Chiemeka Loveth Maxwell
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Chiemeka Loveth Maxwell has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
- Dongsheng Yu
School of Electrical Engineering, China University of Mining and Technology, Xuzhou, China
3 shared publications - Samson Shenglong Yu
Deakin University
3 shared publications - Daniel Gordan
Technical University of Košice
2 shared publications - Marek Pastor
Technical University of Košice
2 shared publications - Mu Yang
School of Electrical Engineering, China University of Mining and Technology, Xuzhou 221116, China
2 shared publications - Xiaojie Wu
School of Electrical Engineering, China University of Mining and Technology, Xuzhou 221116, China
2 shared publications
Latest Publications
- 25 November 2025
- Published by Elsevier in Computers and Electrical Engineering
- Vol. 130
A lightweight hyperchaotic memristor-based encryption for secure power and data synchronous transmission in DC microgrids
- 25 November 2025
- Published by Elsevier in Computers and Electrical Engineering
- Vol. 130
A lightweight hyperchaotic memristor-based encryption for secure power and data synchronous transmission in DC microgrids
- 31 October 2025
- Published by World Scientific Pub Co Pte Ltd in International Journal of Bifurcation and Chaos
- Vol. 36 (02)
A Memristor-Based Encryption for Power and Data Synchronous Transmission
Power and Data Synchronous Transmission (PDST) is a form of power line communication that leverages power modulation via switched-mode power supplies, enabling efficient monitoring and control while reducing system constructional and operational costs. Ensuring secure and robust communication is critical for PDST systems in DC microgrids. This paper proposes a Reference-Modulated Differential Chaos Shift Keying (RM-DCSK) transceiver that employs a 2D discrete memristor-coupled Chebyshev map for both spreading and encryption. The chaotic nature of the map ensures high entropy in the transmitted signal. To ensure confidentiality, a stream cipher is used where the encryption keys are random numbers generated by a Pseudorandom Number Generator (PRNG) based on the proposed map. The cipher uses bitwise XOR operations to encrypt the data prior to modulation. Security is further reinforced by initializing the memristor state using an SHA-512 hash, a design aimed at resisting both eavesdropping and differential attacks. Bit Error Rate (BER) analysis shows optimal and comparable performance to conventional chaotic maps, while maintaining increased complexity for enhanced security. Simulation and Hardware-in-the-Loop (HIL) experimental results validate the effectiveness of the proposed method for secure and reliable PDST communication.
- 31 October 2025
- Published by World Scientific Pub Co Pte Ltd in International Journal of Bifurcation and Chaos
- Vol. 36 (02)
A Memristor-Based Encryption for Power and Data Synchronous Transmission
Power and Data Synchronous Transmission (PDST) is a form of power line communication that leverages power modulation via switched-mode power supplies, enabling efficient monitoring and control while reducing system constructional and operational costs. Ensuring secure and robust communication is critical for PDST systems in DC microgrids. This paper proposes a Reference-Modulated Differential Chaos Shift Keying (RM-DCSK) transceiver that employs a 2D discrete memristor-coupled Chebyshev map for both spreading and encryption. The chaotic nature of the map ensures high entropy in the transmitted signal. To ensure confidentiality, a stream cipher is used where the encryption keys are random numbers generated by a Pseudorandom Number Generator (PRNG) based on the proposed map. The cipher uses bitwise XOR operations to encrypt the data prior to modulation. Security is further reinforced by initializing the memristor state using an SHA-512 hash, a design aimed at resisting both eavesdropping and differential attacks. Bit Error Rate (BER) analysis shows optimal and comparable performance to conventional chaotic maps, while maintaining increased complexity for enhanced security. Simulation and Hardware-in-the-Loop (HIL) experimental results validate the effectiveness of the proposed method for secure and reliable PDST communication.
- Open Access
- 12 June 2025
- Published by Springer Nature in Electrical Engineering
- Vol. 107 (9) , 11831-11845
From IGBT to GaN implementation in phase-shifted full-bridge converter
The phase-shifted full-bridge (PSFB) converter is a preferred topology for isolated DC-DC converters with medium to high power levels. It can be utilized in a variety of applications, preferably with a wide input and/or output range. The efficiency of the converter, as well as its power density, is important factors for modern applications in the automotive industry or renewable energy sources. New semiconductor components based on gallium-nitride (GaN), silicon-carbide, or older silicon MOSFETs, specially designed for resonant converters, together with suitable converter modifications, enable an increase in efficiency and switching frequency. Various auxiliary networks and snubbers extended the limited zero-voltage switching (ZVS) in the lagging leg of the converter. GaN FET enables the utilization of small output capacitances in the PSFB converter to achieve ZVS at low loads even without auxiliary circuits. The small R DS(on) enables the decrease of the conduction losses caused by the circulating current. The FB converter with a controlled rectifier and secondary side energy recovery snubber and the PSFB converter with a synchronous rectifier are compared by simulation for different operational conditions. Finally, a measurement is performed on a PSFB converter with a synchronous rectifier at reduced output power, using a different output rectifier as mentioned in the theoretical part. The experimental part highlights the partial or full achievement of ZVS at different load currents.
- 12 June 2025
- Published by Springer Nature in Electrical Engineering
- Vol. 107 (9) , 11831-11845
Open AccessFrom IGBT to GaN implementation in phase-shifted full-bridge converter
The phase-shifted full-bridge (PSFB) converter is a preferred topology for isolated DC-DC converters with medium to high power levels. It can be utilized in a variety of applications, preferably with a wide input and/or output range. The efficiency of the converter, as well as its power density, is important factors for modern applications in the automotive industry or renewable energy sources. New semiconductor components based on gallium-nitride (GaN), silicon-carbide, or older silicon MOSFETs, specially designed for resonant converters, together with suitable converter modifications, enable an increase in efficiency and switching frequency. Various auxiliary networks and snubbers extended the limited zero-voltage switching (ZVS) in the lagging leg of the converter. GaN FET enables the utilization of small output capacitances in the PSFB converter to achieve ZVS at low loads even without auxiliary circuits. The small R DS(on) enables the decrease of the conduction losses caused by the circulating current. The FB converter with a controlled rectifier and secondary side energy recovery snubber and the PSFB converter with a synchronous rectifier are compared by simulation for different operational conditions. Finally, a measurement is performed on a PSFB converter with a synchronous rectifier at reduced output power, using a different output rectifier as mentioned in the theoretical part. The experimental part highlights the partial or full achievement of ZVS at different load currents.
- Open Access
- 26 November 2024
- Published by Institution of Engineering and Technology (IET) in IET Power Electronics
- Vol. 17 (16) , 3093-3108
A memristor‐sourced key for encrypted power and data synchronous transmission in switched mode power supplies
In power and data synchronous transmission (PDST), it is crucial to modulate additional signals onto the voltage bus of the converters. This reduces the cost of monitoring and control of the power grid. There is thus the need to ensure that the data transmitted is well secured. This study, designs an electronic system that uses the common coupling point for PDST. Then Chua's memristive circuit is introduced as an entropy source for generating a random bit sequence for encrypted PDST in a switched mode power supply. The encrypted data signal is modulated using phase shift key modulation. Thereafter, the carrier signal is pulse width modulation modulated to control the switching operation of the power switch. The use of Chua's memristive circuit for generating a random number is not new; however, there is little study directly adopting its use in PDST. This allows for resource sharing since multiple signal sources can share the same bus without interference or security risk. The generated random bits are tested for randomness using National Institute of Standards and Technology test suite and autocorrelation test. MATLAB/Simulink and experimental results both confirm the effectiveness of the proposed data encryption method.
- 26 November 2024
- Published by Institution of Engineering and Technology (IET) in IET Power Electronics
- Vol. 17 (16) , 3093-3108
Open AccessA memristor‐sourced key for encrypted power and data synchronous transmission in switched mode power supplies
In power and data synchronous transmission (PDST), it is crucial to modulate additional signals onto the voltage bus of the converters. This reduces the cost of monitoring and control of the power grid. There is thus the need to ensure that the data transmitted is well secured. This study, designs an electronic system that uses the common coupling point for PDST. Then Chua's memristive circuit is introduced as an entropy source for generating a random bit sequence for encrypted PDST in a switched mode power supply. The encrypted data signal is modulated using phase shift key modulation. Thereafter, the carrier signal is pulse width modulation modulated to control the switching operation of the power switch. The use of Chua's memristive circuit for generating a random number is not new; however, there is little study directly adopting its use in PDST. This allows for resource sharing since multiple signal sources can share the same bus without interference or security risk. The generated random bits are tested for randomness using National Institute of Standards and Technology test suite and autocorrelation test. MATLAB/Simulink and experimental results both confirm the effectiveness of the proposed data encryption method.
- Open Access
An Optimized Power-Angle and Excitation Dual Loop Virtual Power System Stabilizer for Enhanced MMC-VSG Control and Low-Frequency Oscillation Suppression
Modular Multilevel Converter Virtual Synchronous Generator (MMC-VSG) technology is gaining widespread attention for its ability to enhance the inertia and frequency stability of the power grid integrated with converter-interfaced renewable energy sources. However, the excitation voltage regulation in the MMC-VSG can generate equivalent negative damping torque and cause low-frequency oscillation problems similar to those in synchronous machines. This article aims to improve the system’s damping torque and minimize low-frequency oscillations by introducing a Virtual Power System Stabilizer (VPSS) into the power control loop. Building on the study of dynamic interactions between various control links of the MMC, this research establishes a reduced-order model (ROM) and a Phillips–Heffron state equation for the MMC-VSG single machine infinite bus system, using a hybrid modeling approach and a zero-pole truncation method. It also analyzes the mechanism of low-frequency oscillations in the MMC-VSG system through the damping torque method. The analysis reveals that the negative damping torque produced during the excitation voltage regulation process causes changes in the virtual power angle, which in turn increases the risk of low-frequency oscillation in the MMC-VSG. To address this issue, the article proposes an optimized control method for the MMC-VSG dual power loop architecture (power-angle/excitation) VPSS. This strategy compensates for the inadequate damping torque of a single loop VPSS and effectively suppresses low-frequency oscillations in the system.
Open AccessAn Optimized Power-Angle and Excitation Dual Loop Virtual Power System Stabilizer for Enhanced MMC-VSG Control and Low-Frequency Oscillation Suppression
Modular Multilevel Converter Virtual Synchronous Generator (MMC-VSG) technology is gaining widespread attention for its ability to enhance the inertia and frequency stability of the power grid integrated with converter-interfaced renewable energy sources. However, the excitation voltage regulation in the MMC-VSG can generate equivalent negative damping torque and cause low-frequency oscillation problems similar to those in synchronous machines. This article aims to improve the system’s damping torque and minimize low-frequency oscillations by introducing a Virtual Power System Stabilizer (VPSS) into the power control loop. Building on the study of dynamic interactions between various control links of the MMC, this research establishes a reduced-order model (ROM) and a Phillips–Heffron state equation for the MMC-VSG single machine infinite bus system, using a hybrid modeling approach and a zero-pole truncation method. It also analyzes the mechanism of low-frequency oscillations in the MMC-VSG system through the damping torque method. The analysis reveals that the negative damping torque produced during the excitation voltage regulation process causes changes in the virtual power angle, which in turn increases the risk of low-frequency oscillation in the MMC-VSG. To address this issue, the article proposes an optimized control method for the MMC-VSG dual power loop architecture (power-angle/excitation) VPSS. This strategy compensates for the inadequate damping torque of a single loop VPSS and effectively suppresses low-frequency oscillations in the system.
- Open Access
- 7 August 2024
- Published by Taylor & Francis in Automatika
- Vol. 65 (4) , 1391-1401
Inverter optimization of soft-switching DC-DC converter*
- 7 August 2024
- Published by Taylor & Francis in Automatika
- Vol. 65 (4) , 1391-1401
Open AccessInverter optimization of soft-switching DC-DC converter*
- Open Access
- 10 May 2023
- Published by MDPI AG in Applied Sciences
- Vol. 13 (10) , 5879
A Deep Reinforcement Learning Design for Virtual Synchronous Generators Accommodating Modular Multilevel Converters
The deep reinforcement learning (DRL) technique has gained attention for its potential in designing “virtual network” controllers. This skill utilizes a novel solution that can avoid the specific parameters and system model required in classical dynamic programming algorithms. However, addressing the issue of system uncertainties and performance deterioration remains a challenge. To overcome this challenge, the authors propose a new control prototype using a twin delayed deep deterministic policy gradient (TD3)-based adaptive controller, which replaces the conventional virtual synchronous generator (VSG) module in the modular multilevel converter (MMC) control. In this approach, an adaptive programming module is developed using a critic fuzzy network point of view to determine the optimal control policy. The modification presented in this framework is able to improve the system stability and resist disruptions while retaining the merits of the conventional VSG control model. The proposed approach is implemented and tested using the DRL toolbox in MATLAB/Simulink.
- 10 May 2023
- Published by MDPI AG in Applied Sciences
- Vol. 13 (10) , 5879
Open AccessA Deep Reinforcement Learning Design for Virtual Synchronous Generators Accommodating Modular Multilevel Converters
The deep reinforcement learning (DRL) technique has gained attention for its potential in designing “virtual network” controllers. This skill utilizes a novel solution that can avoid the specific parameters and system model required in classical dynamic programming algorithms. However, addressing the issue of system uncertainties and performance deterioration remains a challenge. To overcome this challenge, the authors propose a new control prototype using a twin delayed deep deterministic policy gradient (TD3)-based adaptive controller, which replaces the conventional virtual synchronous generator (VSG) module in the modular multilevel converter (MMC) control. In this approach, an adaptive programming module is developed using a critic fuzzy network point of view to determine the optimal control policy. The modification presented in this framework is able to improve the system stability and resist disruptions while retaining the merits of the conventional VSG control model. The proposed approach is implemented and tested using the DRL toolbox in MATLAB/Simulink.