986
A Miniaturized Autonomous Thermomagnetic Generator
Thermomagnetic generators (TMG) are promising devices for converting low‐grade waste heat into electricity. Self‐actuation using permanent magnets is the key to autonomy. Tailoring thermomagnetic materials in the form of flexible and freestanding films is a way toward high power‐density through fast, and efficient heat transfer. Design optimization, and the use of micromagnets represent a unique opportunity toward miniaturization. Here, the operation and performance of a TMG using a flexible freestanding Gd film as the active substance, and an array of NdFeB micromagnets as field source is presented. The Gd film self oscillates under the effect of the magnetic field gradient, entering in contact with the heat source, and the heat sink alternatively. At an operating frequency of Hz, a designed piezoelectric spring converts the mechanical oscillation into electrical energy, reaching up to power‐output with temperature difference. The magnetic field gradient acting over the thermal switch, and triggering the caloric response of this thick Gd film, is generated by an array of thick NdFeB micromagnets, which produces a T variation in field strength over a gap. The power density normalized to the combined volume of the Gd film and of the magnet reaches up to .
- 15 October 2026
- Published by Wiley in Advanced Functional Materials
- p. e78986
Open AccessA Miniaturized Autonomous Thermomagnetic Generator
Thermomagnetic generators (TMG) are promising devices for converting low‐grade waste heat into electricity. Self‐actuation using permanent magnets is the key to autonomy. Tailoring thermomagnetic materials in the form of flexible and freestanding films is a way toward high power‐density through fast, and efficient heat transfer. Design optimization, and the use of micromagnets represent a unique opportunity toward miniaturization. Here, the operation and performance of a TMG using a flexible freestanding Gd film as the active substance, and an array of NdFeB micromagnets as field source is presented. The Gd film self oscillates under the effect of the magnetic field gradient, entering in contact with the heat source, and the heat sink alternatively. At an operating frequency of Hz, a designed piezoelectric spring converts the mechanical oscillation into electrical energy, reaching up to power‐output with temperature difference. The magnetic field gradient acting over the thermal switch, and triggering the caloric response of this thick Gd film, is generated by an array of thick NdFeB micromagnets, which produces a T variation in field strength over a gap. The power density normalized to the combined volume of the Gd film and of the magnet reaches up to .
- 14 October 2024
- Published by AIP Publishing in Applied Physics Letters
- Vol. 125 (16)
Single-crystal elastic moduli, anisotropy, and the B1–B2 phase transition of NaCl at high pressures
Pressure dependences of the highest and lowest possible longitudinal sound velocities in single crystals of the B1 and B2 phases of NaCl were extracted from examination of their polycrystalline samples using the technique of time-domain Brillouin scattering. Based on the data collected up to 41 GPa, we largely extended the pressure range where single-crystal elastic moduli, Cij(P), and elastic anisotropy of the two cubic phases are measured, especially the experimental data for the B2 phase formed upon the reconstructive phase transition. The B1 phase of NaCl exhibits strong and growing anisotropy with increasing pressure, while that of the B2 phase is much weaker. Comparing with the previous experimental Cij(P) of other compounds exhibiting or expected to exhibit the B1–B2 phase transition, such as CaO, MgO, and (Mg1−x, Fex)O, we concluded that the transition is initiated by the shear instability due to violation of the Born stability criterion [C44(P)–P] > 0 and predicted the presently-not-verified transition pressures for MgO and (Mg1−x, Fex)O.
- 14 October 2024
- Published by AIP Publishing in Applied Physics Letters
- Vol. 125 (16)
Single-crystal elastic moduli, anisotropy, and the B1–B2 phase transition of NaCl at high pressures
Pressure dependences of the highest and lowest possible longitudinal sound velocities in single crystals of the B1 and B2 phases of NaCl were extracted from examination of their polycrystalline samples using the technique of time-domain Brillouin scattering. Based on the data collected up to 41 GPa, we largely extended the pressure range where single-crystal elastic moduli, Cij(P), and elastic anisotropy of the two cubic phases are measured, especially the experimental data for the B2 phase formed upon the reconstructive phase transition. The B1 phase of NaCl exhibits strong and growing anisotropy with increasing pressure, while that of the B2 phase is much weaker. Comparing with the previous experimental Cij(P) of other compounds exhibiting or expected to exhibit the B1–B2 phase transition, such as CaO, MgO, and (Mg1−x, Fex)O, we concluded that the transition is initiated by the shear instability due to violation of the Born stability criterion [C44(P)–P] > 0 and predicted the presently-not-verified transition pressures for MgO and (Mg1−x, Fex)O.
- 22 July 2024
- Published by AIP Publishing in Applied Physics Letters
- Vol. 125 (4)
Multilevel magnetoresistance states in La0.7Sr0.3MnO3/BaTiO3/La0.7Sr0.3MnO3 heterostructure grown on MgO
Magnetic tunnel junction (MTJ) is one of the cornerstones of modern information technologies. Bringing MTJ's operation beyond the conventional binary regime, enabled by tunneling magnetoresistance (TMR) effect, is highly promising for prospective memory technologies and neuromorphic hardware development. In this paper, we demonstrate multilevel magnetoresistance states in an all-perovskite-oxide La0.7Sr0.3MnO3 (LSMO)/BaTiO3/LSMO heterostructure grown on MgO substrates. Unlike traditional TMR, we observe four distinct regions of increased magnetoresistance, which result in three magnetic field-induced resistance states in total. We show that the observed phenomenon arises from the low-field magnetoresistance effect, which occurs in the two epitaxial LSMO layers, independently and at different values of the magnetic field. The effect is well simulated by a model based on the presence of structural defects and non-uniform deformations in the LSMO layers, induced by the large lattice mismatch of the LSMO with the MgO substrate. We believe that our findings contribute to the understanding of complex magnetoresistance effects in MTJs and can be taken into consideration for the design of multi-bit memory cells or neuromorphic devices.
- 22 July 2024
- Published by AIP Publishing in Applied Physics Letters
- Vol. 125 (4)
Multilevel magnetoresistance states in La0.7Sr0.3MnO3/BaTiO3/La0.7Sr0.3MnO3 heterostructure grown on MgO
Magnetic tunnel junction (MTJ) is one of the cornerstones of modern information technologies. Bringing MTJ's operation beyond the conventional binary regime, enabled by tunneling magnetoresistance (TMR) effect, is highly promising for prospective memory technologies and neuromorphic hardware development. In this paper, we demonstrate multilevel magnetoresistance states in an all-perovskite-oxide La0.7Sr0.3MnO3 (LSMO)/BaTiO3/LSMO heterostructure grown on MgO substrates. Unlike traditional TMR, we observe four distinct regions of increased magnetoresistance, which result in three magnetic field-induced resistance states in total. We show that the observed phenomenon arises from the low-field magnetoresistance effect, which occurs in the two epitaxial LSMO layers, independently and at different values of the magnetic field. The effect is well simulated by a model based on the presence of structural defects and non-uniform deformations in the LSMO layers, induced by the large lattice mismatch of the LSMO with the MgO substrate. We believe that our findings contribute to the understanding of complex magnetoresistance effects in MTJs and can be taken into consideration for the design of multi-bit memory cells or neuromorphic devices.
- Open Access
- 17 June 2021
- Published by American Physical Society (APS) in Physical Review Applied
- Vol. 15 (6) , 064045
Magnetocaloric Effect in Flexible, Free-Standing Gadolinium Thick Films for Energy Conversion Applications
This study presents a method of producing thick (i.e., in the range) polycrystalline free-standing flexible films. Preparation is carried out by sputtering on silicon conventional substrates using tantalum as a buffer and capping layer. Magnetic and magnetocaloric properties show good agreement with data from high-purity bulk , and are not altered by substrate removal. Moreover, the free-standing film is flexible and all the relevant magnetic properties (i.e., Curie temperature , saturation magnetization , and isothermal entropy change ) are preserved under bending (up to a strain over the two film sides). The technological opportunities heralded by availability of magnetocaloric flexible self-sustaining films are discussed in the conclusions with particular focus on energy-conversion applications (i.e., cooling and thermal energy harvesting). More precisely, the output-power upper bound of an thermal-energy harvester deploying a flexible film with the reported properties is worked-out using a thermal switch model presented elsewhere. The calculations show a potential output able to supply the new generation of IoT wireless devices as well as small medical implants. The result moot free-standing flexible films as a benchmark for a new generation of small high-throughput magnetocaloric energy-conversion devices.- 17 June 2021
- Published by American Physical Society (APS) in Physical Review Applied
- Vol. 15 (6) , 064045
Open AccessMagnetocaloric Effect in Flexible, Free-Standing Gadolinium Thick Films for Energy Conversion Applications
This study presents a method of producing thick (i.e., in the range) polycrystalline free-standing flexible films. Preparation is carried out by sputtering on silicon conventional substrates using tantalum as a buffer and capping layer. Magnetic and magnetocaloric properties show good agreement with data from high-purity bulk , and are not altered by substrate removal. Moreover, the free-standing film is flexible and all the relevant magnetic properties (i.e., Curie temperature , saturation magnetization , and isothermal entropy change ) are preserved under bending (up to a strain over the two film sides). The technological opportunities heralded by availability of magnetocaloric flexible self-sustaining films are discussed in the conclusions with particular focus on energy-conversion applications (i.e., cooling and thermal energy harvesting). More precisely, the output-power upper bound of an thermal-energy harvester deploying a flexible film with the reported properties is worked-out using a thermal switch model presented elsewhere. The calculations show a potential output able to supply the new generation of IoT wireless devices as well as small medical implants. The result moot free-standing flexible films as a benchmark for a new generation of small high-throughput magnetocaloric energy-conversion devices. - 1 July 2009
- Published by Elsevier in Microelectronic Engineering
- Vol. 86 (7-9) , 1700-1702
Growth temperature dependence of epitaxial Gd2O3 films on Si(111)
- 1 July 2009
- Published by Elsevier in Microelectronic Engineering
- Vol. 86 (7-9) , 1700-1702
Growth temperature dependence of epitaxial Gd2O3 films on Si(111)