Rui Zeng
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Rui Zeng has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Jianwen Bao
AVIC Manufacturing Technology Institute Composite Technology Center, Beijing 101300, China
1 shared publication - Pengfei Shen
National Key Laboratory of Advanced Composites, AVIC Composite Technology Center, AVIC Composite Corporation Ltd., Beijing 101300, China
1 shared publication - Qian Zhang
School of Mechanical Engineering, Hefei University of Technology, Hefei 230009, China
1 shared publication - Shicai Jiang
National Key Laboratory of Advanced Composites, AVIC Composite Technology Center, AVIC Composite Corporation Ltd., Beijing 101300, China
1 shared publication - Weidong Li
National Key Laboratory of Advanced Composites, AVIC Composite Technology Center, AVIC Composite Corporation Ltd., Beijing 101300, China
1 shared publication - Xiangyu Zhong
AVIC Manufacturing Technology Institute Composite Technology Center, Beijing 101300, China
1 shared publication
Latest Publications
- Open Access
A Study of the Effects of Moisture on Composite−to−Metal Double−Lap Shear Joints
This work investigated the effects of moisture absorption treatment on composite−to−metal double−lap shear joints (DLSJs) bonded with epoxy adhesive film through experiments and simulations. The composite−to−metal DLSJ can be divided into five parts (the interface between the composite and adhesive, the interface between the adhesive and metal, the composite adherend, the metal adherend, and the adhesive layer). First, the wet−dependent properties of the adhesive and interfaces were obtained through adhesive tensile tests and GC tests, which showed that the properties of the adhesive and interfaces were significantly affected by the moist environment. Then, tensile tests of the composite−to−metal double−lap shear joints were carried out in dry and wet environments. Finally, based on the experimental investigations, a finite element (FE) model that considered cohesive damage was established for simulating damage evolution and predicting the failure loads and failure modes of the DLSJs. The results of both the experimental and numerical tests show that the DLSJ failure load decreases significantly after immersion in 95 °C water, and the major failure mode transfers from adhesive failure to interface failure. The research results provide a theoretical basis or basic data for the structural design of adhesively bonded composite−to−metal.
Open AccessA Study of the Effects of Moisture on Composite−to−Metal Double−Lap Shear Joints
This work investigated the effects of moisture absorption treatment on composite−to−metal double−lap shear joints (DLSJs) bonded with epoxy adhesive film through experiments and simulations. The composite−to−metal DLSJ can be divided into five parts (the interface between the composite and adhesive, the interface between the adhesive and metal, the composite adherend, the metal adherend, and the adhesive layer). First, the wet−dependent properties of the adhesive and interfaces were obtained through adhesive tensile tests and GC tests, which showed that the properties of the adhesive and interfaces were significantly affected by the moist environment. Then, tensile tests of the composite−to−metal double−lap shear joints were carried out in dry and wet environments. Finally, based on the experimental investigations, a finite element (FE) model that considered cohesive damage was established for simulating damage evolution and predicting the failure loads and failure modes of the DLSJs. The results of both the experimental and numerical tests show that the DLSJ failure load decreases significantly after immersion in 95 °C water, and the major failure mode transfers from adhesive failure to interface failure. The research results provide a theoretical basis or basic data for the structural design of adhesively bonded composite−to−metal.